Implantable ventricular assist devices (VADs) have proven efficient in advanced heart failure patients as a bridge-to-transplant or destination therapy. However, VAD usage often leads to infection, bleeding, and thrombosis, side effects attributable to the damage to blood cells and plasma proteins. Measuring hemolysis alone does not provide sufficient information to understand total blood damage, and research exploring the impact of currently available pumps on a wider range of blood cell types and plasma proteins such as von Willebrand factor (vWF) is required to further our understanding of safer pump design. The extracorporeal CentriMag (Thoratec Corporation, Pleasanton, CA, USA) has a hemolysis profile within published standards of normalized index of hemolysis levels of less than 0.01 g/100 L at 100 mm Hg but the effect on leukocytes, vWF multimers, and platelets is unknown. Here, the CentriMag was tested using bovine blood (n = 15) under constant hemodynamic conditions in comparison with a static control for total blood cell counts, hemolysis, leukocyte death, vWF multimers, microparticles, platelet activation, and apoptosis. The CentriMag decreased the levels of healthy leukocytes (P < 0.006), induced leukocyte microparticles (P < 10−5), and the level of high molecular weight of vWF multimers was significantly reduced in the CentriMag (P < 10−5) all compared with the static treatment after 6 h in vitro testing. Despite the leukocyte damage, microparticle formation, and cleavage of vWF multimers, these results show that the CentriMag is a hemocompatible pump which could be used as a standard in blood damage assays to inform the design of new implantable blood pumps.

The common complications in heart failure patients with implanted ventricular assist devices (VADs) include hemolysis, thrombosis, and bleeding. These are linked to shear stress-induced trauma to erythrocytes, platelets, and von Willebrand factor (vWF). Novel device designs are being developed to reduce the blood trauma, which will need to undergo in vitro and in vivo preclinical testing in large animal models such as cattle, sheep, and pig. To fully understand the impact of device design and enable translation of preclinical results, it is important to identify any potential species-specific differences in the VAD-associated common complications. Therefore, the purpose of this study was to evaluate the effects of shear stress on cells and proteins in bovine, ovine, and porcine blood compared to human. Blood from different species was subjected to various shear rates (0-8000/s) using a rheometer. It was then analyzed for complete blood counts, hemolysis by the Harboe assay, platelet activation by flow cytometry, vWF structure by immunoblotting, and function by collagen binding activity ELISA (vWF : CBA). Overall, increasing shear rate caused increased total blood trauma in all tested species. This analysis revealed species-specific differences in shear-induced hemolysis, platelet activation, and vWF structure and function. Compared to human blood, porcine blood was the most resilient and showed less hemolysis, similar blood counts, but less platelet activation and less vWF damage in response to shear. Compared to human blood, sheared bovine blood showed less hemolysis, similar blood cell counts, greater platelet activation, and similar degradation of vWF structure, but less impact on its activity in response to shear. The shear-induced effect on ovine blood depended on whether the blood was collected via gravity at the abattoir or by venepuncture from live sheep. Overall, ovine abattoir blood was the least resilient in response to shear and bovine blood was the most similar to human blood. These results lay the foundations for developing blood trauma evaluation standards to enable the extrapolation of in vitro and in vivo animal data to predict safety and biocompatibility of blood-handling medical devices in humans. We advise using ovine venepuncture blood instead of ovine abattoir blood due to the greater overall damage in the latter. We propose using bovine blood for total blood damage in vitro device evaluation but multiple species could be used to create a full understanding of the complication risk profile of new devices. Further, this study highlights that choice of antibody clone for evaluating platelet activation in bovine blood can influence the interpretation of results from different studies.

