No abstract

Thermally stratified compression ignition is a new advanced, low-temperature combustion mode that aims to control the heat release process in a lean, premixed, compression ignition combustion mode by controlling the level of thermal stratification in the cylinder. Specifically, this work uses a mixture of 80% ethanol and 20% water by mass, referred to as “wet ethanol” herein, to increase thermal stratification via evaporative cooling of areas targeted by an injection event during the compression stroke. The experiments conducted aim to both fundamentally understand the effect that a late cycle injection of wet ethanol has on the heat release process, and to use that effect to explore the high-load limit of thermally stratified compression ignition with wet ethanol. At an equivalence ratio of 0.5, injecting just 8% of the fuel during the compression stroke was shown to reduce the peak heat release rate by a factor of 2, subsequently avoiding excessive pressure rise rates. Under pure homogeneous charge compression ignition using wet ethanol as the fuel, the load range was found to be 2.5–3.9 bar gross indicated mean effective pressure. Using a split injection of wet ethanol, the high-load limit was extended to 7.0 bar gross indicated mean effective pressure under naturally aspirated conditions. Finally, intake boost was used to achieve high-load operation with low NOx (oxides of nitrogen (NO or NO2)) emissions and was shown to further increase the high-load limit to 7.6 bar gross indicated mean effective pressure at an intake pressure of 1.43 bar. These results show the ability of a split injection of wet ethanol to successfully control the heat release process and expand the operable load range in low-temperature combustion.

No abstract

No abstract

No abstract

No abstract

No abstract

No abstract