No abstract

Although distraction osteogenesis has solved limb length discrepancies, many complications are inevitable from long duration of external fixation. Use of intramedullary nails for early removal of fixators has its own challenges especially in pediatric age group. To facilitate early removal of external fixators in children, we tried a novel method of submuscular plating over the distraction callus, which is described, and the results and complications of this technique are presented. In eight children (four girls and four boys), of limb lengthening (four cases) and bone transport (four cases) done in three femurs and five tibiae with external fixators (five Ilizarov ring fixators and three monofixators), submuscular plating was done over the distraction callus. The causes of limb length discrepancy included traumatic and septic growth arrest, congenital pseudoarthrosis of tibia, fibular hemimelia, tumor salvage, and Perthes' disease. The purpose of plating was to remove the external fixator earlier after achieving the target length. Mean age of plating procedure was 11.62 years, and mean amount of distraction was 5.47 cm. In all patients, the distraction callus healed on maintaining its length or correcting into the original alignment. The mean external fixation index was 26.93 days/cm and healing index was 52.01 days/cm. One complication of superficial pin-track infection occurred, which resolved completely with conservative treatment. None of the patients developed deep infection or implant failures. The mean follow-up after plating was 28 months (range, 18-62 months). Submuscular plating over the distraction callus may be a successful method that permits early removal of fixator with fewer complications. This method can be a useful alternative in children or when nailing is difficult.

No abstract

No abstract

BackgroundThere have been many studies that utilize the bio-impedance measurement method to analyze the movements of the upper and lower limbs. A fixed electrical current flows into the limbs through four standard disposable electrodes in this method. The current flows in the muscles and blood vessels, which have relatively low resistivity levels in the human body. This method is used to measure bio-impedance changes following volume changes of muscles and blood vessels around a knee joint. The result of the bio-impedance changes is used to evaluate the movements. However, the method using the standard disposable electrodes has a restriction related to its low bio-impedance changes: the standard disposable electrodes are only able to measure bio-impedance from a limited part of a muscle. Moreover, it is impossible to use continuously, as the electrodes are designed to be disposable. This paper describes a conductive fabric sensor (CFS) using a bio-impedance measurement method and determines the optimum configuration of the sensor for estimating knee joint movements.MethodsThe upper side of subjects' lower limbs was divided into two areas and the lower side of subjects' lower limbs was divided into three areas. The spots were matched and 6 pairs were selected. Subjects were composed of 15 males (age: 30.7 ± 5.3, weight: 69.8 ± 4.2 kg, and height: 173.5 ± 2.8 cm) with no known problems with their knee joints. Bio-impedance changes according to knee joint flexion/extension assessments were calculated and compared with bio-impedance changes by an ankle joint flexion/extension test (SNR I) and a hip joint flexion/extension test (SNR II).ResultsThe bio-impedance changes of the knee joint flexion/extension assessment were 35.4 ± 20.0 Ω on the (1, 5) pair. SNR I was 3.8 ± 8.4 and SNR II was 6.6 ± 7.9 on the (1, 5) pair.ConclusionsThe optimum conductive fabric sensor configuration for evaluating knee joint movements were represented by the (1, 5) pair.

No abstract

The e-health infrastructure in Korea has come a long way within a short period since the establishment of the Korea e-Health Association in 2003 by the Korean Ministry of Commerce, Industry and Energy. Since then, four related government departments in the Ministry of Health and Welfare, Ministry of Information and Communication, Ministry of National Defense, and the Ministry of Science and Technology have also started planning and promoting their own strategies for e-Health applications. We have defined standardization, law and policy planning, human resources development, research and development for e-health products, and international collaboration as the five core pillars for the development of a successful e-health industry. In 2008, through the reorganization of government ministries, e-health has become an even more important growth industry for the Korean economy. Consequently, relevant government ministries have more concrete and robust action plans for realization of e-health in effect.

c-Health Research Center(EHRC) has constructed electronic communication and information in the health sector APEC e-Health Portal Site whose address is "apec.ehrc.re.kr" for and the use in the health sector of digital data -transmitted,