В работе представлены результаты физико-математического моделирования с использованием метода конечных элементов технологического процесса ковки сплава марки ХН55МвЦ-иД В расчете использованы экспериментальные данные о механических характеристиках сплава, определенные при испытаниях на растяжение и сжатие в условиях, имитирующих процесс ковки. На основе анализа модели сопоставлены процессы осадки и протяжки. Установлено, что в процессе осадки значения растягивающих деформаций в отдельных локальных областях близки к предельной пластичности сплава при температурах 1100-1140 °С. Поэтому для снижения риска образования дефектов в процессе деформации при температурах близких к 1140 °С целесообразно избегать операции осадки слитка. Процесс протяжки при температуре 1140 °С более благоприятен, так как значения растягивающих деформаций много меньше предельной пластичности сплава во всем исследованном диапазоне температур.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.