No abstract

The stability of the Pt-3d-Pt(111) (3d = Ti, V, Cr, Mn, Fe, Co, or Ni) bimetallic surface structures in the presence of adsorbed oxygen has been investigated by means of density functional theory (DFT). The dissociative binding energies of oxygen on Pt-3d-Pt(111) (i.e., subsurface 3d monolayer) and 3d-Pt-Pt(111) (i.e., surface 3d monolayer) were calculated. All of the Pt-3d-Pt(111) surfaces were found to have weaker oxygen binding energies than pure Pt(111) whereas all of the 3d-Pt-Pt(111) surfaces were found to have stronger oxygen binding energies than pure Pt(111). The total heat of reaction was calculated for the segregation for 3d metal atoms from Pt-3d-Pt(111) to 3d-Pt-Pt(111) when exposed to a half monolayer of oxygen. All of the Pt-3d-Pt(111) subsurface structures were predicted to be thermodynamically unstable with adsorbed oxygen. In addition, the segregation of subsurface Ni and Co to the surfaces of Pt-Ni-Pt(111) and Pt-Co-Pt(111) was investigated experimentally using Auger electron spectroscopy (AES) and high-resolution electron energy loss spectroscopy (HREELS). AES and HREELS confirmed the trend predicted by DFT modeling and showed that both the Pt-Ni-Pt(111) and Pt-Co-Pt(111) surface structures were unstable in the presence of adsorbed oxygen. The activation barrier of the segregation of surbsurface Ni and Co atoms was determined to be 15 +/- 2 and 7 +/- 1 kcal/mol, respectively. These results are further discussed for their implication in the design and selection of cathode bimetallic electrocatalysts for the oxygen reduction reaction (ORR) in polymer electrode membrane (PEM) fuel cells.

It is well known that the unique chemical properties of transition metal alloys depend on the configuration of metal atoms of the bimetallic surfaces. Using density functional theory calculations, the thermodynamic potential for segregation of an admetal from the subsurface to surface configuration is shown to correlate linearly with the difference in occupied d-band center, Delta epsilon(d), between these two configurations for a wide range of bimetallic systems. The thermodynamic potential for segregation is also shown to increase with the Pauling electronegativity for several adsorbates, including atomic H, O, C, N, S, and Se. A generalized equation is provided to predict the stable surface configuration for the bimetallic systems with different adsorbates.

Methanol was used as a probe molecule to examine the reforming activity of oxygenates on NiPt(111) and CoPt(111) bimetallic surfaces, utilizing density functional theory (DFT) modeling, temperature-programmed desorption, and high-resolution electron energy loss spectroscopy (HREELS). DFT results revealed a correlation between the methanol and methoxy binding energies and the surface d-band center of various NiPt(111) and CoPt(111) bimetallic surfaces. Consistent with DFT predictions, increased production of H2 and CO from methanol was observed on a Ni surface monolayer on Pt(111), designated as Ni-Pt-Pt(111), as compared to the subsurface monolayer Pt-Ni-Pt(111) surface. HREELS was used to verify the presence and subsequent decomposition of methoxy intermediates on NiPt(111) and CoPt(111) bimetallic surfaces. On Ni-Pt-Pt(111) the methoxy species decomposed to a formaldehyde intermediate below 300 K; this species reacted at approximately 300 K to form CO and H2. On Co-Pt-Pt(111), methoxy was stable up to approximately 350 K and decomposed to form CO and H2. Overall, trends in methanol reactivity on NiPt(111) bimetallic surfaces were similar to those previously determined for ethanol and ethylene glycol.

The stability of subsurface 3d transition metals (3d represents Ni, Co, Fe, Mn, Cr, V, and Ti) in Pt(111) and Pt(100) was examined in vacuum and with 0.5 ML atomic oxygen by a combined experimental and density functional theory (DFT) approach. DFT was used to predict the trends in the binding energy of oxygen and in the stability of 3d metals to remain in the subsurface layer. DFT calculations predicted that for both (111) and (100) crystal planes the subsurface Pt-3d-Pt configurations were thermodynamically preferred in vacuum and that the surface 3d-Pt-Pt configurations were preferred with the adsorption of 0.5 ML atomic oxygen. Experimentally, the DFT predictions were verified by using Auger electron spectroscopy to monitor the segregation of Ni and Co in Pt-3d-Pt structures on polycrystalline Pt foil, composed of mainly (111) and (100) facets. The activation barrier for the oxygen-induced segregation of Ni was found to be 17+/-1 kcal/mol attributed to the Pt(111) areas and 27+/-1 kcal/mol attributed to the Pt(100) areas of the Pt foil. For Pt-Co-Pt, the activation barrier was found to be 10+/-1 kcal/mol and was attributed to the Pt(111) areas of the Pt foil. The Bronsted-Evans-Polanyi relationship was utilized to predict the activation barriers for segregation of the other Pt-3d-Pt(111) and Pt-3d-Pt(100) systems. These results are further discussed in connection to the activity and stability for cathode bimetallic electrocatalysts for proton exchange membrane fuel cells.

We present results for H 2 production by reforming of oxygenates on Pt-based bimetallic surfaces using temperature-programmed desorption (TPD), highresolution electron energy loss spectroscopy (HREELS) and density functional theory (DFT) calculations. Methanol, ethanol, ethylene glycol, and glycerol were employed as probe molecules. The formation of bimetallic surfaces with a 3d metal monolayer on Pt(111), designated 3d-PtPt(111), led to increased H 2 production as compared to the parent metal surfaces. The combined experimental and DFT results suggest that the reforming activity tracks the energy of the surface d-band center of various monometallic and bimetallic surfaces.

No abstract

No abstract