This work presents the design, fabrication, and characterization of a robust 3D printed microfluidic analysis system that integrates with FDA-approved clinical microdialysis probes for continuous monitoring of human tissue metabolite levels. The microfluidic device incorporates removable needle type integrated biosensors for glucose and lactate, which are optimized for high tissue concentrations, housed in novel 3D printed electrode holders. A soft compressible 3D printed elastomer at the base of the holder ensures a good seal with the microfluidic chip. Optimization of the channel size significantly improves the response time of the sensor. As a proof-of-concept study, our microfluidic device was coupled to lab-built wireless potentiostats and used to monitor real-time subcutaneous glucose and lactate levels in cyclists undergoing a training regime.

Endoscopic procedures have transformed minimally invasive surgery as they allow the examination and intervention on a patient’s anatomy through natural orifices, without the need for external incisions. However, the complexity of anatomical pathways and the limited dexterity of existing instruments, limit such procedures mainly to diagnosis and biopsies. This paper proposes a new robotic platform: the Intuitive imaging sensing navigated and kinematically enhanced () robot that aims to improve the field of endoscopic surgery. The proposed robotic platform includes a snake-like robotic endoscope equipped with a camera, a light-source and two robotic instruments, supported with a robotic arm for global positioning and for insertion of the and a master interface for master–slave teleoperation. The proposed robotic platform design focuses on ergonomics and intuitive control. The control workflow was first validated in simulation and then implemented on the robotic platform. The results are consistent with the simulation and show the clear clinical potential of the system. Limitations such as tendon backlash and elongation over time will be further investigated by means of combined hardware and software solutions. In conclusion, the proposed system contributes to the field of endoscopic surgical robots and could allow to perform more complex endoscopic surgical procedures while reducing patient trauma and recovery time.

Abstract-This paper introduces a single-port robotic platform for Transanal Endoscopic Micro-Surgery (TEMS). Two robotically controlled articulated surgical instruments are inserted via a transanal approach to perform submucosal or fullthickness dissection. This system is intended to replace the conventional TEMS approach that uses manual laparoscopic instruments. The new system is based on master-slave robotically controlled tele-manipulation. The slave robot comprises a support arm that is mounted on the operating table, supporting a surgical port and a robotic platform that drives the surgical instruments. The master console includes a pair of haptic devices, as well as a 3D display showing the live video stream of a stereo endoscope inserted through the surgical port. The surgical instrumentation consists of energy delivery devices, graspers and needle drivers allowing a full TEMS procedure to be performed. Results from benchtop tests, ex-vivo animal tissue evaluation and in-vivo studies demonstrate the clinical advantage of the proposed system.

ObjectiveTo design and implement an electromyography (EMG)-based controller for a hand robotic assistive device, which is able to classify the user's motion intention before the effective kinematic movement execution.MethodsMultiple degrees-of-freedom hand grasp movements (i.e. pinching, grasp an object, grasping) were predicted by means of surface EMG signals, recorded from 10 bipolar EMG electrodes arranged in a circular configuration around the forearm 2–3 cm from the elbow. Two cascaded artificial neural networks were then exploited to detect the patient's motion intention from the EMG signal window starting from the electrical activity onset to movement onset (i.e. electromechanical delay).ResultsThe proposed approach was tested on eight healthy control subjects (4 females; age range 25–26 years) and it demonstrated a mean ± SD testing performance of 76% ± 14% for correctly predicting healthy users' motion intention. Two post-stroke patients tested the controller and obtained 79% and 100% of correctly classified movements under testing conditions.ConclusionA task-selection controller was developed to estimate the intended movement from the EMG measured during the electromechanical delay.

Abstract-The field of robotic surgery increasingly advances towards highly articulated and continuum robots, requiring new kinematic strategies to enable users to perform dexterous manipulation in confined workspaces. This development is driven by surgical interventions accessing the surgical workspace through natural orifices such as the mouth or the anus. Due to the long and narrow nature of these access pathways, external triangulation at the fulcrum point is very limited or absent, which makes introducing multiple degrees of freedom at the distal end of the instrument necessary. Additionally, high force and miniaturization requirements make the control of such instruments particularly challenging. This paper presents the kinematic considerations needed to effectively manipulate these novel instruments and allow their dexterous control in confined spaces. A non-linear calibration model is further used to map joint to actuator space and improve significantly the precision of the instrument's motion. The effectiveness of the presented approach is quantified with bench tests, and the usability of the system is assessed by three user studies simulating the requirements of a realistic surgical task.

New robotic platforms in minimally invasive neurosurgery must possess clear and unambiguous advantages over conventional approaches if they are to achieve significant clinical penetration.

No abstract

The flexible endoscope is playing an increasingly pivotal role in minimally invasive transluminal and endoluminal surgery. Whilst the flexible nature of the platform is desirable in order to navigate through the abdominal cavity or through a lumen, there are a number of issues with using the platform for this purpose.The challenges associated with using flexible endoscopes such as a lack of triangulation of instruments and force transmission, which is often inadequate for endoscopic surgery are discussed in this review.As a result of these difficulties, a number of mechanically and robotically driven devices based upon the flexible endoscope are emerging. The design of these devices and potential problems are also reviewed. Finally, future robotic systems which are still in the development and validation stage are briefly discussed.The field of gastroenterology is diverging. The narrowing divide between minimally invasive and endoluminal surgery has led to a surge of innovative and novel devices which may in the future enable precise, seamless and scar less surgery.