International audienceThis paper addresses the problem of time synchronization in the IEEE 802.11a OFDM wireless communication system.In addition to the reference sequence usually used in conventional algorithms, recently the SIGNAL field of the physical packet has been exploited to improve the coarse time synchronization. To increase the performance of the fine time synchronization, we propose to use joint time synchronization and channel estimation based on the Maximum A Posteriori Probability criterion. Simulation results show that the probability of synchronization failure of the proposed synchronization algorithm is reduced as compared to existing methods
Time and frequency synchronization in the IEEE 802.11a OFDM (Orthogonal Frequency Division Multiplexing) wireless communication system is addressed in this paper. Usually synchronization algorithms rely only on training sequences specified by the standard. To enhance the synchronization between stations, we propose to extract known information by both the transmitter and the receiver at the IEEE 802.11a physical layer to be then exploited by the receiver in addition to the training sequences. Indeed the parts of the identified SIGNAL field are either known or predictable from the RtS (Request to Send) control frame when the CSMA/CA (Carrier Sense Multiple Access with Collision Avoidance) mechanism is triggered jointly to bit-rate adaptation algorithms to the channel. Moreover the received RtS control frame allows the receiver to estimate the channel before time synchronization stage improving then the performance of the proposed synchronization algorithm. Simulation results show that the performance of the proposed synchronization algorithm is improved as compared to existing algorithms.
Herein, we present an energy efficient successive-approximation-register (SAR) analog-to-digital converter (ADC) featuring on-chip dual calibration and various accuracy-enhancement techniques. The dual calibration technique is realized in an energy and area-efficient manner for comparator offset calibration (COC) and digital-to-analog converter (DAC) capacitor mismatch calibration. The calibration of common-mode (CM) dependent comparator offset is performed without using separate circuit blocks by reusing the DAC for generating calibration signals. The calibration of the DAC mismatch is efficiently performed by reusing the comparator for delay-based mismatch detection. For accuracy enhancement, we propose new circuit techniques for a comparator, a sampling switch, and a DAC capacitor. An improved dynamic latched comparator is proposed with kick-back suppression and CM dependent offset calibration. An accuracy-enhanced bootstrap sampling switch suppresses the leakage-induced error <180 μV and the sampling error <150 μV. The energy-efficient monotonic switching technique is effectively combined with thermometer coding, which reduces the settling error in the DAC. The ADC is realized using a 0.18 μm complementary metal–oxide–semiconductor (CMOS) process in an area of 0.28 mm2. At the sampling rate fS = 9 kS/s, the proposed ADC achieves a signal-to-noise and distortion ratio (SNDR) of 55.5 dB and a spurious-free dynamic range (SFDR) of 70.6 dB. The proposed dual calibration technique improves the SFDR by 12.7 dB. Consuming 1.15 μW at fS = 200 kS/s, the ADC achieves an SNDR of 55.9 dB and an SFDR of 60.3 dB with a figure-of-merit of 11.4 fJ/conversion-step.
This paper addresses altogether time and frequency synchronization in IEEE 802.11a orthogonal frequency division multiplexing (OFDM) wireless communication systems. The proposed algorithms have two main features: (i) they make use of an additional source of information available at IEEE 802.11a physical layer, on top of the usual ones typically adopted for synchronization such as training sequences. This additional source of information is provided by the higher layers of the communication protocol. In fact, when the carrier sense multiple access with collision avoidance (CSMA/CA) protocol is activated, the receiver is able to predict some parts of the SIGNAL field that are classically assumed unknown. Moreover, during the negotiation of the transmission medium reservation, the exchanged frames not only help the receiver to predict the SIGNAL field but also to obtain information about the channel state. (ii) Based on this property, we propose a joint MAP time and frequency synchronization algorithm using all available information. Finally, the time synchronization is fine tuned by means of a specific metric in the frequency domain that allows us to minimize the expectation of the transmission error function over all channel estimate errors. Simulation results compliant with the IEEE 802.11a standard in both indoor and outdoor environments show that the proposed algorithm drastically improves the performance in terms of synchronization failure probability and bit error ratio, compared to state-of-the-art algorithms.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.