The present study examined the influence of a customized mouthguard on body alignment and balance performance in professional basketball players. Twenty-three professional male basketball players, aged 25.8 ± 8.6 years old, were voluntarily assigned to participate in three treatments, including no treatment (no mouthguard), acute treatment (wearing a mouthguard), and repeated treatments (8 weeks follow-up). Body alignment status, such as spinal and pelvic posture and balance performance, were measured at each time point using a 3D Formetric III (Germany) and a postural control device (Posturomed 202, Germany), respectively. A repeated MANOVA analysis with a Bonferroni post hoc test was applied, and the adjusted p-value was set at 0.02. No significant treatment effect was observed in body alignment (p = 0.302). However, univariate analysis showed a significant difference in pelvic torsion, where it was decreased after acute and repeated mouthguard treatments compared to no treatment (p < 0.001). Kyphotic angle also increased significantly following 8 weeks of treatment compared to no treatment (p < 0.001) and acute treatment (p < 0.002). There was a significant treatment effect on balance performance (p < 0.001). Both static and dynamic balance performance improved following 8 weeks of treatment (p < 0.001). Our study revealed that a customized mouthguard provides a benefit to balance performance. Notably, repeated treatment impacts on balance performance more than acute treatment. Although our findings did not show a significant effect on body alignment, some positive results, such as pelvic torsion and kyphotic angle, may provide substantial information for developing future longitudinal studies with large sample sizes.
To investigate the species and the distribution of the captured nuclides in a HEPA filter, it was dismantled into a metal part and a filter medium part to obtain a filter medium. From the nuclide analysis results for a filter medium part through pre-treatment of it, it was possible to obtain three kinds of typical distributions in view of the distribution of the captured nuclides in the filter medium. When considering these distribution characteristics of the captured radionuclide, the region showing the high concentration of the captured nuclides was the intake or the outlet part of the HEPA filter. On the other side, the middle part generally represented a uniform distribution below the average concentration of the captured nuclides. Therefore, in the event of taking a representative sample of a HEPA filter at the intake and the outlet part, the results of a nuclide analysis for that sample could be estimated as existing in the range from 1.0 to 1.5 times the real concentration of the nuclides captured by a filter medium. As a result, to conduct a radionuclide assessment of a spent HEPA filter without a dismantlement of it, the analysis results for a representative sample taken from both the intake and the outlet part of a spent HEPA filter could be regarded as an average value for the corresponding HEPA filter.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.