The dilatational rheological properties of monolayers of poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide)-type block copolymers at the air-water interface have been investigated by employing an oscillating ring trough method. The properties of adsorbed monolayers were compared to spread layers over a range of surface concentrations. The studied polymers were PEO26-PPO39-PEO26 (P85), PEO103-PPO40-PEO103 (F88), and PEO99-PPO65-PEO99 (F127). Thus, two of the polymers have similar PPO block size and two of them have similar PEO block size, which allows us to draw conclusions about the relationship between molecular structure and surface dilatational rheology. The dilatational properties of adsorbed monolayers were investigated as a function of time and bulk solution concentration. The time dependence was found to be rather complex, reflecting structural changes in the layer. When the dilatational modulus measured at different concentrations was replotted as a function of surface pressure, one unique master curve was obtained for each polymer. It was found that the dilatational behavior of spread (Langmuir) and adsorbed (Gibbs) monolayers of the same polymer is close to identical up to surface concentrations of approximately 0.7 mg/m2. At higher coverage, the properties are qualitatively alike with respect to dilatational modulus, although some differences are noticeable. Relaxation processes take place mainly within the interfacial layers by a redistribution of polymer segments. Several conformational transitions were shown to occur as the area per molecule decreased. PEO desorbs significantly from the interface at segmental areas below 20 A(2), while at higher surface coverage, we propose that segments of PPO are forced to leave the interface to form a mixed sublayer in the aqueous region.

Nonequilibrium interfacial layers formed by competitive adsorption of beta-lactoglobulin and the nonionic triblock copolymer PEO99-PPO65-PEO99 (F127) to the air-water interface were investigated in order to explain the influence of polymeric surfactants on protein film surface rheology and foam stability. Surface dilatational and shear rheological methods, surface tension measurements, dynamic thin-film measurements, diffusion measurements (from fluorescence recovery after photo bleaching), and determinations of foam stability were used as methods. The high surface viscoelasticity, both the shear and dilatational, of the protein films was significantly reduced by coadsorption of polymeric surfactant. The drainage rate of single thin films, in the presence of beta-lactoglobulin, increased with the amount of added F127, but equilibrium F127 films were found to be thicker than beta-lactoglobulin films, even at low concentration of the polymeric surfactant. It is concluded that the effect of the nonionic triblock copolymer on the interfacial rheology of beta-lactoglobulin layers is similar to that of low molecular weight surfactants. They differ however in that F127 increases the thickness of thin liquid films. In addition, the significant destabilizing effect of low molecular weight surfactants on protein foams is not found in the investigated system. This is explained as due to long-range steric forces starting to stabilize the foam films at low concentrations of F127.

Ellipsometry was used to determine the adsorbed layer thickness (d) and the surface excess (adsorbed amount, Gamma) of a nonionic diblock copolymer, E(106)B(16), of poly(ethylene oxide) (E) and poly(butylene oxide) (B) at the air-water interface. The results were obtained (i) by the conventional ellipsometric evaluation procedure using the change of both ellipsometric angles Psi and Delta and (ii) by using the change of Delta only and assuming values of the layer thickness. It was demonstrated that the calculated surface excesses from the different methods were in close agreement, independent of the evaluation procedure, with a plateau adsorption of about 2.5 mg/m(2) (400 A(2)/molecule). Furthermore, the amount of E(106)B(16) adsorbed at the air-water interface was found to be almost identical to that adsorbed from aqueous solution onto a hydrophobic solid surface. In addition, the possibility to use combined measurements with H(2)O or D(2)O as substrates to calculate values of d and Gamma was investigated and discussed. We also briefly discuss within which limits the Gibbs equation can be used to determine the surface excess of polydisperse block copolymers.