In spite of trying to understand processes in the same spatial domain, the catchment hydrology and water quality scientific communities are relatively disconnected and so are their respective models. This is emphasized by an inadequate representation of transport processes, in both catchment-scale hydrological and water quality models. While many hydrological models at the catchment scale only account for pressure propagation and not for mass transfer, catchment scale water quality models are typically limited by overly simplistic representations of flow processes. With the objective of raising awareness for this issue and outlining potential ways forward we provide a nontechnical overview of (1) the importance of hydrology-controlled transport through catchment systems as the link between hydrology and water quality; (2) the limitations of current generation catchment-scale hydrological and water quality models; (3) the concept of transit times as tools to quantify transport; and (4) the benefits of transit time based formulations of solute transport for catchment-scale hydrological and water quality models. There is emerging evidence that an explicit formulation of transport processes, based on the concept of transit times has the potential to improve the understanding of the integrated system dynamics of catchments and to provide a stronger link between catchment-scale hydrological and water quality models.

Knowledge about the relationship between microbial community structure and hydrogeochemistry (e.g., pollution, redox and degradation processes) in landfill leachate-polluted aquifers is required to develop tools for predicting and monitoring natural attenuation. In this study analyses of pollutant and redox chemistry were conducted in parallel with culture-independent profiling of microbial communities present in a well-defined aquifer (Banisveld, The Netherlands). Degradation of organic contaminants occurred under iron-reducing conditions in the plume of pollution, while upstream of the landfill and above the plume denitrification was the dominant redox process. Beneath the plume iron reduction occurred. Numerical comparison of 16S ribosomal DNA (rDNA)-based denaturing gradient gel electrophoresis (DGGE) profiles of Bacteria and Archaea in 29 groundwater samples revealed a clear difference between the microbial community structures inside and outside the contaminant plume. A similar relationship was not evident in sediment samples. DGGE data were supported by sequencing cloned 16S rDNA. Upstream of the landfill members of the ␤ subclass of the class Proteobacteria (␤-proteobacteria) dominated. This group was not encountered beneath the landfill, where gram-positive bacteria dominated. Further downstream the contribution of gram-positive bacteria to the clone library decreased, while the contribution of ␦-proteobacteria strongly increased and ␤-proteobacteria reappeared. The ␤-proteobacteria (Acidovorax, Rhodoferax) differed considerably from those found upstream (Gallionella, Azoarcus). Direct comparisons of cloned 16S rDNA with bands in DGGE profiles revealed that the data from each analysis were comparable. A relationship was observed between the dominant redox processes and the bacteria identified. In the iron-reducing plume members of the family Geobacteraceae made a strong contribution to the microbial communities. Because the only known aromatic hydrocarbon-degrading, iron-reducing bacteria are Geobacter spp., their occurrence in landfill leachate-contaminated aquifers deserves more detailed consideration.Contamination of groundwater is a serious environmental problem throughout the world as it affects drinking water resources and has an impact on oligotrophic environments. In The Netherlands, an important source of contamination is landfill leachate. In the past, landfilling was performed without the presence of appropriate liners to prevent percolation of leachate into underlying aquifers. Although many old landfills are closed now, the cessation of landfill operations does not stop chemical release into the environment. Organic compounds originating from household and industrial waste are found in most municipal landfills. Dramatic changes in aquifer geochemistry and microbiology downstream of landfills occur as a result of the high organic load of leachate (11). A sequence of redox zones develops in time and space, as the organic matter is microbiologically degraded and electron acceptors are depleted...

Biodegradation is one of the most favored and sustainable means of removing organic pollutants from contaminated aquifers but the major steering factors are still surprisingly poorly understood. Growing evidence questions some of the established concepts for control of biodegradation. Here, we critically discuss classical concepts such as the thermodynamic redox zonation, or the use of steady state transport scenarios for assessing biodegradation rates. Furthermore, we discuss if the absence of specific degrader populations can explain poor biodegradation. We propose updated perspectives on the controls of biodegradation in contaminant plumes. These include the plume fringe concept, transport limitations, and transient conditions as currently underestimated processes affecting biodegradation.

