A new electrocatalyst, palladium nanoparticle-single-walled carbon nanotube (Pd-SWNTs) hybrid nanostructure, for the nonenzymatic oxidation of glucose was developed and characterized by X-ray diffraction (XRD) and the transmission electron microscope (TEM). The hybrid nanostructures were prepared by depositing palladium nanoparticles with average diameters of 4-5 nm on the surface of single-walled carbon nanotubes (SWNTs) via chemical reduction of the precursor (Pd(2+)). The electrocatalyst showed good electrocatalytic activity toward the oxidation of glucose in the neutral phosphate buffer solution (PBS, pH 7.4) even in the presence of a high concentration of chloride ions. A nonenzymatic amperometric glucose sensor was developed with the use of the Pd-SWNT nanostructure as an electrocatalyst. The sensor had good electrocatalytic activity toward oxidation of glucose and exhibited a rapid response (ca.3 s), a low detection limit (0.2 +/- 0.05 microM), a wide and useful linear range (0.5-17 mM), and high sensitivity (approximately 160 microA mM(-1) cm(-2)) as well as good stability and repeatability. In addition, the common interfering species, such as ascorbic acid, uric acid, 4-acetamidophenol, 3,4-dihydroxyphenylacetic acid, and so forth did not cause any interference due to the use of a low detection potential (-0.35 V vs SCE). The sensor can also be used for quantification of the concentration of glucose in real clinical samples. Therefore, this work has demonstrated a simple and effective sensing platform for nonenzymatic detection of glucose.

Single-atom-sized catalysts (often called single atom catalysts) are highly desired for maximizing the efficiency of metal atom use. However, their synthesis is a major challenge that largely depends on finding an appropriate supporting substrate to achieve a well-defined and highly dispersed single atom. This work demonstrates, based on density functional theory (DFT) predictions and experimental validations, that graphdiyne is a good substrate for anchoring Fe atoms through the formation of covalent Fe–C bonds to produce graphdiyne-supported single-atom-sized Fe catalysts (Fe–graphdiyne catalysts); moreover, this catalyst shows high catalytic activity to oxygen reduction reactions (ORRs) similar to or even slightly better than the precious metal benchmark (commercial 20 wt % Pt/C catalyst). DFT predicts that the O2 molecule can bind with an Fe atom, and the electron transformation process of ORRs occurs through a 4e– pathway. To validate the theoretical predictions, the Fe–graphdiyne catalyst was then synthesized by a reduction of Fe3+ ions adsorbed on a graphdiyne surface in aqueous solution, and its electrocatalytic activities toward ORR were experimentally evaluated in alkaline electrolytes (0.1 M KOH). The electrochemical measurements indicate that the Fe–graphdiyne catalyst can facilitate the 4e– ORR while limiting the 2e– transfer reaction, showing a high 4e– selectivity for ORRs and a good agreement with DFT predictions. The results presented here demonstrate that graphdiyne can provide a unique platform for synthesizing well-defined and uniform single-atom-sized metal catalysts with high catalytic activity toward ORRs.

No abstract

The burgeoning demand for clean and energy-efficient fuel cell system requires electrocatalysts to deliver greater activity and selectivity. Bimetallic catalysts have proven superior to single metal catalysts in this respect. This work reports the preparation, characterization, and electrocatalytic characteristics of a new bimetallic nanocatalyst. The catalyst, Pt-Au-graphene, was synthesized by electrodeposition of Pt-Au nanostructures on the surface of graphene sheets, and characterized by scanning electron microscopy (SEM), energy-dispersive spectroscopy (EDS), X-ray powder diffraction (XRD), and voltammetry. The morphology and composition of the nanocatalyst can be easily controlled by adjusting the molar ratio between Pt and Au precursors. The electrocatalytic characteristics of the nanocatalysts for the oxygen reduction reaction (ORR) and the methanol oxidation reaction (MOR) were systematically investigated by cyclic voltammetry. The Pt-Au-graphene catalysts exhibits higher catalytic activity than Au-graphene and Pt-graphene catalysts for both the ORR and the MOR, and the highest activity is obtained at a Pt/Au molar ratio of 2:1. Moreover, graphene can significantly enhance the long-term stability of the nanocatalyst toward the MOR by effectively removing the accumulated carbonaceous species formed in the oxidation of methanol from the surface of the catalyst. Therefore, this work has demonstrated that a higher performance of ORR and the MOR could be realized at the Pt-Au-graphene electrocatalyst while Pt utilization also could be greatly diminished. This method may open a general approach for the morphology-controlled synthesis of bimetallic Pt-M nanocatalysts, which can be expected to have promising applications in fuel cells.

