Accurate dynamical models of the Antarctic ice sheet with carefully specified initial conditions and well-calibrated rheological parameters are needed to forecast global sea level. By adapting an inverse method previously used in electric impedance tomography, we infer present-day flow speeds within the ice sheet. This inversion uses satellite observations of surface velocity, snow accumulation rate, and rate of change of surface elevation to estimate the basal drag coefficient and an ice stiffness parameter that influences viscosity. We represent interior ice motion using a vertically integrated approximation to incompressible Stokes flow. This model represents vertical shearing within the ice and membrane stresses caused by horizontal stretching and shearing. Combining observations and model, we recover marked geographical variations in the basal drag coefficient. Relative changes in basal shear stress are smaller. No simple sliding law adequately represents basal shear stress as a function of sliding speed. Low basal shear stress predominates in central East Antarctica, where thick insulating ice allows liquid water at the base to lubricate sliding. Higher shear stress occurs in coastal East Antarctica, where a frozen bed is more likely. Examining Thwaites glacier in more detail shows that the slowest sliding often coincides with elevated basal topography. Differences between our results and a similar adjoint-based inversion suggest that inversion or regularization methods can influence recovered parameters for slow sliding and finer scales; on broader scales we recover a similar pattern of low basal drag underneath major ice streams and extensive regions in East Antarctica that move by basal sliding.

We use an ice sheet model with realistic initial conditions to forecast how the Amundsen Sea sector of West Antarctica responds to recently observed rates of submarine melting. In these simulations, we isolate the effects of a positive feedback, driven by submarine melt in new ocean cavities flooded during retreat, by allowing the present climate, calving front and melting beneath existing ice shelves to persist over the 21st century. Even without additional forcing from changes in climate, ice shelf collapse, or ice cliff collapse, the model predicts slow, sustained retreat of West Antarctica, driven by the marine ice sheet instability and current levels of ocean‐driven melting. When observed rates of melting are included in new subglacial ocean cavities, the simulated sea level contribution increases, and for sufficiently intense melting it accelerates over time. Conditional Bayesian probabilities for sea level contributions can be derived but will require improved predictions of ocean heat delivery.

Abstract. We present the result of the third Marine Ice Sheet Model Intercomparison Project, MISMIP+. MISMIP+ is intended to be a benchmark for ice-flow models which include fast sliding marine ice streams and floating ice shelves and in particular a treatment of viscous stress that is sufficient to model buttressing, where upstream ice flow is restrained by a downstream ice shelf. A set of idealized experiments first tests that models are able to maintain a steady state with the grounding line located on a retrograde slope due to buttressing and then explore scenarios where a reduction in that buttressing causes ice stream acceleration, thinning, and grounding line retreat. The majority of participating models passed the first test and then produced similar responses to the loss of buttressing. We find that the most important distinction between models in this particular type of simulation is in the treatment of sliding at the bed, with other distinctions – notably the difference between the simpler and more complete treatments of englacial stress but also the differences between numerical methods – taking a secondary role.