A detailed biochemical and mechanistic study of in vitro selected variants of 8-17 DNAzymes is presented. Even though the 8-17 DNAzyme motif has been obtained through in vitro selection under three different conditions involving 10 mM Mg(2+) (called 8-17), 0.5 mM Mg(2+)/50 mM histidine (called Mg5), or 100 microM Zn(2+) (called 17E), all variants are shown to be the most active with Pb(2+) (8-17: k(obs) approximately 0.5 min(-1); Mg5: k(obs) approximately 2 min(-1); 17E: k(obs) approximately 1 min(-1) with 200 microM Pb(2+) at pH 5.0). For the 17E variant of the 8-17 DNAzyme, the single-turnover rate constants followed the order of Pb(2+) >> Zn(2+) >> Mn(2+) approximately Co(2+) > Ni(2+) > Mg(2+) approximately Ca(2+) > Sr(2+) approximately Ba(2+). The catalytic rate is half-maximal at 13.5 microM Pb(2+), 0.97 mM Zn(2+), or 10.5 mM Mg(2+), suggesting that the metal-binding affinity of the DNAzymes is in the order of Pb(2+) > Zn(2+) > Mg(2+). The Pb(2+)-dependent activity increases linearly with pH and the slope of the plot of log k(obs) versus pH is approximately 1, suggesting a single deprotonation in the rate-limiting step of the reaction. Sequence variations of the DNAzyme confirm the importance of the G*T wobble pair, the two loops and the intervening stem in maintaining the active conformation of the system. While Mg(2+) and Zn(2+) catalyze only a transesterification reaction with formation of a product containing a 2',3'-cyclic phosphate, Pb(2+) catalyzes a transesterification reaction followed by hydrolysis of the 2',3'-cyclic phosphate. Although this two-step mechanism has shown to be operative in protein ribonucleases and in the leadzyme RNAzyme, it is now demonstrated for the first time that this DNAzyme may also use the same mechanism. Therefore, the two-step mechanism is observed in metalloenzymes of all classes, and this 8-17 DNAzyme provides a simple, stable, and cost-effective model system for understanding the structure of Pb(2+)-binding sites and their roles in the two-step mechanism.

The 8-17 DNAzyme is a DNA metalloenzyme catalyzing RNA transesterification in the presence of divalent metal ions, with activity following the order Pb2+ >> Zn2+ >>Mg2+. Since the DNAzyme has been used as a metal ion sensor, its metal-induced global folding was studied by fluorescence resonance energy transfer (FRET) by labeling the three stems of the DNAzyme with the Cy3/Cy5 FRET pair two stems at a time in order to gain deeper insight into the role of different metal ions in its structure and function. FRET results indicated that, in the presence of Zn2+ and Mg2+, the DNAzyme folds into a compact structure, stem III approaching a configuration defined by stems I and II without changing the angle between stems I and II. Correlations between metal-induced folding and activity were also studied. For Zn2+ and Mg2+, the metal ion with higher affinity for the DNAzyme in global folding (Kd(Zn) = 52.6 microM and Kd(Mg) = 1.36 mM) also displays higher affinity in activity (Kd(Zn) = 1.15 mM and Kd(Mg) = 53 mM) under the same conditions. Global folding was saturated at much lower concentrations of Zn2+ and Mg2+ than the cleavage activities, indicating the global folding of the DNAzyme occurs before the cleavage activity for those metal ions. Surprisingly, no Pb2+-dependent global folding was observed. These results suggest that for Pb2+ global folding of the DNAzyme may not be a necessary step in its function, which may contribute to the DNAzyme having the highest activity in the presence of Pb2+.

No abstract

No abstract