Phase-matched harmonic conversion of visible laser light into soft x-rays was demonstrated. The recently developed technique of guided-wave frequency conversion was used to upshift light from 800 nanometers to the range from 17 to 32 nanometers. This process increased the coherent x-ray output by factors of 10(2) to 10(3) compared to the non-phase-matched case. This source uses a small-scale (sub-millijoule) high repetition-rate laser and will enable a wide variety of new experimental investigations in linear and nonlinear x-ray science.

In this article, we review progress in the development of high peak-power ultrafast lasers, and discuss in detail the design issues which determine the performance of these systems. Presently, lasers capable of generating terawatt peak powers with unprecedented short pulse duration can now be built on a single optical table in a small-scale laboratory, while large-scale lasers can generate peak power of over a petawatt. This progress is made possible by the use of the chirped-pulse amplification technique, combined with the use of broad-bandwidth laser materials such as Ti:sapphire, and the development of techniques for generating and propagating very short ͑10-30 fs͒ duration light pulses. We also briefly summarize some of the new scientific advances made possible by this technology, such as the generation of coherent femtosecond x-ray pulses, and the generation of MeV-energy electron beams and high-energy ions.

No abstract

No abstract

We generate angularly isolated beams of circularly polarized extreme ultraviolet light through the first implementation of non-collinear high harmonic generation with circularly polarized driving lasers. This non-collinear technique offers numerous advantages over previous methods, including the generation of higher photon energies, the separation of the harmonics from the pump beam, the production of both left and right circularly polarized harmonics at the same wavelength and the capability of separating the harmonics without using a spectrometer. To confirm the circular polarization of the beams and to demonstrate the practicality of this new light source, we measure the magnetic circular dichroism of a 20 nm iron film. Furthermore, we explain the mechanisms of non-collinear high harmonic generation using analytical descriptions in both the photon and wave models. Advanced numerical simulations indicate that this non-collinear mixing enables the generation of isolated attosecond pulses with circular polarization.

No abstract

By use of the recently developed technique of guided-wave frequency conversion, the generation of sub-10-fs light pulses in the UV has been demonstrated for what is believed to be the first time. Cross-phase modulation of the light in a hollow waveguide produced a bandwidth of 16 nm, with a center frequency of 270 nm, at 1 kHz. A simple grating pair was used to compress the pulses to a duration of 8 fs, as measured by self-diffraction frequency-resolved optical gating. In the experiment the compressed energy was greater than 1 muJ , with a peak power of >100 MW ; the technique can be scaled to higher energy. Further improvements should make it possible to generate pulses as short as approximately 3 fs with this technique.

We present what is believed to be the first experimental demonstration of guided-wave phase-matched frequency mixing and harmonic conversion in gases. Broad-bandwidth ultrafast pulses, tunable around 270 nm, were generated from an ultrafast Ti:sapphire amplifier system using 2? + 2? - ? parametric wave mixing in a capillary waveguide. We achieved nonresonant phase matching by coupling both the fundamental and the second-harmonic light into the lowest-order mode. The output 3? pulses have an energy of >4muJ at a 1-kHz repetition rate. Simple extensions of this method can generate higher-energy 10-20-fs pulses tunable throughout the vacuum ultraviolet.