In this work, a numerical model has been applied in order to obtain the wall pressure fluctuations at the volute of an industrial centrifugal fan. The numerical results have been compared to experimental results obtained in the same machine. A three-dimensional numerical simulation of the complete unsteady flow on the whole impeller-volute configuration has been carried out using the computational fluid dynamics code FLUENT®. This code has been employed to calculate the time-dependent pressure both in the impeller and in the volute. In this way, the pressure fluctuations in some locations over the volute wall have been obtained. The power spectra of these fluctuations have been obtained, showing an important peak at the blade passing frequency. The amplitude of this peak presents the highest values near the volute tongue, but the spatial pattern over the volute extension is different depending on the operating conditions. A good agreement has been found between the numerical and the experimental results.

The results of an experimental investigation of the flow at two exit radial locations of a forward-curved blades centrifugal fan are presented. Hot wire techniques were used to obtain steady velocity components and velocity unsteadiness levels (rms value of the components of velocity fluctuation) for different operating conditions. Globally speaking, the data reveal a strong flow asymmetry, with considerable changes in both magnitude and direction along the different circumferential positions. Particularly, big differences appear between the circumferential positions closer to the volute tongue and the other ones. The periodic character of the velocity signals due to the passing of the blades, clearly observed around the impeller, is missed in the vicinity of the volute tongue, where the main contribution to the velocity fluctuations appears to be random. Based on the measured velocity signals, velocity unsteadiness of the flow is determined analyzing the main contributions as a function of the flow rate and the measurement position. High levels of velocity unsteadiness were observed near the volute tongue, mainly at low flow rates.

No abstract

In this work, an experimental study about the influence of some geometric features on the aeroacoustic behavior of a squirrel-cage fan, used in automotive air conditioning units, has been carried out. The study focused on the effect of both the shape and the position of the volute tongue on the noise generated by the fan. Different geometric configurations were tested in order to compare the results. First of all, the performance curves were measured in a standardized test facility. Then, the acoustic behavior of the fan was characterized by means of acoustic pressure measurements near the fan inlet. The comparison of the test results indicated a great dependence of both the shape and the position of the volute tongue and the noise generation. In particular, some geometric configurations of the volute tongue were able to reduce the fan noise generation without reducing the fan performance.

Variable pitch axial flow fans are widely used in industrial applications to satisfy variable operating conditions. The change of the blade pitch leads to a different rotor geometry and has a major influence on the unsteady operation of the machine. In this work, an experimental research on an axial flow fan with variable pitch blades has been carried out. First of all, the fan performance curves has been obtained. Then the flow field has been measured at ten radial locations both at the inlet and exit rotor plane using hot wire anemometry. Velocity components and total unsteadiness were determined and analyzed in order to characterize the influence of pitch blade and operating conditions on the flow structure.