No abstract

A controlled surface reaction technique has been successfully employed to prepare a series of Pt modified Pd/C (Pt/Pd/C) and Pd modified Pt/C (Pd/Pt/C) catalysts. The resulting catalyst materials were characterised by TEM, XRD, electrochemistry, and EXAFS techniques. In the case of the Pd/Pt/C carbon catalysts, core-shell structural arrangements were found, with a 0.04 A contraction of the Pd-Pd bond distance for the 1 Pd/Pt/C being observed. A greater degree of alloying was found for the Pt/Pd/C catalysts where the surface had a mixed composition with a large proportion of the Pt in the interior of the nanoparticle. However, strong Pt characteristics were exhibited in the voltammetry of Pt/Pd/C catalysts, most notably a large increase in the stability with respect to the electrochemical environment compared to Pd alone.

A series of carbon supported PtRu bimetallic catalysts with varying Pt:Ru ratio were prepared and characterised using ex situ and in situ XRD, in situ EXAFS at 0 V vs. RHE, ex situ XPS and monolayer CO stripping voltammetry. Although the catalysts were found to be well mixed/alloyed, with no evidence of unalloyed Ru (oxides) present, the surfaces of the electrocatalyst nanoparticles were found to be enriched with Pt compared to the nominal bulk composition. The methanol oxidation activities of the catalysts were determined in 1.0 mol dm(-3) H2SO4. In agreement with published studies of polycrystalline bulk PtRu alloys the catalyst with a 0.6 surface fraction of Pt was found to give the best methanol oxidation activity at 30 degrees C. However, at 80 degrees C a greater surface fraction of Ru could be tolerated, with some activity at low current densities found for a Pt surface fraction as low as 0.2. The results support the conclusion that a limited amount of methanol dehydrogenation occurs at Ru sites or Ru dominated surface ensembles at 80 degrees C.

The cathode electrocatalysts for proton exchange membrane (PEM) fuel cells are commonly platinum and platinum based alloy nanoparticles dispersed on a carbon support. Control over the particle size and composition has, historically, been attained empirically, making systematic studies of the effects of various structural parameters difficult. The controlled surface modification methodology used in this work has enabled the controlled modification of carbon supported Pt nanoparticles by Cr so as to yield nanoalloy particles with defined compositions. Subsequent heat treatment in 5% H2 in N2 resulted in the formation of a distinct Pt3Cr alloy phase which was either restricted to the surface of the particles or present throughout the bulk of the particle structure. Measurement of the oxygen reduction activity of the catalysts was accomplished using the rotating thin film electrode method and the activities obtained were related to the structure of the nanoalloy catalyst particles, largely determined using Cr K edge and Pt L3 edge XAS.

Note: Novel CeOx/Pt/Al2O3 catalysts have been prepared and characterised under different environments using XANES spectroscopy. The XANES spectra show that conversion to Ce3+ in an atmosphere of H2 is achieved, indicating that Ce is readily reduced at room temperature when well dispersed in the presence of Pt.

The Ru-CO bond of CO adsorbed on a Ru modified Pt/C fuel cell catalyst has been directly probed by in situ EXAFS at the Ru K-edge, providing evidence of a CO:metal surface atom ratio greater than 1:1 and that CO is adsorbed at bridging sites associated with Ru atoms at the surface of the catalyst nanoparticles.. This result

not Available.