The results of this biomechanical study suggest that grafts with tibial interference screw fixation provide better knee stability at time zero because of reduced graft elongation and greater stiffness in comparison with grafts with tibial adjustable-length loop cortical button fixation.

No abstract

No abstract

For the reduction in suture material to two sutures, additional suspension can be used in order to reduce the graft lengthening. Performing a suture-reducing graft can save operating time and costs. However, each of the three all-inside button graft techniques showed considerable graft elongation indicating a risk of graft lengthening in the early postoperative period.

No abstract

Introduction Cement augmentation is an established method to increase the pedicle screw (PS) anchorage in osteoporotic vertebral bodies. The ideal timing for augmentation when a reposition maneuver is necessary is controversial. While augmentation of the PS before reposition maneuver may increase the force applied it on the vertebrae, it bears the risk to impair PS anchorage, whereas augmenting the PS after the maneuver may restore this anchorage and prevent early screw loosening. The purpose of the present study was to evaluate the effect of cement application timing on PS anchorage in the osteoporotic vertebral body. Methods Ten lumbar vertebrae (L1-L5) were used for testing. The left and right pedicles of each vertebra were instrumented with the same PS size and used for pairwise comparison of the two timing points for augmentation. For the reposition maneuver, the left PS was loaded axially under displacement control (2 9 ±2 mm, 3 9 ±6 mm, 3 9 ±10 mm) to simulate a reposition maneuver.Subsequently, both PS were augmented with 2 ml PMMA cement. The same force as measured during the left PS maneuver was applied to the previously augmented right hand side PS [2 9 F (±2 mm), 3 9 F (±6 mm), 3 9 F (±10 mm)]. Both PS were cyclically loaded with initial forces of ?50 and -50 N, while the lower force was increased by 5 N every 100 cycles until total failure of the PS. The PS motion was measured with a 3D motion analysis system. After cyclic loading stress, X-rays were taken to identify the PS loosening mechanism. Results In comparison with PS augmented prior to the reposition maneuver, PS augmented after the reposition maneuver showed a significant higher number of load cycles until failure (5930 ± 1899 vs 3830 ± 1706, p = 0.015). The predominant loosening mechanism for PS augmented after the reposition maneuver was PS toggling with the attached cement cloud within the trabecular bone. While PS augmented prior to the reposition, maneuver showed a motion of the screw within the cement cloud. Conclusion The time of cement application has an effect on PS anchorage in the osteoporotic vertebral body if a reposition maneuver of the instrumented vertebrae is carried out. PS augmented after the reposition maneuver showed a significant higher number of load cycles until screw loosening.

No abstract

A novel biomechanical test bench has been developed for in-vitro evaluation of the knee joint. The test bench allows the kinematics of the knee joint to be studied in all six degrees of freedom. Flexion-extension knee movements are induced by quadriceps and hamstring muscle forces simulated by five pneumatic cylinders. The kinematics of the knee and the actively applied muscle forces are measured simultaneously. The aim of this study was to validate the sensitivity and reproducibility of this novel test bench. Four fresh frozen human knees were tested three times, each with seven flexion-extension cycles between 5° and 60°. After the native knees had been tested, the posterior cruciate ligament and then the lateral collateral ligament were dissected. The injured knees were tested in identical conditions [3×(7×5°-60°)] in order to evaluate whether the test bench is capable of detecting differences in knee kinematics between a native state and an injured one. With regard to reproducibility, the novel test bench showed almost perfect agreement for each specimen and for all states and flexion angles. In comparison with the native knees, the injured knees showed significant differences in knee kinematics. This validated novel test bench will make it possible to investigate various knee pathologies, as well as current and newly developed treatment options.