No abstract

The Rayleigh equation relates the change in isotope ratio of an element in a substrate to the extent of substrate consumption via a single kinetic isotopic fractionation factor (alpha). Substrate consumption is, however, commonly distributed over several metabolic pathways each potentially having a different alpha. Therefore, extended Rayleigh-type equations were derived to account for multiple competing degradation pathways. The value of alpha as expressed in the environment appears a function of the alpha values and rate constants of the various involved degradation pathways. Remarkably, the environmental or apparent alpha value changes and shows non-Rayleigh behavior over a large and relevant concentration interval if Monod kinetics applies and the half-saturation constants of the competing pathways differ. Derived equations were applied to previously published data and enabled (i) quantification of the share that two competing degradation pathways had on aerobic 1,2-dichloroethane (1,2-DCA) biodegradation in laboratory batch experiments and (ii) calculation of the extent of methyl tert-butyl ether (MTBE) biodegradation shared over aerobic and anaerobic degradation at a field site by means of an improved solution to two-dimensional (carbon and hydrogen) compound-specific isotope analysis (CSIA).

Compound-specific carbon and hydrogen isotope analysis was used to investigate biodegradation of benzene and ethylbenzene in contaminated groundwater at Dow Benelux BV industrial site. delta13C values for dissolved benzene and ethylbenzene in downgradient samples were enriched by up to 2+/-0.5 per thousand, in 13C, compared to the delta13C value of the source area samples. delta2H values for dissolved benzene and ethylbenzene in downgradient samples exhibited larger isotopic enrichments of up to 27+/-5 per thousand for benzene and up to 50+/-5 per thousand for ethylbenzene relative to the source area. The observed carbon and hydrogen isotopic fractionation in downgradient samples provides evidence of biodegradation of both benzene and ethylbenzene within the study area at Dow Benelux BV. The estimated extents of biodegradation of benzene derived from carbon and hydrogen isotopic compositions for each sample are in agreement, supporting the conclusion that biodegradation is the primary control on the observed differences in carbon and hydrogen isotope values. Combined carbon and hydrogen isotope analyses provides the ability to compare biodegradation in the field based on two different parameters, and hence provides a stronger basis for assessment of biodegradation of petroleum hydrocarbon contaminants.

There is increasing interest in combined carbon−chlorine compound-specific isotope analysis (CSIA) to differentiate between contaminant sources and to assess transformation processes. However, the significant abundance of polychlorinated molecules with several heavy chlorine isotopes complicates the evaluation of chlorine isotope trends. Therefore, the goal of this study was to develop a conceptual and mathematical framework that describes the expected chlorine isotope fractionation patterns during multistep transformation of chlorinated compounds. Reductive dechlorination of chlorinated ethenes served as an example. The study demonstrates that chlorine isotope trends can be simulated by reproducing the average behavior of light and heavy isotopes or by explicitly simulating molecules with different numbers of heavy isotopes (isotopologues). The calculations reveal that initial chlorine isotope ratios of products equal the isotope ratios of their parent compounds in the absence of secondary isotope effects, while steadily increasing during transformation. The slopes in dual isotope plots are linear for reactant and product during a one-step reaction. They become nonlinear for products that are degraded further but converge to characteristic slopes. Consideration of different scenarios reveals that combined carbon−chlorine isotope analysis bears high potential to differentiate between contaminant sources, to elucidate reaction mechanisms in laboratory studies, and to identify transformation processes in the field.

Carbon (C), chlorine (Cl), and hydrogen (H) isotope effects were determined during dechlorination of TCE to ethene by a mixed Dehalococcoides (Dhc) culture. The C isotope effects for the dechlorination steps were consistent with data published in the past for reductive dechlorination (RD) by Dhc. The Cl effects (combined with an inverse H effect in TCE) suggested that dechlorination proceeded through nucleophilic reactions with cobalamin rather than by an electron transfer mechanism. Depletions of (37)Cl in daughter compounds, resulting from fractionation at positions away from the dechlorination center (secondary isotope effects), further support the nucleophilic dechlorination mechanism. Determination of C and Cl isotope ratios of the reactants and products in the reductive dechlorination chain offers a potential tool for differentiation of Dhc activity from alternative transformation mechanisms (e.g., aerobic degradation and reductive dechlorination proceeding via outer sphere mechanisms), in studies of in situ attenuation of chlorinated ethenes. Hydrogenation of the reaction products (DCE, VC, and ethene) showed a major preference for the (1)H isotope. Detection of depleted dechlorination products could provide a line of evidence in discrimination between alternative sources of TCE (e.g., evolution from DNAPL sources or from conversion of PCE).