Intelligent reflecting surfaces (IRSs) constitute a disruptive wireless communication technique capable of creating a controllable propagation environment. In this paper, we propose to invoke an IRS at the cell boundary of multiple cells to assist the downlink transmission to cell-edge users, whilst mitigating the inter-cell interference, which is a crucial issue in multicell communication systems. We aim for maximizing the weighted sum rate (WSR) of all users through jointly optimizing the active precoding matrices at the base stations (BSs) and the phase shifts at the IRS subject to each BS's power constraint and unit modulus constraint. Both the BSs and the users are equipped with multiple antennas, which enhances the spectral efficiency by exploiting the spatial multiplexing gain. Due to the nonconvexity of the problem, we first reformulate it into an equivalent one, which is solved by using the block coordinate descent (BCD) algorithm, where the precoding matrices and phase shifts are alternately optimized. The optimal precoding matrices can be obtained in closed form, when fixing the phase shifts. A pair of efficient algorithms are proposed for solving the phase shift optimization problem, namely the Majorization-Minimization (MM) Algorithm and the Complex Circle Manifold (CCM) Method. Both algorithms are guaranteed to converge to at least locally optimal solutions. We also extend the proposed algorithms to the more general multiple-IRS and network MIMO scenarios. Finally, our simulation results confirm the advantages of introducing IRSs in enhancing the cell-edge user performance.

An intelligent reflecting surface (IRS) is invoked for enhancing the energy harvesting performance of a simultaneous wireless information and power transfer (SWIPT) aided system. Specifically, an IRS-assisted SWIPT system is considered, where a multi-antenna aided base station (BS) communicates with several multi-antenna assisted information receivers (IRs), while guaranteeing the energy harvesting requirement of the energy receivers (ERs). To maximize the weighted sum rate (WSR) of IRs, the transmit precoding (TPC) matrices of the BS and passive phase shift matrix of the IRS should be jointly optimized. To tackle this challenging optimization problem, we first adopt the classic block coordinate descent (BCD) algorithm for decoupling the original optimization problem into several subproblems and alternately optimize the TPC matrices and the phase shift matrix. For each subproblem, we provide a low-complexity iterative algorithm, which is guaranteed to converge to the Karush-Kuhn-Tucker (KKT) point of each subproblem. The BCD algorithm is rigorously proved to converge to the KKT point of the original problem. We also conceive a feasibility checking method to study its feasibility. Our extensive simulation results confirm that employing IRSs in SWIPT beneficially enhances the system performance and the proposed BCD algorithm converges rapidly, which is appealing for practical applications.

Intelligent reflection surface (IRS) has recently been recognized as a promising technique to enhance the performance of wireless systems due to its ability of reconfiguring the signal propagation environment. However, the perfect channel state information (CSI) is challenging to obtain at the base station (BS) due to the lack of radio frequency (RF) chains at the IRS. Since most of the existing channel estimation methods were developed to acquire the cascaded BS-IRS-user channels, this paper is the first work to study the robust beamforming based on the imperfect cascaded BS-IRS-user channels at the transmitter (CBIUT). Specifically, the transmit power minimization problems are formulated subject to the worst-case rate constraints under the bounded CSI error model and the rate outage probability constraints under the statistical CSI error model, respectively. After approximating the worst-case rate constraints by using the S-procedure and the rate outage probability constraints by using the Bernsteintype inequality, the reformulated problems can be efficiently solved. Numerical results show that the negative impact of the CBIUT error on the system performance is greater than that of the direct CSI error. Index Terms-Intelligent reflecting surface (IRS), reconfigurable intelligent surface (RIS), robust design, imperfect channel state information (CSI), cascaded BS-IRS-user channels.

Perfect channel state information (CSI) is challenging to obtain due to the limited signal processing capability at the intelligent reflection surface (IRS). In this paper, we study the worst-case robust beamforming design for an IRS-aided multiuser multiple-input single-output (MU-MISO) system under the assumption of imperfect CSI. We aim for minimizing the transmit power while ensuring that the achievable rate of each user meets the quality of service (QoS) requirement for all possible channel error realizations. With unit-modulus and rate constraints, this problem is non-convex. The imperfect CSI further increases the difficulty of solving this problem. By using approximation and transformation techniques, we convert this problem into a squence of semidefinite programming (SDP) subproblems that can be efficiently solved. Numerical results show that the proposed robust beamforming design can guarantee the required QoS targets for all the users.

