In this study, electrochemical removal of methylene blue (MB) from water using commercially available and low-cost flexible graphite was investigated. The operating conditions such as initial dye concentration, initial solution pH, electrolyte dose, electrical potential, and operating time were investigated. The Box-Behnken experimental design (BBD) was used to optimize the system’s performance with the minimum number of tests possible, as well as to examine the independent variables’ impact on the removal efficiency, energy consumption, operating cost, and effluent MB concentration. The electrical potential and electrolyte dosage both improved the MB removal efficiency, since increased electrical potential facilitated production of oxidizing agents and increase in electrolyte dosage translated into an increase in electrical current transfer. As expected, MB removal efficiency increased with longer operational periods. The combined effects of operating time–electrical potential and electrical potential–electrolyte concentration improved the MB removal efficiency. The maximum removal efficiency (99.9%) and lowest operating cost (0.012 $/m 3 ) were obtained for initial pH 4, initial MB concentration 26.5 mg/L, electrolyte concentration 0.6 g/L, electrical potential 3 V, and operating time 30 min. The reaction kinetics was maximum for pH 5, and as the pH increased the reaction rates decreased. Consequent techno-economic assessment showed that electrochemical removal of MB using low-cost and versatile flexible graphite had a competitive advantage.
Indoor air quality (IAQ) is impacted by polluted outdoor air in naturally ventilated schools, especially in places where both anthropogenic and natural sources of ambient air pollution exist. CO2, PM2.5, PM10, temperature, relative humidity (RH), and noise were measured in five naturally ventilated primary schools in City of Sanliurfa, in a dusty region of Turkey, Southeast Anatolia. Excess risk levels were estimated for particulate matter. Investigation was conducted through an educational year including two seasons in terms of anthropogenic effect, that is, heating/non‐heating, and natural effect, that is, desert dust transport/non‐dust transport. The median CO2 concentration was measured to be >1000 ppm in all seasons/schools. Temperature and RH fell out of the comfort zone in October–December, during which pollutant concentrations were considerably increased, specifically in November, that heating and dust transport periods coincide. The overall mean indoor PM10 and PM2.5 levels were 58 and 31.8 μg/m3, respectively. Risk assessment indicate that both short (incidence of asthma symptoms in asthmatic children) and long‐term (prevalence of bronchitis) effects are considerable with 10.9 (2.4–19.6)% and 19.5 (2.2–38.8)%, respectively. The findings suggest that mechanical ventilation retrofitting with particle filtration is needed to mitigate potential negative health consequences on children.
Öz Proje yönetiminin en önemli işlevlerinden biri, projenin zaman ve maliyet olarak takibi ve kontrolüdür. Ancak günümüz inşaat sektörü rekabet koşullarında müşteri memnuniyeti, kalite odaklı ölçülmektedir. Bu noktada sektörde müşterinin kalite anlamında yapılan işi görebildiği ve değerlendirdiği son nokta ince inşaat işleri olduğundan, her ne kadar imalatlar bitti denilse de teslimatlarda üst yönetimin veya müşterinin beğenmediği ve düzeltilmesini istediği birçok ilave işler çıkmaktadır. Son anda yapılması istenilen düzeltme ve proje dışı işler, önemli bir zaman ve maliyet kaybına neden olmaktadır. Bu çalışmada, öncelikle aynı bölgede birbirine benzer üç ayrı konut projesine (A, B ve C projeleri) ait ince inşaat işlerinin dokuz farklı imalat kalemine Kazanılmış Değer Analizi (KDA) uygulanmış, zaman ve maliyet parametreleri hesaplanmıştır. Daha sonra her bir imalat için teslimat aşamasında müşteri beklentilerini sağlamak ve hedeflenen kaliteyi yakalamak adına harcanan ilave maliyet ve süreleri hesaba katılarak yeniden KDA uygulanarak süre ve maliyet endekslerinin değişimleri hesaplanmıştır. 1. ve 2. analiz sonuçlarına göre her üç projede ele alınan kümülatif zaman ve maliyet endekslerine bakıldığında A projesinin program başarı endeksi (SPI) değerinde %4, maliyet başarı endeksi (CPI) değerinde %10, B projesinin SPI değerinde %2, CPI değerinde %9, C projesinin ise SPI değerinde %2, CPI değerinde %6 oranında azalma görülmüştür. Bu durum her üç projede de maliyet ve zaman olarak artış olduğunu göstermiştir 1. ve 2. KDA sonuçlarına göre imalat düzeyinde SPI değerleri kıyaslandığında en fazla süre kaybına neden olan imalatın %5'lik düşüşle alçı sıva imalatı olduğu, imalat düzeyinde CPI değerleri kıyaslandığında ise en fazla maliyet kaybının %23'lük düşüşle boya imalatı olduğu tespit edilmiştir. Sonuç olarak bu çalışmada, sadece bütçe ve zaman unsurlarını hesaba katan KDA'ya kalite faktörünün de dâhil edilmesiyle performans endekslerinde oluşacak değişim incelenmiştir. Kalite faktörünün KDA'ya eklenmesiyle proje ve imalat düzeyi performans endekslerinde düşüş (yani maliyette ve sürede artış) olduğu görülmüştür.
Özet: Modern tarımın yaygınlaşmasıyla birlikte dünyada pestisit kullanımı artmıştır. Birçok ülkede olduğu gibi ülkemizde de aşırı ve bilinçsizce pestisit kullanımı sonucunda su ve toprak ortamında giderek artan miktarlarda pestisit kirlenmesi görülmektedir. Meriç-Ergene Havzası'nda bulunan ve etrafında yoğun bir şekilde çeltik tarımı yapılan Meriç Deltası sulak alanları da bu kirlenmenin görüldüğü bölgelerden biridir. Bu çalışma kapsamında, Meriç Deltası sulak alanlarından numuneler alınarak organofosfatlı pestisitlerin akıbeti incelenmiştir. Sulak alanları temsil etmesi amacıyla pilot ölçekli reaktörle çalışılmış, seçilen 4 organofosfatlı pestisit (Chlorpyrifos, Dichlorvos, Fenthion, Diazinon) için biyolojik ayrışma ve adsorpsiyon deneyleri yapılmıştır. Pilot ölçekli sistemde, seçilen pestisitlerin yarı ömürleri belirlenmiş ve bitki ve sediment üzerine adsorpsiyon miktarları ölçülmüştür. Aynı zamanda pestisitlerin yeraltı suyuna sızma potansiyelleri GUS ("Groundwater Ubiquity Score" / "Yeraltı Suyunda Mevcudiyet Katsayısı") kullanılarak hesaplanmıştır. Elde edilen sonuçlar serbest yüzey akışlı yapay sulak alan sistemlerinin organofosfatlı pestisitlerin giderimindeki etkinliğini ortaya koymuştur. Bu çalışmadan elde edilen sonuçlar, organofosfatlı pestisitlerin giderimi için önerilen yapay sulak alanların tasarımı için yol gösterici niteliktedir.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.