Noninvasive continuous blood pressure (BP) monitoring is not yet practically available for daily use. Challenges include making the system easily wearable, reducing noise level and improving accuracy. Variations in each person's physical characteristics, as well as the possibility of different postures, increase the complexity of continuous BP monitoring, especially outside the hospital. This study attempts to provide an easily wearable solution and proposes training to specific posture and individual for further improving accuracy. The wrist watch-based system we developed can measure electrocardiogram and photoplethysmogram. From these two signals, we measure pulse transit time through which we can obtain systolic and diastolic blood pressure through regression techniques. In this study, we investigate various functions to perform the training to obtain blood pressure. We validate measurements on different postures and subjects, and show the value of training the device to each posture and each subject. We observed that the average RMSE between the measured actual systolic BP and calculated systolic BP is between 7.83 to 9.37 mmHg across 11 subjects. The corresponding range of error for diastolic BP is 5.77 to 6.90 mmHg. The system can also automatically detect the arm position of the user using an accelerometer with an average accuracy of 98%, to make sure that the sensor is kept at the proper height. This system, called BioWatch, can potentially be a unified solution for heart rate, SPO2 and continuous BP monitoring.
Heart rate tracking from a wrist-type photoplethysmogram (PPG) signal during intensive physical activities is a challenge that is attracting more attention thanks to the introduction of wrist-worn wearable computers. Commonly-used motion artifact rejection methods coupled with simple periodicity-based heart rate estimation techniques are incapable of achieving satisfactory heart rate tracking performance during intense activities. In this paper, we propose a two-stage solution. Firstly, we introduce an improved spectral subtraction method to reject the spectral components of motion artifacts. Secondly, instead of using heuristic mechanisms, we formalize the spectral peaks selection process as the shortest path search problem and validate its effectiveness. Analysis on the experimental results based on a published database shows that: (1) Our proposed method outperforms three other comparable methods with regards to heart rate estimation error. (2) The proposed method is a promising candidate for both offline cardiac health analysis and online heart rate tracking in daily life, even during intensive physical motions.
A wrist watch based system, which can measure electrocardiogram (ECG) and photoplethysmogram (PPG), is presented in this work. By using both ECG and PPG we also measure pulse transit time (PTT), which studies show to correlate well with blood pressure (BP). The system is also capable of monitoring heart rate using either ECG or PPG and can monitor blood oxygenation by easily replacing the PPG sensors with a different set. In this work, we investigate methods to train a fitting function to convert a PTT measurement to its corresponding systolic BP. We also validate measurements on different postures and show the value of calibrating the device for each posture. This system, called BioWatch, can potentially facilitate continuous and ubiquitous monitoring of ECG, PPG, heart rate, blood oxygenation and BP.
A mobile, easy to use, wireless dry contact EEG acquisition system is presented in this work. This system can potentially facilitate continuous in-home monitoring of electroencephalography (EEG) to diagnose ailments such as epilepsy. The system has also been validated with brain computer interface (BCI) paradigms that would enable physically disabled users to communicate.
Steady-state visual evoked potential (SSVEP) has become one of the most widely employed modalities in online brain computer interface (BCI) because of its high signal-to-noise ratio. However, due to the limitations of brain physiology and the refresh rate of the display devices, the available stimulation frequencies that evoke strong SSVEPs are generally limited for practical applications. In this paper, we introduce a novel stimulation method using patterns of time-varying frequencies that can increase the number of visual stimuli with a fixed number of stimulation frequencies for use in multi-class SSVEP-based BCI systems. We then propose a probabilistic framework and investigate three approaches to detect different patterns of time-varying frequencies. The results confirmed that our proposed stimulation is a promising method for multi-class SSVEP-based BCI tasks. Our pattern detection approaches improved the detection performance significantly by extracting higher quality discriminative information from the input signal.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.