No abstract

Various experiments were conducted on two full-size Pulsating Heat Pipes (PHP) which differed from their diameter, number of turns, and working fluid. The analysis of the experimental results showed two kind of operating curves (overall thermal resistance vs. heat rate): for low heat fluxes, the curve is irregular and the PHP performance is sensitive to the orientation. For high heat fluxes, the operating curve is smooth and independent from the orientation. To contribute to the analysis of these results, experiments were conducted at the ACCEPTED MANUSCRIPT 2 scale of a single branch of a PHP. An oscillating motion was imposed to a single liquid plug surrounded by two vapour slugs in a capillary tube and high speed visualisations were performed. The test section was either adiabatic or heated. The adiabatic experiments brought to the fore the importance of dynamic contact angles in the flow and the dissymmetry between the advancing and receding contact angle. The non-adiabatic experiments showed that at low flux, the flow is disturbed by bubble nucleation, while at high heat flux, the main heat transfer mechanism is thin film evaporation, with a completely different thermal and hydrodynamic behaviour.

No abstract

No abstract

This paper reports on an experimental study of a closed loop Flat Plate Pulsating Heat Pipe (FPPHP) tested on ground and on board of an aircraft during the 60th ESA parabolic flight campaign, during which hyper- and microgravity conditions were reproduced. The tested FPPHP consists of two brazed copper plates, into one of which a continuous rectangular channel (1.6 x 1.7 mm(2)) with 12 bends in the evaporator is machined. The channel is filled with FC-72 as working fluid with a volumetric filling ratio of 50%. Tests have been conducted with the FPPHP positioned both horizontally and vertically (bottomheated). The FPPHP presents an innovative design, involving the milling of grooves between the channels. Experimental results on the ground show that the thermal device can transfer more than 180 W in both inclinations, and that the horizontal operation is characterized by repeated stop-and-start phases and lower thermal performance. The FPPHP can operate under microgravity conditions and with a transient gravity force, with global thermal resistance reaching 50% and 25% of that of the empty plate (or around 66% and 35% of a full copper spreader of same overall dimensions), in horizontal and vertical orientation respectively. The temperature homogeneity remains within 10 K in the evaporator section and 3 K in the condenser section with thermal power transfer up to 180 W. Minimum thermal resistance of 0.12 K W-1 was recorded, with its value rising as heating grew more powerful. A parabolic flight test demonstrated that the FPPHP in vertical inclination is rapidly influenced by variation of gravity field, even if, due to the novel geometry, it continues to operate under microgravity. In horizontal inclination, on the other hand, there was no observable parameter change during gravity field variations

No abstract

No abstract

No abstract