Pim-1 kinase is a member of a distinct class of serine/ threonine kinases consisting of Pim-1, Pim-2, and Pim-3. Pim kinases are highly homologous to one another and share a unique consensus hinge region sequence, ER-PXPX, with its two proline residues separated by a nonconserved residue, but they (Pim kinases) have <30% sequence identity with other kinases. Pim-1 has been implicated in both cytokine-induced signal transduction and the development of lymphoid malignancies. We have determined the crystal structures of apo Pim-1 kinase and its AMP-PNP (5-adenylyl-␤,␥-imidodiphosphate) complex to 2.1-Å resolutions. The structures reveal the following. 1) The kinase adopts a constitutively active conformation, and extensive hydrophobic and hydrogen bond interactions between the activation loop and the catalytic loop might be the structural basis for maintaining such a conformation. 2) The hinge region has a novel architecture and hydrogen-bonding pattern, which not only expand the ATP pocket but also serve to establish unambiguously the alignment of the Pim-1 hinge region with that of other kinases. 3) The binding mode of AMP-PNP to Pim-1 kinase is unique and does not involve a critical hinge region hydrogen bond interaction. Analysis of the reported Pim-1 kinase-domain structures leads to a hypothesis as to how Pim kinase activity might be regulated in vivo.

The rate coefficients for activation (ka0 app) of two alkyl halides, methyl 2-bromopropionate, MBrP, and Brcapped\ud poly(methyl acrylate), by Cu0 were determined under various conditions. The value of ka0 app was studied in two solvents, dimethyl sulfoxide (DMSO) and acetonitrile (MeCN), and their mixtures with methyl acrylate (MA), using tris[2-(dimethylami no)ethyl]amine (Me6TREN) and tris(2-pyridylmethyl)amine (TPMA) as ligands. The experiments showed that the rate of activation increased with the surface area of Cu0 but was typically not affected by the ratio of ligand to initiator, if a sufficient amount of ligand was present. The choice of solvent and presence of monomer/polymer had a small influence on ka0 app. The activation rate coefficient of MBrP was ka0 app= 1.8 × 10−4 cm s−1 with Me6TREN as the ligand in DMSO at 25 °C while the activation rate coefficient of Br-capped poly(methyl acrylate) by Cu0 was slightly lower, ka0 app = 1.0 × 10−4 cm s−1, as measured in a polymerization of MA in MA/DMSO = 1/1 (v/v) with Me6TREN. On the basis of the measured rate coefficients, the activation rate of MBrP by 1 mM CuIBr/Me6TREN (ka1app = 3.2 × 102 M−1 s−1) is similar to the activation rate by 2 km Cu0 wire with diameter of 0.25 mm in 7 mL of DMSO. Thus, under typical conditions, conducted in the presence of ca. 1 cm Cu0 wire, alkyl halides are predominantly activated by CuI species. Consequently, Cu0 acts as a supplemental activator\ud and also as a reducing agent (SARA) because comproportionation dominates disproportionation, for the polymerization of MA in DMSO. These results support the SARA ATRP mechanism rather than the proposed single electron transfer−living radical polymerization (SET-LRP) process, which requires exclusive activation by Cu0 and instantaneous disproportionation of CuI

Glycoprotein D (gD) is a structural component of the herpes simplex virus (HSV) envelope which is essential for virus entry into host cells. Chinese hamster ovary (CHO-K1) cells are one of the few cell types which are nonpermissive for the entry of many HSV strains. However, when these cells are transformed with the gene for the herpesvirus entry mediator (HVEM), the resulting cells, CHO-HVEM12, are permissive for many HSV strains, such as HSV-1(KOS). By virtue of its four cysteine-rich pseudorepeats, HVEM is a member of the tumor necrosis factor receptor superfamily of proteins. Recombinant forms of gD and HVEM, gD-1(306t) and HVEM(200t), respectively, were used to demonstrate a specific physical interaction between these two proteins. This interaction was dependent on native gD conformation but independent of its N-linked oligosaccharides, as expected from previous structure-function studies. Recombinant forms of gD derived from HSV-1(KOS)rid1 and HSV-1(ANG) did not bind to HVEM(200t), explaining the inability of these viruses to infect CHO-HVEM12 cells. A variant gD protein, gD-1(⌬290-299t), showed enhanced binding to HVEM(200t) relative to the binding of gD-1(306t). Competition studies showed that gD-1(⌬290-299t) and gD-1(306t) bound to the same region of HVEM(200t), suggesting that the differences in binding to HVEM are due to differences in affinity. These differences were also reflected in the ability of gD-1(⌬290-299t) but not gD-1(306t) to block HSV type 1 infection of CHO-HVEM12 cells. By gel filtration chromatography, the complex between gD-1(⌬290-299t) and HVEM(200t) had a molecular mass of 113 kDa and a molar ratio of 1:2. We conclude that HVEM interacts directly with gD, suggesting that HVEM is a receptor for virion gD and that the interaction between these proteins is a step in HSV entry into HVEM-expressing cells.

