No abstract

This paper presents an optical diagnostic technique based on seeded thermographic phosphor particles, which allows the simultaneous two-dimensional measurement of gas temperature, velocity and mixture fraction in turbulent flows. The particle Mie scattering signal is recorded to determine the velocity using a conventional PIV approach and the phosphorescence emission is detected to determine the tracer temperature using a two-color method. Theoretical models presented in this work show that the temperature of small tracer particles matches the gas temperature. In addition, by seeding phosphorescent particles to one stream and non-luminescent particles to the other stream, the mixture fraction can also be determined using the phosphorescence emission intensity after conditioning for temperature. The experimental technique is described in detail and a suitable phosphor is identified based on spectroscopic investigations. The joint diagnostics are demonstrated by simultaneously measuring temperature, velocity and mixture fraction in a turbulent jet heated up to 700 K. Correlated single shots are presented with a precision of 2 to 5% and an accuracy of 2%.

Simultaneous gas-phase temperature and velocity imaging using micrometer-size thermographic phosphor particles seeded into the flow is demonstrated at a 3 kHz repetition rate. The velocity field is measured using a standard particle image velocimetry approach, while the temperature is determined from the temperature sensitive phosphorescence emission of the particles following excitation at 355 nm. Since the particles are very small, they rapidly assume the temperature and velocity of the surrounding gas. A single shot temperature precision of better than 5 % was achieved at 500 K. Time-resolved measurements in the wake of a heated cylinder are presented, demonstrating the utility of these imaging diagnostics to observe transient, coupled heat and mass transfer phenomena.

Zinc oxide (ZnO) particles are characterised as a tracer for temperature measurements in turbulent flows, in the context of the thermographic particle image velocimetry technique. Flow measurements are used to compare the temperature precision of ZnO to that obtained using a well-characterised thermographic phosphor, BAM:Eu(2+), under the same conditions. For this two-colour, ratio-based technique the strongly temperature-dependent redshift of the luminescence emission of ZnO offers improved temperature sensitivity, and so at room temperature a threefold increase in the temperature precision is achieved. A dependence of the intensity ratio on the laser fluence is identified, and additional measurements with different laser pulse durations are used to independently show that there is also a dependence on the laser excitation irradiance, irrespective of fluence. A simple method to correct for these effects is demonstrated and sources of error are analysed in detail. Temperature images in a Re = 2000 jet of air heated to 363 K with a precision of 4 K (1.1%) are presented. The sensitivity of ZnO increases across the tested temperature range 300-500 K, so that at 500 K, using a seeding density of 2 x 10(11) particles/m(3), a precision of 3 K (0.6%) is feasible. This new phosphor extends the capabilities of this versatile technique toward the study of flows with small temperature variations.

dependence on the laser fluence is observed, while the measured intensity ratio is shown to be insensitive to both seeding density and the oxygen volume fraction. Finally, the saturation behaviour of the phosphorescence emission is examined, through theoretical considerations and measurements performed with different excitation schemes in an attempt to increase signal levels. In conclusion, this paper confirms that BAM:Eu 2+ is a very suitable tracer for measurements in turbulent flows up to 900 K.