In this paper, a methodology is described aiming at assessing the variability causes, affecting the measurement instruments typically used in the automotive sector for the analysis of dimensional defects of coupled components, to check the conformity of the width of the gap between two adjacent parts and the profile, i.e. the alignment of the two surfaces. The inspection may be performed by means of different gap/flush tools, such as feeler gages, calipers and Laser scanner devices; depending on the choice, a different measurand has to be considered. The obtained measurements need to be consistent, because these devices are used indistinctly, depending on the severity of the control and on the typology of the control itself. The paper proposes a methodology to verify the metrological conformity of measurements provided by both traditional and laser-based instruments, so that it is possible to interpret them in an interchanging manner. A 3D geometric model is realized, used as a basis for the analysis of the most influencing uncertainty causes and measurement biases. The methodology will demonstrate to be able to identify and evaluate in a parametric way, the typical variability causes of the instruments considered. It will also highlight possible improvements in the integration of the obtained results.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.