Intraoperative periarticular injection with multimodal drugs can significantly reduce the requirements for patient-controlled analgesia and improve patient satisfaction, with no apparent risks, following total knee arthroplasty.

Restoration of femoral offset and acetabular inclination may have an effect on polyethylene (PE) wear in THA. We therefore assessed the effect of femoral offset and acetabular inclination (angle) on acetabular conventional (not highly cross-linked) PE wear in uncemented THA. We prospectively followed 43 uncemented THAs for a minimum of 49 months (mean, 64 months; range, 49-88 months). Radiographs were assessed for femoral offset, acetabular inclination, and conventional PE wear. The mean (± standard deviation) linear wear rate in all THAs was 0.14 mm/year (± 0.01 mm/year) and the mean volumetric wear rate was 53.1 mm 3 /year (± 5.5 mm 3 /year). InTHAs with an acetabular angle less than 45°, the mean wear was 0.12 mm/year (± 0.01 mm/year) compared with 0.18 mm/year (± 0.02 mm/year) in those with a reconstructed acetabular angle greater than 45°. Reproduction of a reconstructed femoral offset to within 5 mm of the native femoral offset was associated with a reduction in conventional PE wear (0.12 mm/year versus 0.16 mm/year). Careful placement of the acetabular component to ensure an acetabular angle less than 45°in the reconstructed hip allows for reduced conventional PE wear.

Level I, therapeutic study. See the guidelines online for a complete description of level of evidence.

We identified five (2.3%) fractures of the stem in a series of 219 revision procedures using a cementless, cylindrical, extensively porous-coated, distally-fixed femoral stem. Factors relating to the patients, the implant and the operations were compared with those with intact stems. Finite-element analysis was performed on two of the fractured implants. Factors associated with fracture of the stem were poor proximal bone support (type III-type IV; p = 0.001), a body mass index > 30; (p = 0.014), a smaller diameter of stem (< 13.5 mm; p = 0.007) and the use of an extended trochanteric osteotomy (ETO 4/5: p = 0.028). Finite-element analysis showed that the highest stresses on the stem occurred adjacent to the site of the fracture. The use of a strut graft wired over an extended trochanteric osteotomy in patients lacking proximal femoral cortical support decreased the stresses on the stem by 48%.We recommend the use of a strut allograft in conjunction with an extended trochanteric osteotomy in patients with poor proximal femoral bone stock.

No abstract

No abstract

No abstract

The results are reported of a radiographic study of cement mantle thickness in 112 consecutive primary hip replacements. Measurements were made by three observers of the apparent cement thickness medially and laterally using standard anterior-posterior radiographs. The average cement thickness was 3.2 mm, which is 1.2 mm greater than the size difference between the broach and the prosthesis, and was in the range 2-5 mm in 67 per cent of all measurement points. This has significance for the design of instrumentation to prepare the femoral cavity to give a defined cement mantle thickness. There was a greater cement mantle thickness proximally than distally. In 95 cases it was possible to determine the orientation of the stem within the cement mantle, which showed an even distribution between varus and valgus orientation; 49 per cent were within 1 degree of neutral and only one case was more than 5 degrees from neutral.