No abstract

No abstract

Concern about the depletion of petroleum reserves, rising prices of conventional fuels, security of supply and global warming have driven research toward the development of renewable fuels for use in diesel engines. These fuels have different physical and chemical properties that affect the diesel combustion process. This paper compares between the autoignition, combustion, performance and emissions of soy-bean derived biodiesel, Jet propellant (JP-8) and ultra low sulfur diesel (ULSD) in a high speed single-cylinder research diesel engine equipped with a common rail injection system. Tests were conducted at steady state conditions at different injection pressures ranging from 600 bar to 1200 bar. The ‘rate of heat release’ traces are analyzed to determine the effect of fuel properties on the ignition delay, premixed combustion fraction and mixing and diffusion controlled combustion fractions. Biodiesel produced the largest diffusion controlled combustion fraction at all injection pressures compared to ULSD and JP-8. At 600 bar injection pressure, the diffusion controlled combustion fraction for biodiesel was 53% whereas both JP-8 and ULSD produced 39%. In addition, the effect of fuel properties on engine performance, fuel economy, and engine-out emissions is determined. On an average JP-8 produced 3% higher thermal efficiency than ULSD. Special attention is given to the oxides of nitrogen (NOx) emissions and particulate matter characteristics. On an average biodiesel produced 37% less NOx emissions compared to ULSD and JP-8.

This paper investigates the effect of air inlet temperature on the auto-ignition of fuels that have different CN and volatility in a single cylinder diesel engine. The inlet air temperature is varied over a range of 30°C to 110°C. The fuels used are ultra-low-sulfur-diesel (ULSD), JP-8 (two blends with CN 44.1 & 31) and F-T SPK. Detailed analysis is made of the rate of heat release during the ignition delay period, to determine the effect of fuel volatility and CN on the auto-ignition process. A STAR-CD CFD model is applied to simulate the spray behavior and gain more insight into the processes that immediately follow the fuel injection including evaporation, start of exothermic reactions and the early stages of combustion. The mole fractions of different species are determined during the ignition delay period and their contribution in the auto-ignition process is examined. Arrhenius plots are developed to calculate the global activation energy for the auto-ignition reactions of these fuels. Correlations are developed for the ID and the mean air temperature and pressure.

JP-8 is being closely watched as a suitable fuel for the “One fuel policy” by US Army. Some of the main targets of Army in the battle are the fuel economy and smoke/soot emissions. Soot emissions can be reduced in two ways, by increasing the injection pressure or by increasing swirl. An investigation was conducted to find out the more effective way to reduce soot emissions and to evaluate the influence of the swirl motion on JP-8 fuel combustion, performance and emissions in a single cylinder diesel engine. Increasing swirl increased heat losses and produced lower temperatures during injection process. Increasing swirl improved the premixed combustion fraction and produced higher peak temperatures and in turn increased NOx emissions. Increasing swirl also increased the nano-particle emissions.