Abstruct-An interferometric fiber-optic sensor using a light emitting diode (LED) as the optical source is analyzed and demonstrated. The sensor arrangement employs two Fabry-Perot interferometers (FPl's) in series, one for sensing and one which serves as a reference. The optical output from the LED is spectrally modulated by reflection from the sensing FPI. Then, reflection or transmission by the reference FPI produces an interferometric beat response similar to that observed when a laser is used with the sensing interferometer alone. Best fringe visibility is obtained when the optical path lengths of the two interferometers are matched, and the fringes disappear when the path length difference becomes substantially greater than the coherence length of the LED. The predicted behavior is confirmed by experiments in which the temperature of the sensor FPI is changed while that of the reference is held constant.

No abstract

A fiber-optic ultrasound sensor is presented. The sensor consists of a continuous length of single-mode optical fiber with a built-in Fabry-Perot interferometer. The acoustic pressure produces changes in the index of refraction along the interferometer cavity through the strain-optic effect, thus modulating the reflected power of the light propagating in the fiber. The dielectric internal mirrors that form the interferometer are fabricated by joining a fiber coating with a TiO(2) film at one end to an uncoated fiber by electric arc fusion splicing. Experimental results have been obtained for sensors embedded in plastic and graphite composite materials, using ultrasound waves in the range from 100 kHz to 5 MHz. Values for the optical phase shift amplitude as large as 0.5 rad were obtained at an acoustic frequency of 200 kHz for a 1.1-cm-long interferometer embedded in plastic.

No abstract

No abstract

No abstract

No abstract

No abstract