Existing stretchable, transparent conductors are mostly electronic conductors. They limit the performance of interconnects, sensors, and actuators as components of stretchable electronics and soft machines. We describe a class of devices enabled by ionic conductors that are highly stretchable, fully transparent to light of all colors, and capable of operation at frequencies beyond 10 kilohertz and voltages above 10 kilovolts. We demonstrate a transparent actuator that can generate large strains and a transparent loudspeaker that produces sound over the entire audible range. The electromechanical transduction is achieved without electrochemical reaction. The ionic conductors have higher resistivity than many electronic conductors; however, when large stretchability and high transmittance are required, the ionic conductors have lower sheet resistance than all existing electronic conductors.

It is a challenge to synthesize materials that possess the properties of biological muscles-strong, elastic and capable of self-healing. Herein we report a network of poly(dimethylsiloxane) polymer chains crosslinked by coordination complexes that combines high stretchability, high dielectric strength, autonomous self-healing and mechanical actuation. The healing process can take place at a temperature as low as -20 °C and is not significantly affected by surface ageing and moisture. The crosslinking complexes used consist of 2,6-pyridinedicarboxamide ligands that coordinate to Fe(III) centres through three different interactions: a strong pyridyl-iron one, and two weaker carboxamido-iron ones through both the nitrogen and oxygen atoms of the carboxamide groups. As a result, the iron-ligand bonds can readily break and re-form while the iron centres still remain attached to the ligands through the stronger interaction with the pyridyl ring, which enables reversible unfolding and refolding of the chains. We hypothesize that this behaviour supports the high stretchability and self-healing capability of the material.

Our skin is a stretchable, large-area sheet of distributed sensors. These properties of skin have inspired the development of mimics, with differing levels of sophistication, to enable wearable or implantable electronics for entertainment and healthcare. [1][2][3][4] "Electronic skin" is generally taken to be a stretchable sheet with area above 10 cm 2 carrying sensors for various stimuli, including deformation, pressure, light and temperature. The sensors report signals through stretchable electrical conductors [5] (e.g., carbon grease, [6] microcraked metal films, [1] serpentine metal lines, [2] graphene sheets, [7] carbon nanotubes, [8][9][10] silver nanowires, [11] gold nanomeshes, [12] and liquid metals [13,14] ). These conductors transmit signals using electrons.They meet the essential requirements of conductivity and stretchability, but struggle to meet additional requirements in specific applications, such as biocompatibility in biometric sensors, [15] and transparency in tunable optics. [16,17] By contrast, sensors in our skin report signals using ions. Here we explore the potential of ionic conductors in the development of a new type of sensory sheet, which we call "ionic skin".The sensory sheet is highly stretchable, transparent, and biocompatible. It readily monitors large deformation, such as that generated by the bending of a finger. It detects stimuli with wide dynamic range (strains from 1% to 500%). It measures pressure as low as 1 kPa, with small drift over many cycles. A sheet of distributed sensors covering a large area can report the location and pressure of touch. High transparency allows the sensory sheet to transmit electrical signals without impeding optical signals.Many ionic conductors, such as hydrogels and ionogels, are highly stretchable and transparent. [18][19][20] These gels are polymeric networks swollen with water or ionic liquids. They behave like elastic solids and eliminate the need for containers as required in the case of liquid metal conductors. Whereas familiar elastic gels, such as Jell-O, are brittle and easily rupture, the recent decade has seen the development of hydrogels and ionogels as tough as elastomers. [20][21][22] Many hydrogels are biocompatible. They can be made softer than tissues, achieving the "mechanical invisibility" required for biometric sensors, which monitor soft tissues without 3 constraining them. Although most hydrogels dry out in open air, hydrogels containing humectants retain water in environment of low humidity, and ionogels are nonvolatile in vacuum. [18][19][20] We have recently used ionic conductors-together with stretchable and transparent dielectrics-to make actuators, which deform in response to high voltages, on the order of kilovolts. [18] By contrast, the sensors described here deform in response to applied forces, giving signals that can be measured using voltages below 1 volt. To illustrate principles in our design of the ionic skin, consider a simple example-a dielectric sandwiched between two ionic conductors (Figure 1). In many...