Background Extracorporeal membrane oxygenation (ECMO) is a life-saving modality used to manage cardiopulmonary failure refractory to conventional medical and surgical therapies. Despite advances in ECMO equipment, bleeding and thrombosis remain significant complications. While the flow rate for ECMO support is well recognized, less is known about the minimum-rate requirements and haemostasis. We investigated the relationship between different ECMO flow rates, and their effect on haemolysis and coagulation. Methods Ten ex-vivo ECMO circuits were tested using donated, < 24-h-old human whole blood, with two flow rates: high-flow at 4 L/min (normal adult cardiac output; n = 5) and low-flow at 1.5 L/min (weaning; n = 5). Serial blood samples were taken for analysis of haemolysis, von Willebrand factor (vWF) multimers by immunoblotting, rotational thromboelastometry, platelet aggregometry, flow cytometry and routine coagulation laboratory tests. Results Low-flow rates increased haemolysis after 2 h ( p = 0.02), 4 h ( p = 0.02) and 6 h ( p = 0.02) and the loss of high-molecular-weight vWF multimers ( p = 0.01), while reducing ristocetin-induced platelet aggregation ( p = 0.0002). Additionally, clot formation times were prolonged ( p = 0.006), with a corresponding decrease in maximum clot firmness ( p = 0.006). Conclusions In an ex-vivo model of ECMO, low-flow rate (1.5 L/min) altered haemostatic parameters compared to high-flow (4 L/min). Observed differences in haemolysis, ristocetin-induced platelet aggregation, high-molecular-weight vWF multimers and clot formation time suggest an increased risk of bleeding complications. Since patients are often on ECMO for protracted periods, extended-duration studies are required to characterise long-term ECMO-induced haemostatic changes.

Infection is a clinically relevant adverse event in patients with ventricular assist device (VAD) support. The risk of infection could be linked to a reduced immune response resulting from damage to leukocytes during VAD support. The purpose of this study was to develop an understanding of leukocyte responses during the in vitro testing of VADs by analyzing the changes to their morphology and biochemistry. The VentrAssist implantable rotary blood pump (IRBP) and RotaFlow centrifugal pump (CP) were tested in vitro under constant hemodynamic conditions. Automated hematology analysis of samples collected regularly over 25-h tests was undertaken. A new flow cytometric assay was employed to measure biochemical alteration, necrosis (7-AAD) and morphological alteration (CD45 expression) of the circulating leukocytes during the pumping process. The results of hematology analysis show the total leukocyte number and subset counts decreased over the period of in vitro tests dependent on different blood pumps. The percentage of leukocytes damaged during 6-h tests was 40.8 ± 5.7% for the VentrAssist IRBP, 17.6 ± 5.4% for the RotaFlow CP, and 2.7 ± 1.8% for the static control (all n=5). Flow cytometric monitoring of CD45 expression and forward/side scatter characteristics revealed leukocytes that were fragmented into smaller pieces (microparticles). Scanning electron microscopy and imaging flow cytometry were used to confirm this. Device developers could use these robust cellular assays to gain a better understanding of leukocyte-specific VAD performance.

Extracorporeal membrane oxygenation (ECMO) is used in critical care to manage patients with severe respiratory and cardiac failure. ECMO brings blood from a critically ill patient into contact with a non-endothelialized circuit which can cause clotting and bleeding simultaneously in this population. Continuous systemic anticoagulation is needed during ECMO. The membrane oxygenator, which is a critical component of the extracorporeal circuit, is prone to significant thrombus formation due to its large surface area and areas of low, turbulent, and stagnant flow. Various surface coatings, including but not limited to heparin, albumin, poly­(ethylene glycol), phosphorylcholine, and poly­(2-methoxyethyl acrylate), have been developed to reduce thrombus formation during ECMO. The present work provides an up-to-date overview of anti-thrombogenic surface coatings for ECMO, including both commercial coatings and those under development. The focus is placed on the coatings being developed for oxygenators. Overall, zwitterionic polymer coatings, nitric oxide (NO)-releasing coatings, and lubricant-infused coatings have attracted more attention than other coatings and showed some improvement in in vitro and in vivo anti-thrombogenic effects. However, most studies lacked standard hemocompatibility assessment and comparison studies with current clinically used coatings, either heparin coatings or nonheparin coatings. Moreover, this review identifies that further investigation on the thrombo-resistance, stability and durability of coatings under rated flow conditions and the effects of coatings on the function of oxygenators (pressure drop and gas transfer) are needed. Therefore, extensive further development is required before these new coatings can be used in the clinic.

