A study of generation of converging strong shock wave using microsecond underwater electrical explosion of spherical Cu-wire array is presented. Hydrodynamic simulations coupled with the equation of state for Cu and water, deposited energy, and the magnetic pressure were used to calculate the water parameters in the vicinity of the implosion origin. The results of simulations agree with the shock wave time-of-flight and energy delivered to the water flow and show that in the vicinity (diameter of $12 lm) of an implosion one can expect water pressure of $6 TPa, temperature of $17 eV, and compression of $8. V C 2013 American Institute of Physics.
We present the measurements of the development of striation like instabilities during the electrical driven explosions of wires in a water bath. In vacuum based wire explosion experiments, such instabilities have long been known. However, in spite of intense research into the explosion of wires in liquids, the development of these instabilities has either not been observed or has been assumed to play a minor role in the parameters of the exploding wire due to the tamping of the wire's explosion. Using synchrotron based multiframe radiography, we have seen the development of platelike density structures along an exploding copper wire. Our measurements were compared to a 2D magnetohydrodynamics simulation, showing similar striation formation. These observed instabilities could affect the measurements of the conductivity of the wire material in the gas-plasma state-an important parameter in the warm dense matter community. The striations could also act as a seed for other instabilities later in time if the wire is in a dense flow of material or experiences a shock from an adjacent wire-as it would do in experiments with arrays of wires.
Time-and space-resolved evolution of the density (down to 0.07 of solid state density) of a copper wire during its microsecond timescale electrical explosion in water was obtained by X-ray backlighting. In the present research, a flash X-ray source of 20 ns pulse-width and >60 keV photon energy was used. The conductivity of copper was evaluated for a temperature of 10 kK and found to be in good agreement with the data obtained in earlier experiments [DeSilva and Katsouros, Phys. Rev. E 57, 5945 (1998) and Sheftman and Krasik, Phys. Plasmas 18, 092704 (2011)] where only electrical and optical diagnostics were applied. Magneto-hydrodynamic simulation shows a good agreement between the simulated and experimental waveforms of the current and voltage and measured the radial expansion of the exploding wire. Also, the radial density distribution obtained by an inverse Abel transform analysis agrees with the results of these simulations. Thus, the validity of the equations of state for copper and the conductivity model used in the simulations was confirmed for the parameters of the exploding wire realized in the present research.
We present the first use of synchrotron-based phase contrast radiography to study pulsed-power driven high energy density physics experiments. Underwater electrical wire explosions have become of interest to the wider physics community due to their ability to study material properties at extreme conditions and efficiently couple stored electrical energy into intense shock waves in water. The latter can be shaped to provide convergent implosions, resulting in very high pressures (1-10 Mbar) produced on relatively small pulsed power facilities (100s of kA-MA). Multiple experiments have explored single-wire explosions in water, hoping to understand the underlying physics and better optimize this energy transfer process; however, diagnostics can be limited. Optical imaging diagnostics are usually obscured by the shock wave itself; and until now, diode-based X-ray radiography has been of relatively low resolution and rather a broad x-ray energy spectrum. Utilising phase contrast imaging capabilities of the ID19 beamline at the European Synchrotron Radiation Facility, we were able to image both the exploding wire and the shock wave. Probing radiation of 20-50 keV radiographed 200 μm tungsten and copper wires, in ∼2-cm diameter water cylinders with resolutions of 8 μm and 32 μm. The wires were exploded by a ∼30-kA, 500-ns compact pulser, and 128 radiographs, each with a 100-ps X-ray pulse exposure, spaced at 704 ns apart were taken in each experiment. Abel inversion was used to obtain the density profile of the wires, and the results are compared to two dimensional hydrodynamic and one dimensional magnetohydrodynamic simulations.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.