Biosurfactants are microbially synthesized surfactants that are environmental friendly due to low toxicity. Sophorolipid is one of the simplest biosurfactants with well-defined structure produced by Starmerella bombicola(ATCC 22214) on glucose and vegetable oil as the carbon source. The raw material cost accounts for 10-30% of the overall cost. Glycerol is readily available from a commercial fat-splitting process as sweetwater at a very low cost. Sophorolipids was synthesized using glycerol and sweetwater as a cost-effective carbon source. The glycerol was further replaced with sweetwater as a source of glycerol. Optimum glycerol concentration was 15% w/v with 10% w/v sunflower oil, giving 6.6 g/L of sophorolipids. The crude sophorolipid contains two major components; both of them were lactonic sophorolipids as analyzed by reverse-phase high-performance liquid chromatography (RP-HPLC), liquid chromatography-mass spectroscopy (LC-MS), and nuclear magnetic resonance ((1)H-NMR).

Vegetable edible oils and fats are mainly used for frying purposes in households and the food industry. The oil undergoes degradation during frying and hence has to be replaced from time to time. Rhamnolipids are produced by microbial cultivation using refined vegetable oils as a carbon source and Pseudomonas aeruginosa (ATCC 10145). The raw material cost accounts for 10-30% of the overall cost of biosurfactant production and can be reduced by using low-cost substrates. In this research, attention was focused on the preparation of rhamnolipids, which are biosurfactants, using potential frying edible oils as a carbon source via a microbial fermentation technique. The use of low-cost substrates as a carbon source was emphasized to tilt the cost of production for rhamnolipids. The yield was 2.8 g/L and 7.5 g/L from waste frying oil before and after activated earth treatment, respectively. The crude product contained mainly dirhamnolipids, confirmed by thin-layer chromatography (TLC), high-performance liquid chromatography (HPLC), liquid chromatography-mass spectroscopy (LC-MS), and (1)H-nuclear magnetic resonance (NMR). Hence, the treatment can be used to convert waste frying oil as a low-cost substrate into a cost-effective carbon source.

No abstract

The procedure for the classical chemical refining of vegetable oils consists of degumming, alkali neutralization, bleaching, and deodorization. Conventional refining of rice bran oil using alkali gives oil of acceptable quality, but the refining losses are very high. A critical work has been carried out to study the application of membrane technology in the pretreatment of crude rice bran oil. Oils intended for physical refining should have a low phosphorus content, and this is not readily achievable by the conventional acid/ water degumming process. The application of membrane technology for the pretreatment of rice bran oil has been investigated. The process has already been successfully applied to other vegetable oils. Ceramic membranes, which are important from the commercial point of view, were examined for this purpose. The results showed that the membrane-filtered oils met the requirements of physical refining, with a substantial reduction in color. It was observed that most of the waxy material was also rejected. Experiments were carried out to establish the relationship between permeate flux and rejection with membrane pore size, trans-membrane pressure and micellar solute concentration.