Cost effective hydrogen evolution reaction (HER) catalyst without using precious metallic elements is a crucial demand for environment-benign energy production. Molybdenum sulfide is one of the promising candidates for such purpose, particularly in acidic condition, but its catalytic performance is inherently limited by the sparse catalytic edge sites and poor electrical conductivity. We report synthesis and HER catalysis of hybrid catalysts composed of amorphous molybdenum sulfide (MoSx) layer directly bound at vertical N-doped carbon nanotube (NCNT) forest surface. Owing to the high wettability of N-doped graphitic surface and electrostatic attraction between thiomolybdate precursor anion and N-doped sites, ∼2 nm scale thick amorphous MoSx layers are specifically deposited at NCNT surface under low-temperature wet chemical process. The synergistic effect from the dense catalytic sites at amorphous MoSx surface and fluent charge transport along NCNT forest attains the excellent HER catalysis with onset overpotential as low as ∼75 mV and small potential of 110 mV for 10 mA/cm(2) current density, which is the highest HER activity of molybdenum sulfide-based catalyst ever reported thus far.

Graphene is a promising candidate to complement brittle and expensive transparent conducting oxides. Nevertheless, previous research efforts have paid little attention to reduced graphene, which can be of great benefit due to low-cost solution processing without substrate transfer. Here we demonstrate workfunction-tunable, highly conductive, N-doped reduced graphene film, which is obtainable from the spin-casting of graphene oxide dispersion and can be successfully employed as a transparent cathode for high-performance polymer light-emitting diodes (PLEDs) as an alternative to fluorine-doped tin oxide (FTO). The sheet resistance of N-doped reduced graphene attained 300 Ω/□ at 80% transmittance, one of the lowest values ever reported from the reduction of graphene oxide films. The optimal doping of quaternary nitrogen and the effective removal of oxygen functionalities via sequential hydrazine treatment and thermal reduction accomplished the low resistance. The PLEDs employing N-doped reduced graphene cathodes exhibited a maximum electroluminescence efficiency higher than those of FTO-based devices (4.0 cd/A for FTO and 7.0 cd/A for N-doped graphene at 17,000 cd/m(2)). The reduced barrier for electron injection from a workfunction-tunable, N-doped reduced graphene cathode offered this remarkable device performance.

SummaryHsp31 encoded by hchA is known as a heat-inducible molecular chaperone. Although structure studies revealed that Hsp31 has a putative catalytic triad consisting of Asp-214, His-186 and Cys-185, its enzymatic function, besides weak amino-peptidase activity, is still unknown. We found that Hsp31 displays glyoxalase activity that catalyses the conversion of methylglyoxal (MG) to D-lactate without an additional cofactor. The glyoxalase activity was completely abolished in the hchA-deficient strain, confirming the relationship between the hchA gene and its enzymatic activity in vivo. Hsp31 exhibits Michaelis-Menten kinetics for substrates MG with Km and kcat of 1.43 Ϯ 0.12 mM and 156.9 Ϯ 5.5 min -1 respectively. The highest glyoxalase activity was found at 35-40°C and pH of 6.0-8.0, and the activity was significantly inhibited by Cu 2+ , Fe 3+ and Zn 2+ . Mutagenesis studies based on our evaluation of conserved catalytic residues revealed that the Cys-185 and Glu-77 were essential for catalysis, whereas His-186 was less crucial for enzymatic function, although it participates in the catalytic process. The stationary-phase Escherichia coli cells became more susceptible to MG when hchA was deleted, which was complemented by an expression of plasmid-encoded hchA. Furthermore, an accumulation of intracellular MG was observed in hchA-deficient strains.

Novel Pt-Co alloyed nanocatalysts are generated via chemical vapor deposition-assisted facile one-pot synthesis. The method guarantees highly monodisperse Pt-Co alloy nanoparticles with precise control of metallic compositions within 1 at%. A significant features is that a perfectly alloyed single-crystal structure is obtained at temperatures as low as 500 °C, which is much lower than conventional alloying temperatures.

