Currently, there is an increasing demand for the production of biodiesel and, consequently, there will be an increasing need to treat wastewaters resulting from the production process of this biofuel. The main objective of this work was, therefore, to investigate the effect of applied volumetric organic load (AVOL) on the efficiency, stability, and methane production of an anaerobic sequencing batch biofilm reactor applied to the treatment of effluent from biodiesel production. As inert support, polyurethane foam cubes were used in the reactor and mixing was accomplished by recirculating the liquid phase. Increase in AVOL resulted in a drop in organic matter removal efficiency and increase in total volatile acids in the effluent. AVOLs of 1.5, 3.0, 4.5 and 6.0 g COD L(-1) day(-1) resulted in removal efficiencies of 92%, 81%, 67%, and 50%, for effluent filtered samples, and 91%, 80%, 63%, and 47%, for non-filtered samples, respectively, whereas total volatile acids concentrations in the effluent amounted to 42, 145, 386 and 729 mg HAc L(-1), respectively. Moreover, on increasing AVOL from 1.5 to 4.5 g COD L(-1) day(-1) methane production increased from 29.5 to 55.5 N mL CH(4) g COD(-1). However, this production dropped to 36.0 N mL CH(4) g COD(-1) when AVOL was increased to 6.0 g COD L(-1) day(-1), likely due to the higher concentration of volatile acids in the reactor. Despite the higher concentration of volatile acids at the highest AVOL, alkalinity supplementation to the influent, in the form of sodium bicarbonate, at a ratio of 0.5-1.3 g NaHCO(3) g COD (fed) (-1) , was sufficient to maintain the pH near neutral and guarantee process stability during reactor operation.

No abstract

-The removal of biological nitrogen from a synthetic wastewater with different ammonium nitrogen concentrations (50 and 100 mgN-NH 4 + /L) by a nitrification and denitrification process using a sequencing batch biofilm reactor (SBBR) with liquid-phase circulation was studied. The system with a total working volume of 4.6 L (3.7 L in the reactor and 0.9 L in the reservoir) treated 2.1 L of synthetic wastewater in 12-h cycles. As inoculum two types of biomass were used: an anaerobic/anoxic one from an up-flow anaerobic sludge blanket reactor (UASB) and an aerobic one from a prolonged aeration activated sludge system. The system, maintained at 30 ± 1 o C, operated in batch mode followed by fed-batch mode and was aerated intermittently. During fed-batch operation the reactor was fed with an external carbon source as electron donor in the denitrifying step and with no aeration. When the reactor was fed with 50 mgN-NH 4 + /L, efficiencies of removal of ammonium nitrogen and total nitrogen from the effluent were 93.8 and 72.2%, respectively, and nitrite, nitrate and organic nitrogen concentrations were 0.07, 6.4 and 0.5 mg/L, respectively. On the other hand, when the influent ammonium nitrogen concentration was 100 mgN-NH 4 + /L, residual nitrite and nitrate were 0.17 and 20.4, respectively, and no N-Org was found in the effluent. It should be mentioned that residual nitrate remained unaltered at the different C/N ratios used. Consequently, efficiency of total nitrogen removal was reduced to 66.7%, despite efficiency of ammonium nitrogen removal exceeding 90%. These results show the potential of the proposed system in removing ammonium nitrogen from liquid effluents with a moderate ammonium nitrogen concentration.

No abstract

No abstract