Photopolymerization behavior of a methacryloxypropyl-terminated polydimethylsiloxane (MAT-PDMS) healing agent was investigated in the presence of benzoin isobutyl ether (BIE) photoinitiator by Fourier transform infrared (FT-IR) spectroscopy. MAT-PDMS and BIE were microencapsulated with urea-formaldehyde polymer. The surface and shell morphology of the microcapsules was investigated by scanning electron microscopy (SEM). Mean diameter and size distribution of the microcapsules could be controlled by agitation rate. A coating matrix formulation was prepared by sol-gel reaction of tetraethyl orthosilicate (TEOS) in the presence of a polysiloxane and by subsequent addition of an adhesion promoter. The formulation and microcapsules were mixed to give a self-healing coating formulation, which was then sprayed to surface of cellulose-fiber-reinforced-cement (CRC) board or mortar. Contact angle measurements showed that both the polymerized MAT-PDMS and the prepared coating matrix are hydrophobic, and the coating matrix has good wettability with MAT-PDMS. It was confirmed by optical microscopy and SEM that, when the self-healing coating is damaged, the healing agent is released from ruptured microcapsules and fills the damaged region. The self-healing coating was evaluated as protective coating for mortar, and it was demonstrated by water permeability and chloride ion penetration tests that our system has sunlight-induced self-healing capability. Our self-healing coating is the first example of capsule-type photoinduced self-healing system, and offers the advantages of catalyst-free, environmentally friendly, inexpensive, practical healing.
Conventional synthesis of polyimides includes hightemperature (160-350 8C) imidization of poly(amic acid)s. In the present work, imidization has been carried out at much lower temperatures (40-160 8C). 1,2,4,5,-cyclohexanetetracarboxylic dianhydride (HPMDA) or pyromellitic dianhydride (PMDA) was polymerized with an aromatic diamine, 4,4 0 -diaminodiphenylmethane (DDPM), to give poly(amic acid)s, which were then imidized chemically. Imidization was more than 90% complete even at the very low imidization temperature of 40 8C. It was found that the imidization occurs in two steps: an initial rapid cyclization and a subsequent slower cyclization. The activation energy for the rapid process was determined to be 4.3 kJ/mol, and that of the slower process, 4.8 kJ/mol. As the imidization temperature decreases, the transmittance of the resulting polyimides tends to gradually increase, the cutoff wavelength decreases and the color becomes pale. A partially aliphatic polyimide based on HPMDA and DDPM prepared at 40 8C yielded thin films that were highly transparent and colorless, and had good flexibility, solubility and thermal stability. The polyimide films prepared in this study may be good candidates for flexible, transparent plastic substrates in the display industry.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.