No abstract

Objectives The main reason for restoration failure is secondary caries caused by biofilm acids. Replacing the failed restorations accounts for 50–70% of all operative work. The objectives of this study were to incorporate a new quaternary ammonium monomer (dimethylaminododecyl methacrylate, DMADDM) and nanoparticles of silver (NAg) into a primer and an adhesive, and to investigate their effects on antibacterial and dentin bonding properties. Methods Scotchbond Multi-Purpose (SBMP) served as control. DMADDM was synthesized and incorporated with NAg into primer/adhesive. A dental plaque microcosm biofilm model with human saliva was used to investigate metabolic activity, colony-forming units (CFU), and lactic acid. Dentin shear bond strengths were measured. Results Minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) of the new DMADDM were orders of magnitude lower than those of a previous quaternary ammonium dimethacrylate (QADM). Uncured primer with DMADDM had much larger inhibition zones than QADM (p<0.05). Cured primer/adhesive with DMADDM-NAg greatly reduced biofilm metabolic activity (p<0.05). Combining DMADDM with NAg in primer/adhesive resulted in less CFU than DMADDM alone (p<0.05). Lactic acid production by biofilms was reduced by 20-fold via DMADDM-NAg, compared to control. Incorporation of DMADDM and NAg into primer/adhesive did not adversely affect dentin bond strength. Conclusions A new antibacterial monomer DMADDM was synthesized and incorporated into primer/adhesive for the first time. The bonding agents are promising to combat residual bacteria in tooth cavity and invading bacteria at tooth-restoration margins to inhibit caries. DMADDM and NAg are promising for use into a wide range of dental adhesive systems and restoratives.

In this study the crack growth resistance behavior and fracture toughness of human tooth enamel were quantified using incremental crack growth measures and conventional fracture mechanics. Results showed that enamel undergoes an increase in crack growth resistance (i.e. rising R-curve) with crack extension from the outer to the inner enamel, and that the rise in toughness is function of distance from the Dentin Enamel Junction (DEJ). The outer enamel exhibited the lowest apparent toughness (0.67 ± 0.12 MPa·m 0.5 ), and the inner enamel exhibited a rise in the growth toughness from 1.13 MPa·m 0.5 /mm to 3.93 MPa·m 0.5 /mm. The maximum crack growth resistance at fracture (i.e. fracture toughness (K c )) ranged from 1.79 to 2.37 MPa·m0.5. Crack growth in the inner enamel was accompanied by host of mechanisms operating from the micro-to the nano-scale. Decussation in the inner enamel promoted crack deflection and twist, resulting in a reduction of the local stress intensity at the crack tip. In addition, extrinsic mechanisms such as bridging by unbroken ligaments of the tissue and the organic matrix promoted crack closure. Microcracking due to loosening of prisms was also identified as an active source of energy dissipation. In summary, the unique microstructure of enamel in the decussated region promotes crack growth toughness that is approximately three times that of dentin and over ten times that of bone.

No abstract

No abstract

No abstract

Aging and the related changes in mechanical behavior of hard tissues of the human body are becoming increasingly important. In this study the influence of aging on the mechanical behavior of human enamel was evaluated using 3rd molars from young (18 < or = age < or = 30 years) and old (55 < or = age) patients. The hardness and elastic modulus were quantified using nanoindentation as a function of distance from the Dentin-Enamel Junction (DEJ) and within three different regions of the crown (i.e. cervical, cuspal and inter-cuspal enamel). Results of the evaluation showed that the elastic modulus and hardness increased with distance from the DEJ in all three regions examined, regardless of patient age. The largest increases with distance from the DEJ occurred within the cervical region of the old enamel. Overall, the results showed that there were no age-dependent differences in properties of enamel near the DEJ. However, near the tooth's surface, both the hardness (p < 0.025) and elastic modulus (p < 0.0001) were significantly greater in the old enamel. At the surface of the tooth the average elastic modulus of "old" enamel was nearly 20% greater than that of enamel from the young patients.

Optical methods are becoming commonplace in investigations of the physical and mechanical behavior of biological tissues. Digital image correlation (DIC) is a versatile optical method that shows tremendous promise for applications involving biological tissues and biomaterials. We present the fundamentals of DIC with an emphasis on the application to biological materials. An approach for surface preparation is described that facilitates its application to hydrated substrates. Three examples are presented that highlight the use of DIC for biomedical research. The first example describes the use of DIC to study the mechanical behavior of arterial tissues up to 40% elongation. The second example describes an evaluation of the mechanical properties of bovine hoof horn in the dehydrated and fully hydrated states. Uniaxial tension experiments are performed to determine the elastic modulus (E) and Poisson's ratio (nu) of both the arterial and dermal tissues. Spatial variations in the mechanical properties are evident from the full-field characterization of both tissues. Finally, an application of DIC to study the evolution of loosening in cemented total hip replacements is described. The noncontact analysis enables measurement of the relative displacement between the bone/bone cement and bone cement/prosthesis interfaces. Based on the elementary optical arrangement, the simple surface preparation, and the ability to acquire displacement/strain measurements over a large range of deformation, DIC should serve as a valuable tool for biomedical research. Further developments will enable the use of DIC for in vivo applications.