In the spring and summer of 2001, 47 fathers, 48 mothers and 117 children of Iowa farm and non-farm households were recruited to participate in a study investigating take-home pesticide exposure. On two occasions approximately 1 month apart, urine samples from each participant and dust samples from various rooms were collected from each household and were analyzed for atrazine, metolachlor, glyphosate and chlorpyrifos or their metabolites. The adjusted geometric mean (GM) level of the urine metabolite of atrazine was significantly higher in fathers, mothers and children from farm households compared with those from non-farm households (P < or = 0.0001). Urine metabolites of chlorpyrifos were significantly higher in farm fathers (P = 0.02) and marginally higher in farm mothers (P = 0.05) when compared with non-farm fathers and mothers, but metolachlor and glyphosate levels were similar between the two groups. GM levels of the urinary metabolites for chlorpyrifos, metolachlor and glyphosate were not significantly different between farm children and non-farm children. Farm children had significantly higher urinary atrazine and chlorpyrifos levels (P = 0.03 and P = 0.03 respectively) when these pesticides were applied by their fathers prior to sample collection than those of farm children where these pesticides were not recently applied. Urinary metabolite concentration was positively associated with pesticide dust concentration in the homes for all pesticides except atrazine in farm mothers; however, the associations were generally not significant. There were generally good correlations for urinary metabolite levels among members of the same family.
Twenty-five farm (F) households and 25 nonfarm (NF) households in Iowa were enrolled in a study investigating agricultural pesticide contamination inside homes. Air, surface wipe, and dust samples were collected. Samples from 39 homes (20 F and 19 NF) were analyzed for atrazine, metolachlor, acetochlor, alachlor, and chlorpyrifos. Samples from 11 homes (5 F and 6 NF) were analyzed for glyphosate and 2,4-Dichlorophenoxyac etic acid (2,4-D). Greater than 88% of the air and greater than 74% of the wipe samples were below the limit of detection (LOD). Among the air and wipe samples, chlorpyrifos was detected most frequently in homes. In the dust samples, all the pesticides were detected in greater than 50% of the samples except acetochlor and alachlor, which were detected in less than 30% of the samples. Pesticides in dust samples were detected more often in farm homes except 2,4-D, which was detected in 100% of the farm and nonfarm home samples. The average concentration in dust was higher in farm homes versus nonfarm homes for each pesticide. Further analysis of the data was limited to those pesticides with at least 50% of the dust samples above the LOD. All farms that sprayed a pesticide had higher levels of that pesticide in dust than both farms that did not spray that pesticide and nonfarms; however, only atrazine and metolachlor were significantly higher. The adjusted geometric mean pesticide concentration in dust for farms that sprayed a particular pesticide ranged from 94 to 1300 ng/g compared with 12 to 1000 ng/g for farms that did not spray a particular pesticide, and 2.4 to 320 ng/g for nonfarms. The distributions of the pesticides throughout the various rooms sampled suggest that the strictly agricultural herbicides atrazine and metolachlor are potentially being brought into the home on the farmer's shoes and clothing. These herbicides are not applied in or around the home but they appear to be getting into the home para-occupationally. For agricultural pesticides, take-home exposure may be an important source of home contamination.
An algorithm developed to estimate pesticide exposure intensity for use in epidemiologic analyses was revised based on data from two exposure monitoring studies. In the first study, we estimated relative exposure intensity based on the results of measurements taken during the application of the herbicide 2,4-dichlorophenoxyacetic acid (2,4-D) (n = 88) and the insecticide chlorpyrifos (n = 17). Modifications to the algorithm weighting factors were based on geometric means (GM) of post-application urine concentrations for applicators grouped by application method and use of chemically-resistant (CR) gloves. Measurement data from a second study were also used to evaluate relative exposure levels associated with airblast as compared to hand spray application methods. Algorithm modifications included an increase in the exposure reduction factor for use of CR gloves from 40% to 60%, an increase in the application method weight for boom spray relative to in-furrow and for air blast relative to hand spray, and a decrease in the weight for mixing relative to the new weights assigned for application methods. The weighting factors for the revised algorithm now incorporate exposure measurements taken on Agricultural Health Study (AHS) participants for the application methods and personal protective equipment (PPE) commonly reported by study participants.
This study presents exposure data for various metal oxides in facilities that produce or use nanoscale metal oxides. Exposure assessment surveys were conducted at seven facilities encompassing small, medium, and large manufacturers and end users of nanoscale (particles <0.1 μm diameter) metal oxides, including the oxides of titanium, magnesium, yttrium, aluminum, calcium, and iron. Half- and full-shift sampling consisting of various direct-reading and mass-based area and personal aerosol sampling was employed to measure exposure for various tasks. Workers in large facilities performing handling tasks had the highest mass concentrations for all analytes. However, higher mass concentrations occurred in medium facilities and during production for all analytes in area samples. Medium-sized facilities had higher particle number concentrations in the air, followed by small facilities for all particle sizes measured. Production processes generally had the highest particle number concentrations, particularly for the smaller particles. Similar to particle number, the medium-sized facilities and production process had the highest particle surface area concentration. TEM analysis confirmed the presence of the specific metal oxides particles of interest, and the majority of the particles were agglomerated, with the predominant particle size being between 0.1 and 1 μm. The greatest potential for exposure to workers occurred during the handling process. However, the exposure is occurring at levels that are well below established and proposed limits.
During an investigation conducted December 17–20, 2001, we collected environmental samples from a U.S. postal facility in Washington, D.C., known to be extensively contaminated with Bacillus anthracis spores. Because methods for collecting and analyzing B. anthracis spores have not yet been validated, our objective was to compare the relative effectiveness of sampling methods used for collecting spores from contaminated surfaces. Comparison of wipe, wet and dry swab, and HEPA vacuum sock samples on nonporous surfaces indicated good agreement between results with HEPA vacuum and wipe samples. However, results from HEPA vacuum sock and wipe samples agreed poorly with the swab samples. Dry swabs failed to detect spores >75% of the time they were detected by wipe and HEPA vacuum samples. Wipe samples collected after HEPA vacuum samples and HEPA vacuum samples after wipe samples indicated that neither method completely removed spores from the sampled surfaces.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.