No abstract

No abstract

Two deep wells were drilled at Rittershoffen (Alsace, France) to produce high-temperature fluids to supply heat to a biorefinery. The GRT-2 production well was drilled to a depth of 3196 m MD and was deviated to target a permeable local fault in the granitic basement buried beneath a thick sedimentary cover. The objective of this study is to better understand the permeability of fractured reservoirs within crystalline rocks, focusing on the production well GRT-2. Based on a petrographic and mineralogical analysis of cutting samples, several granitic facies associated with hydrothermal alteration were identified on the basis of the amounts of illite, chlorite, anhydrite, secondary geodic quartz, and oxides. These observations were correlated with various geological and geophysical datasets (gamma ray, porosity, density, electrical resistivity, caliper, borehole image logs, temperature, rate of penetration, and mud losses) to localize and identify permeable fracture zones. In sections where acoustic image logs were not available, such as in the deepest part of the well, the geometries of the fracture zones were interpreted from an oriented caliper log. The caliper log interpretation detected one-third of the fractures detected by acoustic image logs. However, two major fracture sets striking N-S and dipping eastward or westward were observed. Furthermore, a synthetic resistivity log that fits the measured resistivity log relatively well was built using the Archie and Waxman and Smits models. This approach is a proxy for estimating the porosity and the mineralogical changes based on the cation exchange capacity, which is controlled by the chlorite/illite ratio, derived from electrical logs in granitic formations. The correlation of all these results allowed the identification of a resistivity signature of a permeable fracture zone that spatially fits with the temperature signature. The major contribution of this study is the identification of a hierarchy of permeable fractures based on petrophysical signatures. The geophysical signature of fracture zones with low residual permeability exhibits a broad depth extent, whereas the geophysical signature of a highly permeable fracture zone is more localized. Past hydrothermal circulation has enlarged the altered and porous zones around open Open Access© The Author(s) 2018. This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creat iveco mmons .org/licen ses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.

Identifying fluid circulation in fracture zones (FZs) is a key challenge in the extraction of deep geothermal heat from natural reservoirs in the Upper Rhine Graben. This study focuses on permeable FZs present within the granitic basement penetrated by deep geothermal well GPK-1 at Soultz and GRT-1 and GRT-2 at Rittershoffen (France). The various temperature (T) log datasets acquired from these wells during production and at equilibrium, with the associated flow logs, allow for the unique opportunity to interpret fluid circulation at the borehole scale. All permeable FZs identified by permeability indicators measured during drilling operations and from image logs spatially coincide with positive or negative T anomalies observed in the T logs during production and/or at equilibrium. However, within the FZs, partially open fractures act as narrower paths for circulation at different temperatures. These temperatures can even be estimated with confidence if the associated flow log is available. The polarity of the T anomalies correlates with the state of equilibrium of the well and thus can change over the well history. During production, the temperature of the water inflow through the fractures can be estimated relative to the mixture of water circulating below the fractures. At thermal equilibrium, the water temperature is estimated with respect to the temperature of the surrounding rock formation. Because temperature fluxes and geothermal fluids are intimately linked, T logs are a useful, reliable, and very sensitive tool to localize the inflow of geothermal water through FZs.

Clay minerals are the signature of hydrothermal alterations related to fluid circulation in volcanic and crystalline rocks. In the French part of the Upper Rhine Graben, in the deep-seated granites, illitic minerals (illite and I/S mixed layers (ml)) are typical products of the structurally-controlled argillic alteration in the Paleozoic granitic basement. In the new Illkirch geothermal well, GIL-1, drill-cuttings were studied with various petrographic methods to determine the characteristics of illite in paleo- and present-permeable zones, and to compare the alteration mineralogy with that of geothermal Soultz-sous-Forêts and Rittershoffen sites. Alteration petrography, crystal structure as well as the chemical composition of the illitic minerals and the altered bulk rocks were performed all along the well. This complete characterization, combined with geophysical logs and structural results, highlighted that the illitic minerals at Illkirch, Soultz-sous-Forêts, and Rittershoffen are composed of illite and illite-rich illite-smectite mixed layers (I/S ml) (<10% smectite). Two mineralogical assemblages were distinguished: chlorite + illite resulting from the propylitic alteration after the emplacement of the granitic basement under temperatures higher than 350 °C, and illite + I/S ml + carbonates + quartz resulting from the argillic alteration due to fluid circulation in the fractures at temperatures between 130 and 160 °C. Fracture zones are characterized by the occurrence of illitic minerals (illite and I/S ml), and specifically, by higher quantities of I/S ml in present-day permeable zones than in paleo-permeable zones. A conceptual model of the fracture zones at the interface between the overlying sedimentary rocks and the granitic basement is proposed. The present-day permeability distribution is controlled by the fault and fracture network, which consists of sealed zones and unsealed zones. Fluid convection in the URG implies paleo and present fluids circulating in both fractured sedimentary and crystalline reservoirs. Such circulations develop illitic minerals that could be considered as exploration guides for future geothermal sites in the URG. At Illkirch, the repartition of the present-permeable fracture zones (KFZs) in the GIL-1 well indicates that the moderately argillically altered granite distally situated from the Eschau fault is more permeable than the intensely argillically altered granite close to the Eschau fault.

No abstract

The investigation of permeable hydrothermally altered and fractured zones and their distribution is a key issue for the understanding of fluid circulation in granitic rocks, on which the success of geothermal projects relies. Based on the use of short-wave infrared (SWIR) spectroscopy applied to rock cuttings coupled with interpretation of geophysical logs, we propose an investigation of the clay signature of fault and fracture zones (FZ) inside the granitic basement. This methodology was applied to two geothermal wells: GRT-2 from the Rittershoffen and GPK-1 from the Soultz-sous-Forêts (Soultz) geothermal sites, both located in the Upper Rhine Graben (URG). A total of 1430 SWIR spectra were acquired and analysed. Variations in the 2200 nm absorption band area are correlated with hydrothermal alteration grades. The 2200 nm absorption band area is found to reflect the illite quantity and its variations in the granitic basement. Low, stable values are observed in the unaltered granite facies, showing good reproducibility of the method, whereas scattered high values are associated with high hydrothermal alteration and FZs. Variations in the 2200 nm absorption band area were correlated with the gamma ray and electrical resistivity logs. This procedure allowed us to confirm that illite mainly controls the resistivity response except inside the permeable FZs, where the resistivity response is controlled by the geothermal brine. Thus, the architecture of these permeable FZs was described precisely by using a combination of the 2200 nm absorption band area data and the electrical resistivity log. Moreover, by correlation with other geophysical logs (temperature (T), porosity, and density), paleo-permeable and currently permeable FZs inside the reservoir were distinguished. The correlation of SWIR spectroscopy with electrical resistivity logs appears to be a robust tool for geothermal exploration in granitic reservoirs in the URG.

No abstract