PALS results show a bimodal pore size distribution for a spirobisindane polymer, with the majority of pores being of the larger size. Gas permeability, density and PALS results suggest the polymer undergoes physical aging during permeability testing. PALS results also show that solution processing generates extra free volume above the intrinsic free volume of the precipitated polymer.

Trialkyl and aryl organoboranes catalyze the polymerization of dimethylsulfoxonium methylide (1). The product of the polymerization is a tris-polymethylene organoborane. Oxidation affords linear telechelic alpha-hydroxy polymethylene. The polymer molecular weight was found to be directly proportional to the stoichiometric ratio of ylide/borane, and polydispersities as low as 1.01-1.03 have been realized. Although oligomeric polymethylene has been the most frequent synthetic target of this method, polymeric star organoboranes with molecular weights of 1.5 million have been produced. The average turnover frequency at 120 degrees C in 1,2,4,5-tetrachlorobenzene/toluene is estimated at >6 x 10(6) g of polymethylene (mol boron)(-1) h(-1). The mechanism of the polyhomologation reaction involves initial formation of a zwitterionic organoborane.ylide complex which breaks down in a rate-limiting 1,2-alkyl group migration with concomitant expulsion of a molecule of DMSO. The reaction was found to be first order in the borane catalyst and zero order in ylide. DMSO does not interfere with the reaction. The temperature dependence of the reaction rate yielded the following activation energy parameters (toluene, DeltaH(++) = 23.2 kcal/mol, DeltaS(++) = 12.6 cal deg/mol, DeltaG(++) = 19.5 kcal/mol; THF, DeltaH(++) = 26.5 kcal/mol, DeltaS(++) = 21.5 cal deg/mol, DeltaG(++) = 20.1 kcal/mol).

The adsorption of noble gases and nitrogen by sixteen metal-organic frameworks (MOFs) was investigated using grand canonical Monte Carlo simulation. The MOFs were chosen to represent a variety of net topologies, pore dimensions, and metal centers. Three commercially available MOFs (HKUST-1, AlMIL-53, and ZIF-8) and PCN-14 were also included for comparison. Experimental adsorption isotherms, obtained from volumetric and gravimetric methods, were used to compare krypton, argon, and nitrogen uptake with the simulation results. Simulated trends in gas adsorption and predicted selectivities among the commercially available MOFs are in good agreement with experiment. In the low pressure regime, the expected trend of increasing adsorption with increasing noble gas polarizabilty is seen. For each noble gas, low pressure adsorption correlates with several MOF properties, including free volume, topology, and metal center. Additionally, a strong correlation exists between the Henry's constant and the isosteric heat of adsorption for all gases and MOFs considered. Finally, we note that the simulated and experimental gas selectivities demonstrated by this small set of MOFs show improved performance compared to similar values reported for zeolites.

Copper-, manganese-, and zinc-based ionic liquids (Cu{NH(2)CH(2)CH(2)OH}(6)[CH(3)(CH(2))(3)CH(C(2)H(5))CO(2)](2) (2), Cu{NH(CH(2)CH(2)OH)(2)}(6)[CH(3)(CH(2))(3)CH(C(2)H(5))CO(2)](2) (3A), Cu{NH(CH(2)CH(2)OH)(2)}(6)[CF(3)SO(3)](2) (3B), Cu{NH(CH(2)CH(2)OH)(2)}(6)[(CF(3)SO(2))(2)N](2) (3C), Mn{NH(CH(2)CH(2)OH)(2)}(6)[CF(3)SO(3)](2) (4), and Zn{NH(2)CH(2)CH(2)OH}(6)[CF(3)SO(3)](2) (5)) are synthesized in a single-step reaction. Infrared data suggest that ethanolamine preferentially coordinates to the metal center through the amine group in 2 and the hydroxyl group in 5. In addition, diethanolamine coordinates through the amine group in 3A, 3C, and 4 and the hydroxyl group in 3B. The compounds are viscous (>1000 cP) at room temperature, but two (3C and 4) display specific conductivities that are reasonably high for ionic liquids (>20 mS cm(-1)). All of the compounds display a glass transition (T(g)) below -50 °C. The cyclic voltammograms (CVs) of 2, 3A, 3B, and 3C display a single quasi-reversible wave associated with Cu(II)/Cu(I) reduction and re-oxidation while 5 shows a wave attributed to Zn(II)/Zn(0) reduction and stripping (re-oxidation). Compound 4 is the first in this new family of transition metal-based ionic liquids (MetILs) to display reversible Mn(II)/Mn(III) oxidation and re-reduction at 50 mV s(-1) using a glassy carbon working electrode.

An iron-based ionic liquid, Fe((OHCH(2)CH(2))(2)NH)(6)(CF(3)SO(3))(3), is synthesized in a single-step complexation reaction. Infrared and Raman data suggest NH(CH(2)CH(2)OH)(2) primarily coordinates to Fe(iii) through alcohol groups. The compound has T(g) and T(d) values of -64 degrees C and 260 degrees C, respectively. Cyclic voltammetry reveals quasi-reversible Fe(iii)/Fe(ii) reduction waves.

No abstract

The boron-catalyzed polymerization of dimethylsulfoxonium methylide (1) has been used to prepare telechelic polymethylene polymers. The functional polymers were synthesized by hydroboration of substituted α-olefins. Functional groups including biotin, carbohydrates, primary and secondary amines, and dansyl and pyrene fluorescent groups were tolerant to the reaction conditions. The living polymerization of ylide 1 was initiated and catalyzed by the organoborane. Oxidation of the resulting tris(polymethylene) organoborane produced ω-hydroxy-terminated polymethylenes. The reactions were used to produce α,ω-polymethylenes with molecular weights in the range of 1000−17 000 with polydispersities < 1.1.

No abstract