No abstract

In this study, a novel porous titanium structure for the purpose of bone in-growth has been designed, manufactured and evaluated. The structure was produced by Selective Laser Melting (SLM); a rapid manufacturing process capable of producing highly intricate, functionally graded parts. The technique described utilizes an approach based on a defined regular unit cell to design and produce structures with a large range of both physical and mechanical properties. These properties can be tailored to suit specific requirements; in particular, functionally graded structures with bone in-growth surfaces exhibiting properties comparable to those of human bone have been manufactured. The structures were manufactured and characterized by unit cell size, strand diameter, porosity, and compression strength. They exhibited a porosity (10-95%) dependant compression strength (0.5-350 Mpa) comparable to the typical naturally occurring range. It is also demonstrated that optimized structures have been produced that possesses ideal qualities for bone in-growth applications and that these structures can be applied in the production of orthopedic devices.

The rapid manufacturing process of selective laser melting has been used to produce a series of stainless steel 316L microlattice structures. Laser power and laser exposure time are the two processing parameters used for manufacturing the lattice structures and, therefore, control the quality and mechanical properties of microlattice parts. An evaluation of the lattice material was undertaken by manufacturing a range of struts, representative of the individual trusses of the microlattices, as well as, microlattice block structures. Low laser powers were shown to result in significantly lower strand strengths due to the presence of inclusions of unmelted powder in the strut cross-sections. Higher laser powers resulted in struts that were near to full density as the measured strengths were comparable to the bulk 316L values. Uniaxial compression tests on microlattice blocks highlighted the effect of manufacturing parameters on the mechanical properties of these structures and a linear relationship was found between the plateau stress and elastic modulus relative to the measured relative density.

No abstract

No abstract

No abstract

Porous structures are used in orthopaedics to promote biological fixation between metal implant and host bone. In order to achieve rapid and high volumes of bone ingrowth the structures must be manufactured from a biocompatible material and possess high interconnected porosities, pore sizes between 100 and 700 microm and mechanical strengths that withstand the anticipated biomechanical loads. The challenge is to develop a manufacturing process that can cost effectively produce structures that meet these requirements. The research presented in this paper describes the development of a 'beam overlap' technique for manufacturing porous structures in commercially pure titanium using the Selective Laser Melting (SLM) rapid manufacturing technique. A candidate bone ingrowth structure (71% porosity, 440 microm mean pore diameter and 70 MPa compression strength) was produced and used to manufacture a final shape orthopaedic component. These results suggest that SLM beam overlap is a promising technique for manufacturing final shape functional bone ingrowth materials.

No abstract