No abstract

No abstract

The rapid development that our society is experiencing effects road management, therefore developing economical and efficient solutions, as well as extending road service life is indispensable. Aging is a problem associated to the majority of failures at the pavement surface layer (cracks, fissures, fatigue), including those produced by traffic solicitations. Diverse studies indicate that alterations to mixtures due to age can be decreased by incorporating a filler or mineral filler. Therefore, the present study incorporates cellulose ashes at different Cv/Cs concentrations as contribution filler in bituminous mastic, analysing its influence on aging resistance using the Cantabro wear test. The results indicated that using cellulose ash as contribution filler allows promising results to be obtained in regards to aging resistance of asphalt mixtures, if they are incorporated in concentrations close to or equal to the critical concentration, with an increase in aging resistance from 45.3 to 48.6% depending on the type of bitumen used. Therefore, incorporating them into the design of asphalt mixtures could be an efficient and economical solution to the current problems of early cracking and pavements with a service life lower than the estimated, although a more thorough analysis of its behaviour in other tests and service conditions is required in bituminous mixtures.

The increased population has accelerated pavement deterioration of and boosted production of residues, generating a constant environmental problem. One of the main problems of pavements is a failure to develop union between bituminous mastic ligand and aggregate. The following study evaluates the use of ash from cellulose incineration as a contribution filler to improve thermal susceptibility of pavements in different climatic zones. The applied methodology for dosage was based on volumetric criteria and state curves. The obtained results showed that reusing this residue in determined conditions (Cv/Cs 1) offers lower wear loss to 35% of temperatures between 10 and 60 C, due to the Cv/Cs = 0.75 ratio that maximizes the cohesive properties of the mixture. Therefore, we showed that this type of industry residue can be reused without complication in zones of certain climatic criteria and that it provides improved properties to the asphalt mix compared to conventional mixes.

No abstract

No abstract

No abstract

In recent years, Chile’s vehicle fleet has undergone great changes, with 25% growth in motor vehicles. This increase is directly related to improvements in the performance of flexible pavements, which make infrastructure less susceptible to permanent deformations and/or cracking at high and low temperatures, respectively. In 2016, the Ministry of the Environment passed the Law on Recycling and Accountability to promote the search for innovative ideas and materials in different sectors. This research focused on the experimental study of the mechanical behaviour of a mixture of hot asphalt, incorporating thick particles of polyethylene terephthalate (PET) from bottle recycling, using the Marshall stability and flow test and the resilience module (rigidity) test at 5°C and 22°C. Based on previous research, significant PET fibre sizes were used, increasing the optimum amount of polyethylene terephthalate from 6% to 14% in the mixture. The results show that incorporating this polymeric additive provides greater stability, in addition to an increase in resistance to permanent deformations and fatigue, compared to a “traditional” mixture.