We examined six Arabidopsis thaliana genes from the DJ-1/PfpI superfamily for similarity to the recently characterized bacterial and animal glyoxalases. Based on their sequence similarities, the six genes were classified into two sub-groups consisting of homologs of the human DJ-1 gene and the PH1704 gene of Pyrococcus horikoshii. Unlike the homologs from other species, all the A. thaliana genes have two tandem domains, which may have been created by gene duplication. The six AtDJ-1 proteins (a-f) were expressed in Escherichia coli for enzymatic assays with glyoxals. The DJ-1d protein, which belongs to the PH1704 sub-group, exhibits the highest activity against methylglyoxal and glyoxal, and K m values of 0.10 and 0.27 mM were measured for these two substrates, respectively, while the corresponding k cat values were 1700 and 2200 min À1 , respectively. The DJ-1a and DJ-1b glyoxalases exhibited higher specificity towards glyoxal. The other three proteins have either no or extremely low activity for glyoxals. For the DJ-1d enzyme, the residues, Cys120/313 and Glu19/212 at the active site and His121/314 and Glu94/287 at the oligomeric interface were mutated to alanines. As in other enzymes characterized to date, mutation of either the Cys or the Glu residues of the active site completely abolished enzyme activity, whereas mutation of the interface residues produced a variable decrease in activity. DJ-1d differs from its animal and bacterial homologs with respect to the configuration of its catalytic residues and the oligomeric property of the enzyme. When the wild-type DJ-1d enzyme was expressed in E. coli, the bacteria became resistant to glyoxals.

DJ‐1 family proteins have recently been characterized as novel glyoxalases, although their cofactor‐free catalytic mechanisms are not fully understood. Here, we obtained crystals of Arabidopsis thaliana DJ‐1d (atDJ‐1d) and Homo sapiens DJ‐1 (hDJ‐1) covalently bound to glyoxylate, an analog of methylglyoxal, forming a hemithioacetal that presumably mimics an intermediate structure in catalysis of methylglyoxal to lactate. The deuteration level of lactate supported the proton transfer mechanism in the enzyme reaction. Differences in the enantiomeric specificity of d/l‐lactacte formation observed for the DJ‐1 superfamily proteins are explained by the presence of a His residue in the active site with essential Cys and Glu residues. The model for the stereospecificity was further evaluated by a molecular modeling simulation with methylglyoxal hemithioacetal superimposed on the glyoxylate hemithioacetal. The mechanism of DJ‐1 glyoxalase provides a basis for understanding the His residue‐based stereospecificity. Database Structural data have been submitted to the Protein Data Bank under accession numbers http://www.rcsb.org/pdb/search/structidSearch.do?structureId=4OFW (structure of atDJ‐1d), http://www.rcsb.org/pdb/search/structidSearch.do?structureId=4OGF (structure of hDJ‐1 with glyoxylate) and http://www.rcsb.org/pdb/search/structidSearch.do?structureId=4OGG (structure of atDJ‐1d with glyoxylate).

Atomic level engineering of graphene-based materials is in high demand to enable customize structures and properties for different applications. Unzipping of the graphene plane is a potential means to this end, but uncontrollable damage of the two-dimensional crystalline framework during harsh unzipping reaction has remained a key challenge. Here we present heteroatom dopant-specific unzipping of carbon nanotubes as a reliable and controllable route to customized intact crystalline graphene-based nanostructures. Substitutional pyridinic nitrogen dopant sites at carbon nanotubes can selectively initiate the unzipping of graphene side walls at a relatively low electrochemical potential (0.6 V). The resultant nanostructures consisting of unzipped graphene nanoribbons wrapping around carbon nanotube cores maintain the intact two-dimensional crystallinity with well-defined atomic configuration at the unzipped edges. Large surface area and robust electrical connectivity of the synergistic nanostructure demonstrate ultrahigh-power supercapacitor performance, which can serve for AC filtering with the record high rate capability of −85° of phase angle at 120 Hz.

Novel 3D self-assembled nanopatterning is presented via tailored crumpling of chemically modified graphene. Block-copolymer self-assembly formed on a layer of chemically modified graphene provides highly dense and uniform 2D nanopatterns, and the controlled crumpling of the chemically modified graphene by mechanical instabilities realizes the controlled 3D transformation of the self-assembled nanopatterns.