Pressure sensors for wearable healthcare devices, particularly force sensitive resistors (FSRs) are widely used to monitor physiological signals and human motions. However, current FSRs are not suitable for integration into wearable platforms. This work presents a novel technique for developing textile FSRs (TFSRs) using a combination of inkjet printing of metal-organic decomposition silver inks and heat pressing for facile integration into textiles. The insulating void by a thermoplastic polyurethane (TPU) membrane between the top and bottom textile electrodes creates an architectured piezoresistive structure. The structure functions as a simple logic switch where under a threshold pressure the electrodes make contact to create conductive paths (on-state) and without pressure return to the prior insulated condition (off-state). The TFSR can be controlled by arranging the number of layers and hole diameters of the TPU spacer to specify a wide range of activation pressures from 4.9 kPa to 7.1 MPa. For a use-case scenario in wearable healthcare technologies, the TFSR connected with a readout circuit and a mobile app shows highly stable signal acquisition from finger movement. According to the on/off state of the TFSR with LED bulbs by different weights, it can be utilized as a textile switch showing tactile feedback.
The low-temperature processing, inherent flexibility, and biocompatibility of piezoelectric polymers such as poly(vinylidene fluoride) (PVDF)-based materials enable the creation of soft wearable sensors, energy harvesters, and actuators. Of the various processing techniques, electrospinning is the most widely adopted process to form PVDF nanofiber scaffolds with enhanced piezoelectric properties such that they do not require further post-processing such as mechanical drawing, electrical poling, or thermal annealing. However, electrospinning requires long periods of time to form sufficiently thick PVDF nanofiber scaffolds and requires extremely high voltages to form scaffolds with enhanced piezoelectric properties, which limits the number of usable substrates, thus restricting the integration and use of electrospun PVDF scaffolds into wearable textile platforms. In this work, we propose a facile processing technique to airbrush PVDF−trifluoroethylene (TrFE) nanofiber scaffolds directly onto textile substrates. We tune the polymer concentration (4, 6, and 8 wt %) and the spray distance (5, 12.5, and 20 cm) to understand their effects on the morphology and crystal structure of the fibrous scaffolds. The characterization results show that increasing the polymer wt % encourages the formation of fibrous morphologies and a β-phase crystal structure. We then demonstrate how the airbrushed PVDF−TrFE scaffolds can be easily integrated onto conductive inkjet-printed nonwoven textile substrates to form airbrushed piezoelectric textile devices (APTDs). The APTDs exhibit maximum open-circuit voltages of 667.1 ± 162.1 mV under tapping and 276.9 ± 59.0 mV under bending deformations. The APTDs also show an areal power density of 0.04 μW/cm 2 , which is 40× times higher compared to previously reported airbrushed PVDF scaffolds. Lastly, we sew APTDs into wearable textile platforms to create fully textile-integrated devices with applications in sensing a basketball shooting form.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.