The paper presents the results of the Battle of Post-Disaster Response and Restoration (BPDRR), presented in a special session at the 1 st International WDSA/CCWI Joint Conference, held in Kingston, Ontario, in July 2018. The BPDRR problem focused on how to respond and restore water service after the occurrence of five earthquake scenarios that cause structural damage in a water distribution system. Participants were required to propose a prioritization schedule to fix the damages of each scenario while following restrictions on visibility/non visibility of damages. Each team/approach was evaluated against six performance criteria that included: 1) Time without supply for hospital/firefighting, 2) Rapidity of recovery, 3) Resilience loss, 4) Average time of no user service, 5) Number of users without service for 8 consecutive hours, and 6) Water loss. Three main types of approaches were identified from the submissions: 1) General purpose metaheuristic algorithms, 2) Greedy algorithms, and 3) Ranking-based prioritizations. All three approaches showed potential to solve the challenge efficiently. The results of the participants showed that, for this network, the impact of a largediameter pipe failure on the network is more significant than several smaller pipes failures. The location of isolation valves and the size of hydraulic segments influenced the resilience of the system during emergencies. On average, the interruptions to water supply (hospitals and firefighting) varied considerably between solutions and emergency scenarios, highlighting the importance of private water storage for emergencies. The effects of damages and repair work were more noticeable during the peak demand periods (morning and noontime) than during the low-flow periods; and tank storage helped to preserve functionality of the network in the first few hours after a simulated event.

In recent years, there has been an increase in the frequency of urban floods as a result of three determinant factors: the reduction in systems’ capacity due to aging, a changing environment that has resulted in alterations in the hydrological cycle, and the reduction of the permeability of watersheds due to urban growth. Due to this, a question that every urban area must answer is: Are we ready to face these new challenges? The renovation of all the pipes that compose the drainage system is not a feasible solution, and, therefore, the use of new solutions is an increasing trend, leading to a new operational paradigm where water is stored in the system and released at a controlled rate. Hence, technologies, such as stormwater tanks, are being implemented in different cities. This research sought to understand how Climate Change would affect future precipitation, and based on the results, applied two different approaches to determine the optimal location and sizing of storage units, through the application of the Simulated Annealing and Pseudo-Genetic Algorithms. In this process, a strong component of computational modeling was applied in order to allow the optimization algorithms to efficiently reach near-optimal solutions. These approaches were tested in two stormwater networks at Bogotá, Colombia, considering three different rainfall scenarios.

The determination of the optimal location and settings of PRV is an operational problem that water utilities must deal with in order to reduce the real losses that are inherent to their water distribution system. In this research, a multi-objective optimization approach was developed to provide an optimal solution for the addressed problem, using the well-known metaheuristic algorithm NSGA-II and including the usage of hydraulic criteria to reduce the solution space, in order to enhance the performance of the procedure. The proposed methodology was tested using two different networks, which differ in their leakage configuration and the hydraulic parameters used for this modeling.

In recent years, iterative computational techniques have been considered as the most effective methods to tackle the problem of Water Distribution System (WDS) minimum-cost design. Given their stochastic nature, these approaches involve a large number of hydraulic simulations in order to obtain suitable results. Herein, a WDS design methodology based entirely on hydraulic principles is presented. This methodology, named Optimal Power Use Surface (OPUS), focuses on both reaching low-cost designs and diminishing the number of hydraulic executions (iterations), by establishing efficient ways in which energy is dissipated and flow is distributed throughout the system. The algorithm was tested in four well known benchmark networks, previously reported in the literature. OPUS proved that following hydraulic principles is a fair choice to design WDS, showing plenty of potential in other water distribution mathematical modeling applications and offering an alternative for the extensive search process undertaken by metaheuristics.

No abstract

No abstract

No abstract

Contamination events in water distribution systems (WDSs) are highly dangerous events in very vulnerable infrastructure where a quick response by water utility managers is indispensable. Various studies have explored methods to respond to water events and a variety of models have been developed to simulate the consequences and the reactions of all stakeholders involved. This study proposes a novel contamination response and recovery methodology using machine learning and knowledge of the topology and hydraulics of a water network inside of an agent-based model (ABM). An artificial neural network (ANN) is trained to predict the possible source of the contamination in the network, and the knowledge of the WDS and the possible flow directions throughout a demand pattern is utilized to verify that prediction. The utility manager agent can place mobile sensor equipment to trace the contamination spread after identifying the source to identify endangered and safe places in the water network and communicate that information to the consumer agents through water advisories. The contamination status of the network is continuously updated, and the consumers reaction and decision making are determined by a fuzzy logic system considering their social background, recent stress factors based on findings throughout the COVID-19 pandemic and their location in the network. The results indicate that the ANN-based support tool, paired with knowledge of the network, provides a promising support tool for utility managers to identify the source of a possible water event. The optimization of the ANN and the methodology led to accuracies up to 80%, depending on the number of sensors and the prediction types. Furthermore, the specified water advisories according to the mobile sensor placement provide the consumer agents with information on the contamination spread and urges them to seek for help or support less.