No abstract

We report a density functional theory (DFT) study of microscopic detailed effects of the bonding configuration of nitrogen-doped graphene (N-graphene) within the carbon lattice (including pyridinic, pyrrolic, and graphitic N) on the reactivity and mechanistic processes of H2O2 reduction reaction. We simulated the adsorption process of H2O2, analyzed the mechanistic processes, and calculated the reversible potential of each reaction step of the H2O2 reduction reaction on N-graphene. The results indicate that the adsorption of H2O2 on the pristine and N-doped graphene surfaces occurs via physisorption without the formation of a chemical bond. When H(+) is introduced into the system, a series of reactions can occur, including the breakage of the O-O bond, the formation of an O-C chemical bond between oxygen and graphene, and the creation of water molecules. The results also indicate a decrease in the energy of the system and a positive reversible potential for each reaction step. The calculations of the relative energy of each reaction step and the value of the onset potential for H2O2 reduction reaction suggest that the reactivity of pristine and N-doped graphene has the following order: pyridinic N-graphene > pyrrolic N-graphene > graphitic N-graphene > pristine graphene. We also proposed an explanation based on electrostatic potential calculations for this dependence of the reactivity order on the bond configuration of the doping in N-graphene. The results of this study should help in the atomic-scale understanding of the dependence of the reactivity of N-graphene on its microstructure, inspire the study of various types of heteroatom-doped graphenes to improve their catalytic efficiency, and provide a theoretical framework to analyze their reactivities.

Three-dimensional Pd@Pt core−shell nanostructures with controllable shape and composition were synthesized by using a one-step microwave heating method. The nanostructures with the morphology, structure, and composition being easily controlled through adjusting the molar ratio between Pt and Pd precursor were characterized by transmission electronic microscopy (TEM), scanning electronic microscopy (SEM), X-ray powder diffraction (XRD), and energy-dispersive X-ray (EDX) techniques. In addition, the electrocatalytic characteristics of these prepared Pd@Pt electrocatalysts with different Pd/Pt molar ratio for oxygen electro-reduction reaction (ORR) and methanol electro-oxidation reaction (MOR) were systematically investigated by voltammetry. The results show that Pd@Pt electrocatalysts exhibit higher catalytic activity than pure Pd and pure Pt catalysts for both the ORR and MOR, and the highest activity is obtained at the Pd@Pt electrocatalyst with a Pd/Pt molar ratio of 1:3. This result demonstrates that a higher performance of ORR and MOR could be realized at the novel core−shell electrocatalyst while Pt utilization also could be diminished. This method may open a general approach for the shape-controlled synthesis of bimetallic Pt−M nanocatalysts, which can be expected to have promising applications in fuel cells.

Graphyne, a new two-dimensional periodic carbon allotrope with a one-atom-thick sheet of carbon built from triple-and double-bonded units of two sp-and sp 2hybridized carbon atoms, has been shown in recent studies to have the potential for high-density hydrogen and lithium storage. We report here a density functional theory (DFT) study of an oxygen reduction reaction (ORR) involving graphyne and demonstrate that graphyne is a good, metal-free electrocatalyst for ORRs in acidic fuel cells. We optimized the geometrical structure, calculated the charge densities on each carbon atom in the graphyne, and simulated each step of the ORR reaction involving graphyne. The simulation results indicate that the distribution of the charge density at each carbon atom on the graphyne plane is not uniform and that a large number of positively charged carbon atoms, which are beneficial to the adsorption of O 2 and OOH + molecules, can behave as catalytic sites to facilitate ORRs. When H + is introduced into the system, a series of reactions can occur including the formation of an O−C chemical bond between oxygen and graphyne, breakage of the O−O bond, and the creation of water molecules. The results also indicate a decrease in the energy of the system and a positive value of the reversible potential for each reaction step on the graphyne surface. In addition, a spontaneous electron transformation process occurs during the ORR along a four-electron pathway. The results presented here should lead to an improvement in the catalytic efficiency of carbon nanomaterials and provide a theoretical framework for the analysis of their catalytic activity. This paper highlights the urgent need for new experimental syntheses for graphyne.