Ectopically, expression of defined factors could reprogram mammalian somatic cells into induced pluripotent stem cells (iPSCs), which initiates a new strategy to obtain pluripotent stem cell lines. Attempts have been made to generate buffalo pluripotent stem cells by culturing primary germ cells or inner cell mass, but the efficiency is extremely low. Here, we report a successful method to reprogram buffalo fetal fibroblasts (BFFs) into pluripotent stem cells [buffalo induced pluripotent stem cell (biPSCs)] by transduction of buffalo defined factors (Oct4, Sox2, Klf4, and c-Myc) using retroviral vectors. The established biPSCs displayed typical morphological characteristics of pluripotent stem cells, normal karyotype, positive staining of alkaline phosphatase, and expressed pluripotent markers including Oct4, Sox2, Nanog, Lin28, E-Cadherin, SSEA-1, SSEA-4, TRA-1-81, STAT3, and FOXD3. They could form embryoid bodies (EBs) in vitro and teratomas after injecting into the nude BALB/C mice, and 3 germ layers were identified in the EBs and teratomas. Methylation assay revealed that the promoters of Oct4 and Nanog were hypomethylated in biPSCs compared with BFFs and pre-biPSCs, while the promoters of Sox2 and E-Cadherin were hypomethylated in both BFFs and biPSCs. Further, inhibiting p53 expression by coexpression of SV40 large T antigen and buffalo defined factors in BFFs or treating BFFs with p53 inhibitor pifithrin-a (PFT) could increase the efficiency of biPSCs generation up to 3-fold, and nuclear transfer embryos reconstructed with biPSCs could develop to blastocysts. These results indicate that BFFs can be reprogrammed into biPSCs by buffalo defined factors, and the generation efficiency of biPSCs can be increased by inhibition of p53 expression. These efforts will provide a feasible approach for investigating buffalo stem cell signal pathways, establishing buffalo stem cell lines, and producing genetic modification buffaloes in the future.

The use of COCs to select spermatozoa for ICSI appears to be effective and led to a statistically significant improvement in blastocyst development and quality.

BackgroundSperm cryopreservation is the most effective method to preserve male fertility but this is normally used for motile spermatozoa. Thus, only motile spermatozoa are used for cryopreservation in most reproductive medicine centers worldwide. The immotile spermatozoa from some problematic patients are usually discarded, resulting in a missed opportunity of sterility cryopreservation for future assisted reproductive treatments. Many studies have shown that successful fertilization can be obtained after selection of viable sperm from the completely immotile spermatozoa before ICSI. Whether the completely immotile spermatozoa are worth of freezing has not been realized The aim of this study is to explore the clinical value of cryopreservation of immotile spermatozoa.MethodsCompletely immotile spermatozoa were collected and frozen, and subsequently viable but immotile frozen-thawed spermatozoa were selected by laser plus for ICSI. Main outcomes included spermatozoa survival index, fertilization rate and good quality embryo rate.ResultsAfter identification by laser, the fresh samples of spermatozoa presented with a mean survival rate of 54.86% and 26.05%, and this was reduced to 44.13% and 18.13% in frozen-thawed spermatozoa samples, which showed a frozen-thawed spermatozoa survival index of 0.80 and 0.70 in the testicular and ejaculate sperm, respectively. There were no statistically differences in fertilization rate (80% vs80.51%, 75.00% vs 81.48%), cleavage rate (95.45% vs 98.95%, 100.00% vs 95.45%) and good quality embryo rate (40.48% vs 52.13%, 33.33%vs38.10%) between the frozen-thawed immotile spermatozoa group and the routine fresh immotile spermatozoa ICSI group in both testicular and ejaculate sperm, respectively.ConclusionsThe results of the study show that completely immotile spermatozoa can be frozen in order to preserve male fertility as long as viable spermatozoa are present. This procedure provides a further possibility for fertility preservation for patients with completely immotile spermatozoa.

