The crustal structure of the Anatolian plateau in Eastern Turkey is investigated using receiver functions obtained from the teleseismic recordings of a 29 broadband PASSCAL temporary network, i.e., the Eastern Turkey Seismic Experiment [ETSE]. The S‐wave velocity structure was estimated from the stacked receiver functions by performing a 6‐plane layered grid search scheme in order to model the first order features in the receiver functions with minimum trade‐off. We found no significant crustal root beneath the western portion of the network, but there is some evidence of crustal thickening in the northern portion of the network. We found an average crustal thickness of 45 km and an average crustal shear velocity of 3.7 km/s for the entire eastern Anatolian plateau. Within the Anatolian plateau we found evidence of a prominent low velocity zone where the crust thickness is approximately 46 km. These results suggests that the 2 km high topography across the Anatolian plateau is dynamically supported because most of the plateau appears to be isostatically under‐compensated. Also, there appears to be a region of thin crust at the easternmost edge of the Anatolian plateau that may be a relic from the accretion of island arcs to the Eurasian plate.

We have determined the shear wave splitting fast polarization direction and delay time using data from the ETSE broadband experiment (Eastern Turkey Seismic Experiment), a deployment of 29 broadband seismic stations across the collision zone of the Arabian, Eurasian, and Anatolian plates. Our results show that the fast polarization directions are relatively uniform and they exhibit primarily NE–SW orientations. No abrupt changes in anisotropy directions are observed across the main tectonic units in the region: the Bitlis Suture (BS) and the North and Eastern Anatolian Fault zones. The fast polarization directions are determined to be sub‐parallel to the Anatolian, Arabian, and Eurasian absolute plate velocities, except for those stations in the northeastern corner of the Anatolian Plateau. Observed delay times range from 0.7 to 2.0 seconds with an average value of 1.0 second; the largest values are within the northern Anatolian Plateau which is underlain by an exceptionally low velocity zone in the uppermost mantle. We interpret shear wave splitting as the vector difference of the Eurasian lithosphere and northeastern or southwestern directed flow of the asthenospheric mantle. Comparisons of the polarization anisotropy with measurements of Pn azimuthal anisotropy suggest vertical anisotropic layering except in those areas which are underlain by partially molten uppermost mantle.

Abstract:Observations based on relatively limited data recorded by sparsely distributed stations have indicated that regional seismic phase propagation (Lg and Sn) is very complex in the Middle East. Accurate characterization of regional seismic wave propagation in this region necessitates the use of a large number of seismic stations. We have compiled a large data set of regional and local seismograms recorded in the Middle East. This data set comprises approximately four years of data from national short-period networks in Turkey and Syria, data from temporary broad band arrays in Saudi Arabia and the Caspian Sea region, and data from GSN, MEDNET, and GEOFON stations in the Middle East. We have used this data set to decipher the character and pattern of regional seismic wave propagation. We have mapped zones of blockage as well as inefficient and efficient propagation for Lg, Pg, and Sn throughout the Middle East. Two tomographic techniques have been developed in order to objectively determine regions of lithospheric attenuation in the Middle East.We observe evidence of major increase in Lg attenuation, relative to Pg, across the Bitlis suture and the Zagros fold and thrust belt, corresponding to the boundary between the Arabian and Eurasian plates. We also observe a zone of inefficient Sn propagation along the Dead Sea fault system which coincides with low Pn velocities along most of the Dead Sea fault system and with previous observations of poor Sn propagation in western Jordan. Our observations indicate that in the northern portion of the Arabian plate (south of the Bitlis suture) there is also a zone of inefficient Sn propagation that would not have been predicted from prior measurements of relatively low Pn velocities. Mapped high attenuation of Sn correlates well with regions of Cenozoic and Holocene basaltic volcanism. These regions of uppermost mantle shear-wave attenuation most probably have anomalously hot and possibly thin lithosphere.