Hydrogen induced cracking was investigated for hot-rolled titanium steels. Aim of the present work was to observe the influence of titanium content and grain size on the cracking behaviour. Three titanium steels (0.12-0.30 % Ti; 0.0057-0.0480 % C) and one non-titanium steel (0.0056 % C) were used for the investigation. Various grain sizes were generated by heat treatment at 950, 1050 and 1150 °C; furnace cooling was applied. The specimens were electrolytically charged with hydrogen at various current densities. It was found that cracks are generated at low charging current densities for the investigated steels. The titanium steels showed better performance than the non-titanium steel. It was shown that the charging current density does not correspond to the hydrogen concentration in a steel; the hydrogen concentration in steel B was 3.8 ppm at 1 mA/cm 2 • in steel D it was found to be 15.5 ppm at 0.5 mA/cm 2 . The total hydrogen concentration was found to be influenced by content of precipitates and grain size. It was shown that the percentage of cracked grain boundary area increases with increasing grain size. This increase is linear for the non-titanium steel whilst for the titanium steels a plateau was observed at a grain size diameter of 50 µ,m. EinfluB von Ti-Gehalt undKorngroBe auf wasserstoffinduzierte RiBbildung in warmgewalzten Stahlen. Die vorliegende Arbeit behandelt den EinfluB von Titangehalt und Korngri:iBe auf die wasserstoffinduzierte RiBbildung bei warmgewalzten Stahlen. HierfOr wurden drei verschiedene Ti-legierte Stahle, deren Ti-Gehalte zwischen O, 12 und 0,30 % und C-Gehalte von 0,0057 bis 0,0480 % variierten, sowie ein Ti-freier Stahl mil 0,0056 % C herangezogen. Warmebehandlungen bei 950, 1050 bzw. 1150 °C mil anschlieBender AbkOhlung im Ofen sorgten tor verschiedene KorngroBen. Die Wasserstoffbeladung der Proben erfolgte elektrolytisch bei verschiedenen Stromdichten. Es stellte sich heraus, daB niedrige Temperaturen die RiBbildung bei den untersuchten Stahlen begOnstigen; dabei schnitten die Ti-legierten Sorten insgesamt besser ab als der Stahl ohne Titan. Es zeigte sich weiterhin, daB die Stromdichte bei der Beladung nicht mil der Wasserstoffkonzentration korrespondiert. Vielmehr beeinflussen der Anteil der Ausscheidungen und die Korngri:iBe die Wasserstoffgesamtkonzentration. SchlieBlich stellte sich heraus, daB der Anteil riBbehafteter Korngrenzen mil zunehmender Korngri:iBe wachst. Dieser Anstieg verlauft tor den Ti-freien Stahl linear, fur Ti-legierte Sorten bildet sich dagegen ein Plateau bei einem Korndurchmesser von 50 µ,m aus.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.