Computation off-loading in mobile edge computing (MEC) systems constitutes an efficient paradigm of supporting resource-intensive applications on mobile devices. However, the benefit of MEC cannot be fully exploited, when the communications link used for off-loading computational tasks is hostile. Fortunately, the propagation-induced impairments may be mitigated by intelligent reflecting surfaces (IRS), which are capable of enhancing both the spectral-and energy-efficiency. Specifically, an IRS comprises an IRS controller and a large number of passive reflecting elements, each of which may impose a phase shift on the incident signal, thus collaboratively improving the propagation environment. In this paper, the beneficial role of IRSs is investigated in MEC systems, where singleantenna devices may opt for off-loading a fraction of their computational tasks to the edge computing node via a multiantenna access point with the aid of an IRS. Pertinent latencyminimization problems are formulated for both single-device and multi-device scenarios, subject to practical constraints imposed on both the edge computing capability and the IRS phase shift design. To solve this problem, the block coordinate descent (BCD) technique is invoked to decouple the original problem into two subproblems, and then the computing and communications settings are alternatively optimized using low-complexity iterative algorithms. It is demonstrated that our IRS-aided MEC system is capable of significantly outperforming the conventional MEC system operating without IRSs. Quantitatively, about 20 % computational latency reduction is achieved over the conventional MEC system in a single cell of a 300 m radius and 5 active devices, relying on a 5-antenna access point.

Reconfigurable intelligent surfaces (RISs) or intelligent reflecting surfaces (IRSs), are regarded as one of the most promising and revolutionizing techniques for enhancing the spectrum and/or energy efficiency of wireless systems. These devices are capable of reconfiguring the wireless propagation environment by carefully tuning the phase shifts of a large number of low-cost passive reflecting elements. In this article, we aim for answering four fundmental questions: 1) Why do we need RISs? 2) What is an RIS? 3) What are RIS's applications? 4) What are the relevant challenges and future research directions? In response, eight promising research directions are pointed out.

In this paper, we consider the sum power minimization problem via jointly optimizing user association, power control, computation capacity allocation and location planning in a mobile edge computing (MEC) network with multiple unmanned aerial vehicles (UAVs). To solve the nonconvex problem, we propose a low-complexity algorithm with solving three subproblems iteratively. For the user association subproblem, the compressive sensing based algorithm is accordingly is proposed. For the computation capacity allocation subproblem, the optimal solution is obtained in closed form. For the location planning subproblem, the optimal solution is effectively obtained via one-dimensional search method. To obtain a feasible solution for this iterative algorithm, a fuzzy c-means clustering based algorithm is proposed.Numerical results show that the proposed algorithm achieves better performance than conventional approaches. ). 2 I. INTRODUCTION With high mobility and the explosive growth of data traffic, unmanned aerial vehicles (UAVs) assisted wireless communications have attracted considerable attention [1]. Compared to conventional wireless communications, UAV-enabled wireless communications can provide higher wireless connectivity in areas without infrastructure coverage. Besides, high throughput can always be achieved in UAV-enabled wireless communications due to the higher probability of line-of-sight (LoS) communication links between user equipments (UEs) and UAVs [2]-[5]. Due to the above distinctions, UAVs can be utilized in many applications, such as UAVenabled relaying [6]-[9], UAV-enabled data collection [10]-[13], UAV-enabled device-to-device communication networks [14], [15], UAV-enabled wireless power transfer networks [16] and UAV-enabled caching networks [17], [18].To fully exploit the design degrees of freedom for UAV-enabled communications, it is crucial to investigate the location and trajectory optimization in UAV-enabled wireless communication networks. In [19], the altitude of UAV was optimized to provide maximum radio coverage on the ground. To maximize the number of covered users using the minimum transmit power, an optimal location and altitude placement algorithm was investigated in [20] for UAV-base stations (BSs). With different quality-of-service (QoS) requirements of users, authors in [21] studied the three-dimension UAV-BS placement that maximizes the number of covered users.Considering the adjustable UAVs' locations, the UAV number minimization was considered in [22]. In [23] and [24], the UAV's trajectory was optimized by jointly considering both the communication throughput and the UAV's energy consumption. Further optimizing user-UAV association, [25] investigated the sum power minimization problem of the UAV. Different from [19]-[25] with fixed-beamwidth antenna, the beamwidth of the directional antenna was optimized in [26] with fixed bandwidth allocation to improve the system throughput. Through jointly optimizing beamwidth and bandwidth, the sum power was further minimized in [27]. Deployi...

This paper studies the impact of hardware mismatch (HM) between the base station (BS) and the user equipment (UE) in the downlink (DL) of large-scale antenna systems. Analytical expressions to predict the achievable rates are derived for different precoding methods, i.e., matched filter (MF) and regularized zero-forcing (RZF), using large system analysis techniques. Furthermore, the upper bounds on achievable rates of MF and RZF with HM are investigated, which are related to the statistics of the circuit gains of the mismatched hardware. Moreover, we present a study of HM calibration, where we take zero-forcing (ZF) precoding as an example to compare two HM calibration schemes, i.e., Pre-precoding Calibration (Pre-Cal) and Post-precoding Calibration (Post-Cal). The analysis shows that Pre-Cal outperforms Post-Cal schemes. Monte-Carlo simulations are carried out, and numerical results demonstrate the correctness of the analysis.