A protocol for the ab initio crystal structure determination of powdered solids at natural isotopic abundance by combining solid-state NMR spectroscopy, crystal structure prediction, and DFT chemical shift calculations was evaluated to determine the crystal structures of four small drug molecules: cocaine, flutamide, flufenamic acid, and theophylline. For cocaine, flutamide and flufenamic acid, we find that the assigned 1 H isotropic chemical shifts provide sufficient discrimination to determine the correct structures from a set of predicted structures using the root-mean-square deviation (rmsd) between experimentally determined and calculated chemical shifts. In most cases unassigned shifts could not be used to determine the structures. This method requires no prior knowledge of the crystal structure, and was used to determine the correct crystal structure to within an atomic rmsd of less than 0.12 Å with respect to the known reference structure. For theophylline, the NMR spectra are too simple to allow for unambiguous structure selection.

Elucidating the binding mode of carboxylate-containing ligands to gold nanoparticles (AuNPs) is crucial to understand their stabilizing role. A detailed picture of the three-dimensional structure and coordination modes of citrate, acetate, succinate and glutarate to AuNPs is obtained by C andNa solid-state NMR in combination with computational modelling and electron microscopy. The binding between the carboxylates and the AuNP surface is found to occur in three different modes. These three modes are simultaneously present at low citrate to gold ratios, while a monocarboxylate monodentate (1κO) mode is favoured at high citrate:gold ratios. The surface AuNP atoms are found to be predominantly in the zero oxidation state after citrate coordination, although trace amounts of Au are observed. Na NMR experiments show that Na ions are present near the gold surface, indicating that carboxylate binding occurs as a 2e L-type interaction for each oxygen atom involved. This approach has broad potential to probe the binding of a variety of ligands to metal nanoparticles.

Dynamic nuclear polarization (DNP) enhanced solid-state NMR spectroscopy at 9.4 T is demonstrated for the detailed atomic-level characterization of commercial pharmaceutical formulations. To enable DNP experiments without major modifications of the formulations, the gently ground tablets are impregnated with solutions of biradical polarizing agents. The organic liquid used for impregnation (here 1,1,2,2-tetrachloroethane) is chosen so that the active pharmaceutical ingredient (API) is minimally perturbed. DNP enhancements (ε) of between 40 and 90 at 105 K were obtained for the microparticulate API within four different commercial formulations of the over-the-counter antihistamine drug cetirizine dihydrochloride. The different formulations contain between 4.8 and 8.7 wt % API. DNP enables the rapid acquisition with natural isotopic abundances of one- and two-dimensional (13)C and (15)N solid-state NMR spectra of the formulations while preserving the microstructure of the API particles. Here this allowed immediate identification of the amorphous form of the API in the tablet. API-excipient interactions were observed in high-sensitivity (1)H-(15)N correlation spectra, revealing direct contacts between povidone and the API. The API domain sizes within the formulations were determined by measuring the variation of ε as a function of the polarization time and numerically modeling nuclear spin diffusion. Here we measure an API particle radius of 0.3 μm with a single particle model, while modeling with a Weibull distribution of particle sizes suggests most particles possess radii of around 0.07 μm.

In this article, the relationships between molecular symmetry, molecular electronic structure, and chemical shielding (CS) tensors are discussed. First, a brief background on the CS interaction and CS tensors is given. Then, the visualization of the three-dimensional nature of CS is described. A simple method for examining the relationship between molecular orbitals (MOs) and CS tensors, using point groups and direct products of irreducible representations of MOs and rotational operators, is outlined. A number of specific examples are discussed, involving CS tensors of different nuclei in molecules of different symmetries, including ethene (D 2h ), hydrogen fluoride (C 1v ), trifluorophosphine (C 3v ), and water (C 2v ). Finally, we review the application of this method to CS tensors in several interesting cases previously discussed in the literature, including acetylene (D 1h ), the PtX 4 2À series of compounds (D 4h ) and the decamethylaluminocenium cation (D 5d ).

The synthesis and full characterization of a well-defined silica-supported ≡Si-O-W(Me)5 species is reported. Under an inert atmosphere, it is a stable material at moderate temperature, whereas the homoleptic parent complex decomposes above -20 °C, demonstrating the stabilizing effect of immobilization of the molecular complex. Above 70 °C the grafted complex converts into the two methylidyne surface complexes [(≡SiO-)W(≡CH)Me2] and [(≡SiO-)2W(≡CH)Me]. All of these silica-supported complexes are active precursors for propane metathesis reactions.

The spatial arrangement of atoms is directly linked to chemical function. A fundamental challenge in surface chemistry and catalysis relates to the determination of three-dimensional structures with atomic-level precision. Here we determine the three-dimensional structure of an organometallic complex on an amorphous silica surface using solid-state NMR measurements, enabled through a dynamic nuclear polarization surface enhanced NMR spectroscopy approach that induces a 200-fold increase in the NMR sensitivity for the surface species. The result, in combination with EXAFS, is a detailed structure for the surface complex determined with a precision of 0.7 Å. We observe a single well-defined conformation that is folded toward the surface in such a way as to include an interaction between the platinum metal center and the surface oxygen atoms.

A series of monohaloanilinium halides exhibiting weak halogen bonding (XB) has been prepared and characterized by 35 Cl, 81 Br, and 127 I solid-state nuclear magnetic resonance (SSNMR) spectroscopy in magnetic fields of up to 21.1 T. The quadrupolar and chemical shift (CS) tensor parameters for halide ions (Cl − , Br − , I − ) which act as electron density donors in the halogen bonds of these compounds are measured to provide insight into the possible relationship between halogen bonding and NMR observables. The NMR data for certain series of related compounds are strongly indicative of when such compounds pack in the same space group, thus providing practical structural information. Careful interpretation of the NMR data in the context of novel and previously available X-ray crystallographic data, and new gauge-including projector-augmented-wave density functional theory (GIPAW DFT) calculations has revealed several notable trends. When a series of related compounds pack in the same space group, it has been possible to interpret trends in the NMR data in terms of the strength of the halogen bond. For example, in isostructural series, the halide quadrupolar coupling constant was found to increase as the halogen bond weakens. In the case of a series of haloanilinium bromides, the 81 Br isotropic chemical shift and CS tensor span both decrease as the bromide−halogen XB is weakened. These trends were reproduced using both GIPAW DFT and cluster-model calculations of the bromide ion magnetic shielding tensor. Such trends are particularly exciting given the well-known role that NMR has played historically in the characterization of hydrogen bonding.

Solid-state NMR spectroscopy and GIPAW DFT calculations reveal the pronounced sensitivity of (79/81)Br and (25)Mg quadrupolar coupling constants to subtle aspects of solid state structure which were not previously detected by pXRD methods.