ObjectiveThe aim of this study was to explore the effects of the insemination method on the outcomes of elective blastocyst culture.MethodsWe retrospectively analyzed the outcomes of elective blastocyst culture performed between January 2011 and December 2014.ResultsThere were 2,003 cycles of conventional in vitro fertilization (IVF) and 336 cycles of intracytoplasmic sperm injection (ICSI), including 25,652 and 4,164 embryos that underwent sequential blastocyst culture, respectively. No significant differences were found in the female patients' age, basal follicle-stimulating hormone level, basal luteinizing hormone level, body mass index, number of oocytes, maturity rate, fertilization rate, or good-quality embryo rate. However, the blastocyst formation rate and embryo utilization rate were significantly higher in the conventional IVF group than in the ICSI group (54.70% vs. 50.94% and 51.09% vs. 47.65%, respectively, p<0.05). The implantation/pregnancy rate (IVF, 50.93%; ICSI, 55.10%), miscarriage rate (IVF, 12.57%; ICSI, 16.29%), and live birth rate (IVF, 42.12%; ICSI, 44.08%) were similar (p>0.05). No cycles were canceled due to the formation of no usable blastocysts.ConclusionAlthough the fertilization method had no effect on clinical outcomes, the blastocyst formation rate and embryo utilization rate in the ICSI group were significantly lower than those observed in the conventional IVF group. Therefore, more care should be taken when choosing to perform blastocyst culture in ICSI patients.

Timing of blastocoele re-expansion in vitrified-warmed cycles is a strong predictor of clinical pregnancy outcome. The faster the re-expansion of the blastocoele, the higher the developmental potential of the blastocysts.

BackgroundIn recent years, single blastocyst transfer combined with vitrification has been applied widely, which can maximize the cumulative pregnancy rate in per oocyte retrieval cycles and minimize the multiple pregnancy rate. Thus, the guarantee for these is the effectiveness of vitrified blastocyst. Studies has shown that AS of the blastocoel cavity prior to vitrification can reduce injuries, increase the thawed blastocyst survival rate and implantation rate. Several AS methods have been established. However, only a few studies have compared the effectiveness and safety of these AS methods. In this study, we aimed to compare the clinical outcomes and neonatal outcomes in FET cycles with single blastocyst that were artificially shrunk before vitrification by either LAS or MNAS method.MethodsA retrospective comparative study of FET cycles in infertile patients which were at our clinic between January 2013 and December 2014. These FET cycles were divided into two groups by the shrinking methods used before vitrification and the clinical and neonatal outcomes were assessed.ResultsThere were no statistically differences in blastocyst survival rates (95.40% vs 94.05%, P > 0.05) between the LAS and MNAS groups. However, compared with MNAS, LAS improved the warmed blastocyst implantation/clinical pregnancy rate (60.82% vs 54.37%, P < 0.05), live birth rate (50.43% vs 45.22%, P < 0.05) and also increased the monozygotic twin rate (4.07% vs 1.73%, P < 0.05). There were no differences in the average gestational weeks (38.83 ± 1.57 vs 38.74 ± 1.75), premature birth rate (0.30% vs 0.49%), average birth weight (3217.89 ± 489.98 g vs 3150.88 ± 524.03 g), low birth weight rate (5.60% vs 8.63%) and malformation rate (0.59% vs 0.48%) (P > 0.05).ConclusionsNo significant differences in neonatal outcomes were observed, while in clinical outcomes, LAS improved the warmed blastocyst implantation/clinical pregnancy rate and live birth rate markedly, there was also an increased risk of monozygotic twin pregnancies.

No abstract

A viable spermatozoon is a prerequisite for fertilization in intracytoplasmic sperm injection (ICSI). Thus, it is crucial to select viable but immotile spermatozoa on the day of ICSI. We report conflicting results in the identification of viable but immotile spermatozoa between the eosin-nigrosin staining and the laser test, which resulted in confusion for embryologists during assisted reproductive technology (ART). Three patients’ semen samples that showed no motile spermatozoa are described in this report. To identify viable spermatozoa, we used both the eosin-nigrosin test and the laser test for each sample, and repeated the semen analysis twice in each patient. Viable but immotile spermatozoa selected by the laser test were used for ICSI. Viable spermatozoa were detected by both the eosin-nigrosin and laser tests in two patients (case 1, 95.00% vs. 24.21% and 92.68% vs. 22.22%; case 2, 41.18% vs. 23.48% and 39.81% vs. 22.52%), indicating consistent results between the two methods. In the third patient, the eosin-nigrosin test yielded viability rates of 20.75% and 19.14%, while the result of the laser test was 0%. Thus, testicular aspiration was performed to collect viable sperm from this patient. Normal fertilization was achieved after the injection of viable but immotile spermatozoa selected from these patients by the laser test, resulting in the birth of two healthy babies. Our study documents a case where the eosin-nigrosin test showed a limitation in identifying viable but immotile spermatozoa for ART, while the laser test may overcome this limitation. Larger samples may be required to corroborate the clinical value of the laser test.