Soft robots actuated by pressurization and inflation of a pneumatic network (a "pneunet") of small channels in elastomeric materials are appealing for their ability to produce sophisticated motions with simple controls. Although current designs of pneu-nets achieve motion with large amplitudes, they do so relatively slowly (that is, over seconds). This paper describes a new design for pneu-nets that reduces the amount of gas that must be transported for inflation of the pneu-net, and thus increases its speed of actuation. A simple actuator can bend from a linear shape to a quasi-circular shape in 50 milliseconds when pressurized at ΔP = 345 kPa. At high rates of pressurization and inflation, the path along which the actuator bends depends on this rate. When inflated fully, the channels and chambers of this new pneu-net design experience only one-tenth the change in volume of that required for a motion of equal amplitude using the previous design. This small change in volume requires comparably low levels of strain in the material at maximum amplitudes of actuation, and commensurately low rates of fatigue and failure. This actuator can operate over a million cycles without significant degradation of performance. This design for soft robotic actuators combines high rates of actuation with high reliability of the actuator, and opens new areas of application for them.

Existing soft actuators have persistent challenges that restrain the potential of soft robotics, highlighting a need for soft transducers that are powerful, high-speed, efficient, and robust. We describe a class of soft actuators, termed hydraulically amplified self-healing electrostatic (HASEL) actuators, which harness a mechanism that couples electrostatic and hydraulic forces to achieve a variety of actuation modes. We introduce prototypical designs of HASEL actuators and demonstrate their robust, muscle-like performance as well as their ability to repeatedly self-heal after dielectric breakdown-all using widely available materials and common fabrication techniques. A soft gripper handling delicate objects and a self-sensing artificial muscle powering a robotic arm illustrate the wide potential of HASEL actuators for next-generation soft robotic devices.

Scientists are exploring elastic and soft forms of robots, electronic skin and energy harvesters, dreaming to mimic nature and to enable novel applications in wide fields, from consumer and mobile appliances to biomedical systems, sports and healthcare. All conceivable classes of materials with a wide range of mechanical, physical and chemical properties are employed, from liquids and gels to organic and inorganic solids. Functionalities never seen before are achieved. In this review we discuss soft robots which allow actuation with several degrees of freedom. We show that different actuation mechanisms lead to similar actuators, capable of complex and smooth movements in 3d space. We introduce latest research examples in sensor skin development and discuss ultraflexible electronic circuits, light emitting diodes and solar cells as examples. Additional functionalities of sensor skin, such as visual sensors inspired by animal eyes, camouflage, self-cleaning and healing and on-skin energy storage and generation are briefly reviewed. Finally, we discuss a paradigm change in energy harvesting, away from hard energy generators to soft ones based on dielectric elastomers. Such systems are shown to work with high energy of conversion, making them potentially interesting for harvesting mechanical energy from human gait, winds and ocean waves.

Self-healing materials can repair damage caused by mechanical wear, thereby extending lifetime of devices. A transparent, self-healing, highly stretchable ionic conductor is presented that autonomously heals after experiencing severe mechanical damage. The design of this self-healing polymer uses ion-dipole interactions as the dynamic motif. The unique properties of this material when used to electrically activate transparent artificial muscles are demonstrated.

Soft robotic systems are well suited to unstructured, dynamic tasks and environments, owing to their ability to adapt and conform without damaging themselves or their surroundings. These abilities are crucial in areas such as humanrobot interaction. Soft robotic systems are currently limited by the soft actuators that power them. To date, most soft actuators are based on pneumatics or shape-memory alloys, which have issues with efficiency, response speed, and portability. Dielectric elastomer actuators (DEAs) are controlled and powered electrically and excel with musclelike actuation, but they typically require a rigid frame and prestretch to perform effectively. In addition, DEAs require complex stacks or structures to achieve linear contraction modes. We present a class of soft electrohydraulic transducers, termed Peano-HASEL (hydraulically amplified self-healing electrostatic) actuators, that combine the strengths of fluidic actuators and electrostatic actuators, while addressing many of their issues. These actuators use both electrostatic and hydraulic principles to linearly contract on application of voltage in a muscle-like fashion, without rigid frames, prestretch, or stacked configurations. We fabricated these actuators using a facile heat-sealing method with inexpensive commercially available materials. These prototypical devices demonstrated controllable linear contraction up to 10%, a strain rate of 900% per second, actuation at 50 hertz, and the ability to lift more than 200 times their weight. In addition, these actuators featured characteristics such as high optical transparency and the ability to self-sense their deformation state. Hence, this class of actuators demonstrates promise for applications such as active prostheses, medical and industrial automation, and autonomous robotic devices.