This article is the first in a series of papers, describing reversible-deactivation radical polymerization (RDRP) in the presence of metallic copper. The aim of these papers is to determine the proportions and roles of Cu0, CuIBr/L, and CuIIBr2/L, and the overall reaction mechanism. This paper is focused on the comproportionation and disproportionation equilibrium between Cu0, CuIBr/L and CuIIBr2/L in dimethyl sulfoxide (DMSO) for various surface areas of Cu0 and different ligand concentrations, in both the absence and presence of methyl acrylate (MA). Comproportionation dominated disproportionation when there was enough ligand present in the reaction medium to stabilize all soluble copper species. The relative amount of CuI at comproportionation/disproportionation equilibrium increased with ligand concentration. CuI represents approximately 99.95% of all soluble Cu species in MA/DMSO = 2/1 (v/v) at the ratio [Me6TREN]0:[CuIIBr2]0 = 6:1. Under typical polymerization conditions, there is essentially no disproportionation, since the ratio [Me6TREN]:[CuII] is very large, starting from infinity and decreasing down to 6.7, for ∼3% terminated chains under the initial conditions [MA]0:[MBrP]0:[Me6TREN]0 = 222:1:0.1, in 33.3% (v/v) DMSO, with excess Cu0. The kinetics of comproportionation and disproportionation were both slow, requiring hours to reach equilibrium. The apparent rate coefficients for comproportionation and disproportionation were calculated as k comp app = 9.0 × 10–4 cm s–1 and k disp app = 2.0 × 10–5 cm s–1 in DMSO, as well as 3.5 × 10–3 cm s–1 and 3.1 × 10–6 cm s–1 in MA/DMSO = 2/1 (v/v), respectively. The results of this study invalidate the assumption of instantaneous and complete disproportionation, proposed in single-electron transfer living radical polymerization (SET-LRP). These findings agree with Cu0 acting as a supplemental activator and reducing agent in atom transfer radical polymerization (SARA ATRP).

The kinetics of copper-mediated controlled/ living radical polymerization (CRP) of methyl acrylate (MA) in the presence of Cu 0 and two different ligands that form active catalyst complexes with copperTPMA (tris(2-pyridylmethyl)amine) and Me 6 TREN (tris(2-(dimethylamino)ethyl)amine) are compared. The critical difference between the ligands is that TPMA forms a Cu I complex that undergoes essentially no disproportionation in a mixture of MA and dimethyl sulfoxide (DMSO), DMSO/MA (v/v = 1/2), while the complex with Me 6 TREN undergoes disproportionation to a limited extent. Parameters such as the surface area of Cu 0 wire, the concentration of added Cu II X 2 /L, and ligand concentration were examined. Both the Me 6 TREN-and TPMA-based catalysts efficiently controlled the polymerization of MA. The TPMA-based system showed a power law order of 0.47 for the apparent propagation rate constant with the Cu 0 surface area, very similar to the reported value for the Me 6 TREN-based system, which showed a power law of 0.44. These results demonstrate that the polymerization of MA in DMSO in the presence of metallic copper can be explained by a core atom-transfer radical polymerization (ATRP) process in which the Cu 0 acts as a supplemental activator and reducing agent, rather than through the proposed single-electron-transfer living radical polymerization (SET-LRP) mechanism, which requires additional assumptions, such as complete and instantaneous disproportionation of Cu I /L species.