Flatbed scanners are the most frequently used reading instrument for radiochromic film dosimetry because its low cost, high spatial resolution, among other advantages. These scanners use a fluorescent lamp and a CCD array as light source and detector, respectively. Recently, manufacturers of flatbed scanners replaced the fluorescent lamp by light emission diodes (LED) as a light source. The goal of this work is to evaluate the performance of a commercial flatbed scanner with LED based source light for radiochromic film dosimetry. Film read out consistency, response uniformity, film-scanner sensitivity, long term stability and total dose uncertainty was evaluated. In overall, the performance of the LED flatbed scanner is comparable to that of a cold cathode fluorescent lamp (CCFL). There are important spectral differences between LED and CCFL lamps that results in a higher sensitivity of the LED scanner in the green channel. Total dose uncertainty, film response reproducibility and long-term stability of LED scanner are slightly better than those of the CCFL. However, the LED based scanner has a strong non-uniform response, up to 9%, that must be adequately corrected for radiotherapy dosimetry QA. The differences in light emission spectra between LED and CCFL lamps and its potential impact on film-scanner sensitivity suggest that the design of a dedicated flat-bed scanner with LEDs may improve sensitivity and dose uncertainty in radiochromic film dosimetry.

No abstract

We show numerically and experimentally that second-harmonic generation in spatially nonsymmetrical structures can show a direction-dependent or nonreciprocal behavior under a variety of conditions.

Temperature dependence and single-mode tuning behavior of second-harmonic generation in quantum cascade lasers Appl.Device length dependence of optical second-harmonic generation in AlGaAs quasiphase matched waveguides

A single-lens optical setup with a nonlinear medium placed in its geometrical focal plane is used to contrast a phase disturbance. This setup blends the robustness of phase-contrast methods with an optical nonlinear intensity-dependent medium and the usefulness of traditional interferometric techniques. We show that the ratio of the total illumination area to the phase-object area determines an adequate phase-disturbance contrast.