Clinical outcomes from ventricular assist devices (VADs) have improved significantly during recent decades, but bleeding episodes remain a common complication of long-term VAD usage. Greater understanding of the effect of the shear stress in the VAD on platelet aggregation, which is influenced by the functional activity of high molecular weight (HMW) von Willebrand factor (vWF), could provide insight into these bleeding complications. However, because VAD shear rates are difficult to assess, there is a need for a model that enables controlled shear rates to first establish the relationship between shear rates and vWF damage. Secondly, if such a dependency exists, then it is relevant to establish a rapid and quantitative assay that can be used routinely for the safety assessment of new VADs in development. Therefore, the purpose of this study was to exert vWF to controlled levels of shear using a rheometer, and flow cytometry was used to investigate the shear-dependent effect on the functional activity of vWF. Human platelet-poor plasma (PPP) was subjected to different shear rate levels ranging from 0 to 8000/s for a period of 6 h using a rheometer. A simple and rapid flow cytometric assay was used to determine platelet aggregation in the presence of ristocetin cofactor as a readout for vWF activity. Platelet aggregates were visualized by confocal microscopy. Multimers of vWF were detected using gel electrophoresis and immunoblotting. The longer PPP was exposed to high shear, the greater the loss of HMW vWF multimers, and the lower the functional activity of vWF for platelet aggregation. Confocal microscopy revealed for the first time that platelet aggregates were smaller and more dispersed in postsheared PPP compared with nonsheared PPP. The loss of HMW vWF in postsheared PPP was demonstrated by immunoblotting. Smaller vWF platelet aggregates formed in response to shear stress might be a cause of bleeding in patients implanted with VADs. The methodological approaches used herein could be useful in the design of safer VADs and other blood handling devices. In particular, we have demonstrated a correlation between the loss of HMW vWF, analyzed by immunoblotting, with platelet aggregation, assessed by flow cytometry. This suggests that flow cytometry could replace conventional immunoblotting as a simple and rapid routine test for HMW vWF loss during in vitro testing of devices.

Background: Extracorporeal membrane oxygenation is a life-saving support for heart and/or lung failure patients. Despite technological advancement, abnormal physiology persists and has been associated with subsequent adverse events. These include thrombosis, bleeding, systemic inflammatory response syndrome and infection. However, the underlying mechanisms are yet to be elucidated. We aimed to investigate whether the different flow dynamics of extracorporeal membrane oxygenation would alter immune responses, specifically the overall inflammatory response, leukocyte numbers and activation/adhesion surface antigen expression. Methods: An ex vivo model was used with human whole blood circulating at 37°C for 6 hours at high (4 L/minute) or low (1.5 L/minute) flow dynamics, with serial blood samples taken for analysis. Results: During high flow, production of interleukin-1β (p < 0.0001), interleukin-6 (p = 0.0075), tumour necrosis factor-α (p = 0.0013), myeloperoxidase (p < 0.0001) and neutrophil elastase (p < 0.0001) were significantly elevated over time compared to low flow, in particular at 6 hours. While the remaining assessments exhibited minute changes between flow dynamics, a consistent trend of modulation in leukocyte subset numbers and phenotype was observed at 6 hours. Conclusion: We conclude that prolonged circulation at high flow triggers a prominent pro-inflammatory cytokine response and activates neutrophil granule release, but further research is needed to better characterize the effect of flow during extracorporeal membrane oxygenation.

The Harboe spectrophotometric assay is regarded as one of the safest and most reproducible methods for measuring plasma free hemoglobin (pfHb). However, there is still some ambiguity in the application of the assay when assessing the hemolytic performance of ventricular assist devices (VADs). The purpose of this study was to reexamine and compare values of pfHb obtained using different concentrations of plasma diluent (Na(2) CO(3) ) as cited by various studies such that a standard practice may be recommended for the application of the Harboe assay in the hemolytic evaluation of VADs, allowing reliable comparisons to be made between laboratories. As a means to examine the Harboe assay, a BioMedicus BPX-80 was tested using both whole blood and a washed suspension of red blood cells (RBCs). Results show that for whole blood, the pfHb may be underestimated by 13-23%, dependent upon the concentration of Na(2) CO(3) diluent solution. This trend was not observed for the washed suspension of RBCs. Furthermore, it is shown that the concentration of diluent influences the stability of a sample. The results of this study show that the problems associated with the incongruity of pfHb readings are a direct result of the precipitation of proteins from the plasma under alkaline conditions; as the molarity of the diluent controls pH, it becomes essential to use the appropriate concentration of Na(2) CO(3) diluent in order to avoid turbidity of the solution and the consequent misrepresentation of pfHb values. Such standardization is pertinent when measuring the very low levels of pfHb observed during the in vivo testing of modern ventricular assist devices.