Data assimilation (DA) methods for convective‐scale numerical weather prediction at operational centres are surveyed. The operational methods include variational methods (3D‐Var and 4D‐Var), ensemble methods (LETKF) and hybrids between variational and ensemble methods (3DEnVar and 4DEnVar). At several operational centres, other assimilation algorithms, like latent heat nudging, are additionally applied to improve the model initial state, with emphasis on convective scales. It is demonstrated that the quality of forecasts based on initial data from convective‐scale DA is significantly better than the quality of forecasts from simple downscaling of larger‐scale initial data. However, the duration of positive impact depends on the weather situation, the size of the computational domain and the data that are assimilated. Furthermore it is shown that more advanced methods applied at convective scales provide improvements over simpler methods. This motivates continued research and development in convective‐scale DA. Challenges in research and development for improvements of convective‐scale DA are also reviewed and discussed. The difficulty of handling the wide range of spatial and temporal scales makes development of multi‐scale assimilation methods and space–time covariance localization techniques important. Improved utilization of observations is also important. In order to extract more information from existing observing systems of convective‐scale phenomena (e.g. weather radar data and satellite image data), it is necessary to provide improved statistical descriptions of the observation errors associated with these observations.

Abstract. Currently, no extensive, near real time, global soil moisture observation network exists. Therefore, the Met Office global soil moisture analysis scheme has instead used observations of screen temperature and humidity. A number of new space-borne remote sensing systems, operating at microwave frequencies, have been developed that provide a more direct retrieval of surface soil moisture. These systems are attractive since they provide global data coverage and the horizontal resolution is similar to weather forecasting models. Several studies show that measurements of normalised backscatter (surface soil wetness) from the Advanced Scatterometer (ASCAT) on the meteorological operational (MetOp) satellite contain good quality information about surface soil moisture. This study describes methods to convert ASCAT surface soil wetness measurements to volumetric surface soil moisture together with bias correction and quality control. A computationally efficient nudging scheme is used to assimilate the ASCAT volumetric surface soil moisture data into the Met Office global soil moisture analysis. This ASCAT nudging scheme works alongside a soil moisture nudging scheme that uses observations of screen temperature and humidity. Trials, using the Met Office global Unified Model, of the ASCAT nudging scheme show a positive impact on forecasts of screen temperature and humidity for the tropics, North America and Australia. A comparison with in-situ soil moisture measurements from the US also indicates that assimilation of ASCAT surface soil wetness improves the soil moisture analysis. Assimilation of ASCAT surface soil wetness measurements became operational during July 2010.

Surface precipitation‐rate estimates derived from radar data are potentially of considerable value to high‐resolution Numerical Weather Prediction (NWP) models. This paper describes a scheme developed to assimilate precipitation rates derived from the UK weather radar network into the UK Met. Office Mesoscale Model, with the aim of improving the analysis and forecast of precipitation. It is based on ‘latent heat nudging’, in which the model profiles of latent heating are scaled by the ratio of observed and model precipitation rates. This causes the model to adjust so that the diagnosed precipitation rate agrees more closely with observations. The assimilation algorithm is outlined, and the results of a trial of the scheme are described. The scheme brings an increase in forecast skill for precipitation distribution in the first six to nine hours of the forecast, a conclusion supported both by objective verification against radar data and subjective assessment of 14 forecasts. The main benefit was found to occur in frontal cases. The scheme was implemented operationally on 16 April 1996. Copyright © 1997 Royal Meteorological Society

ABSTRACT:The formulation and performance of the Met Office visibility analysis and prediction system are described. The visibility diagnostic within the limited-area Unified Model is a function of humidity and a prognostic aerosol content. The aerosol model includes advection, industrial and general urban sources, plus boundary-layer mixing and removal by rain. The assimilation is a 3-dimensional variational scheme in which the visibility observation operator is a very nonlinear function of humidity, aerosol and temperature. A quality control scheme for visibility data is included. Visibility observations can give rise to humidity increments of significant magnitude compared with the direct impact of humidity observations. We present the results of sensitivity studies which show the contribution of different components of the system to improved skill in visibility forecasts. Visibility assimilation is most important within the first 6-12 hours of the forecast and for visibilities below 1 km, while modelling of aerosol sources and advection is important for slightly higher visibilities (1-5 km) and is still significant at longer forecast times.

The status of current efforts to assimilate cloud-and precipitation-affected satellite data is summarised with special focus on infrared and microwave radiance data obtained from operational Earth observation satellites. All global centres pursue efforts to enhance infrared radiance data usage due to the limited availability of temperature observations in cloudy regions where forecast skill is estimated to strongly depend on the initial conditions. Most systems focus on the sharpening of weighting functions at cloud top providing high vertical resolution temperature increments to the analysis, mainly in areas of persistent high and low cloud cover. Microwave radiance assimilation produces impact on the deeper atmospheric moisture structures as well as cloud microphysics and, through control variable and background-error formulation, also on temperature but to lesser extent than infrared data. Examples of how the impacts of these two observation types are combined are shown for subtropical low-level cloud regimes. The overall impact of assimilating such data on forecast skill is measurably positive despite the fact that the employed assimilation systems have been constructed and optimized for clear-sky data. This leads to the conclusion that a better understanding and modelling of model processes in cloud-affected areas and data assimilation system enhancements through inclusion of moist processes and their error characterization will contribute substantially to future forecast improvement.