No abstract

This study focused on applying different high hydrostatic pressure + carbon dioxide (HHP + CO2) processing conditions on refrigerated (4 °C, 25 days) farmed coho salmon (Oncorhynchus kisutch) to inactivate endogenous enzymes (protease, lipase, collagenase), physicochemical properties (texture, color, lipid oxidation), and microbial shelf life. Salmon fillets were subjected to combined HHP (150 MPa/5 min) and CO2 (50%, 70%, 100%). Protease and lipase inactivation was achieved with combined HHP + CO2 treatments in which lipase activity remained low as opposed to protease activity during storage. Collagenase activity decreased approximately 90% during storage when applying HHP + CO2. Combined treatments limited the increase in spoilage indicators, such as total volatile amines and trimethylamine. The 150 MPa + 100% CO2 treatment was the most effective at maintaining hardness after 10 days of storage. Combined treatments limited HHP-induced color change and reduced the extent of changes caused by storage compared with the untreated sample. Microbial shelf life was extended by the CO2 content and not by the HHP treatments; this result was related to an increased lag phase and decreased growth rate. It can be concluded that combining HHP and CO2 could be an effective method of inactivating endogenous enzymes and extend salmon shelf life.

Summary Viscoelastic properties of two nontraditional hydrocolloid dispersions were evaluated. Prosopis chilensis seed gum was evaluated based on temperature (5–80 °C) and added CaCl2 (0.07%), whereas nopal mucilage was evaluated based on temperature (5–80 °C) and sucrose concentration (0–20%). Viscoelasticity was tested by the small strain oscillatory shear test; storage modulus (G′), loss modulus (G″) and tan δ were reported. Prosopis chilensis and nopal dispersions behaved as weak gels (G’ > G’’) regardless of experimental condition. Raising temperature from 20 to 80 °C significantly increased G’. The gel structure was strengthened by adding CaCl2 and G’ increased at 40 °C. The sucrose effect depended on concentration and temperature; at low sucrose concentrations, G’ modulus increased regardless of temperature level, but at high concentrations, it decreased at temperatures >40 °C. In conclusion, nopal and Prosopis chilensis dispersions show weak gel structure regardless of experimental condition. G′ increases as temperature increases, and these dispersions could be suitable for food applications requiring heat tolerance.

No abstract

This study aimed to increase the encapsulation efficiency (EE%) of liposomes loaded with green tea polyphenols (GTP), by optimizing with response surface methodology (RSM), characterizing the obtained particles, and modeling their release under conventional heating and pulsed electric fields. GTP-loaded liposomes were prepared under conditions of Lecithin/Tween 80 (4:1, 1:1, and 1:4), cholesterol (0, 30, and 50%), and chitosan as coating (0, 0.05, and 0.1%). Particles were characterized by size, polydispersity index, ζ -potential, electrical conductivity, and optical microscopy. The release kinetics was modeled at a temperature of 60 °C and an electric field of 5.88 kV/cm. The optimal manufacturing conditions of GTP liposomes (ratio of lecithin/Tween 80 of 1:1, cholesterol 50%, and chitosan 0.1%) showed an EE% of 60.89% with a particle diameter of 513.75 nm, polydispersity index of 0.21, ζ -potential of 33.67 mV, and electrical conductivity of 0.14 mS/cm. Optical microscopy verified layering in the liposomes. The kinetic study revealed that the samples with chitosan were more stable to conventional heating, and those with higher cholesterol content were more stable to pulsed electric fields. However, in both treatments, the model with the best fit was the Peppas model. The results of the study allow us to give an indication of the knowledge of the behavior of liposomes under conditions of thermal and non-thermal treatments, helping the development of new functional ingredients based on liposomes for processed foods.