In osteoarthrosis, pathological features of articular cartilage are associated with degeneration and nanomechanical changes. The aim of this paper is to show that indentation-atomic force microscopy can monitor wear-related biomechanical changes in the hip joint of patients with osteoarthritis. Fifty patients (N = 50), aged 40 to 65, were included in the study. The mechanical properties and the submicron surface morphology of hyaline cartilage were investigated using atomic force microscopy. Measurements of the roughness parameters of cartilage surfaces were performed, including the arithmetic average of absolute values (Ra), the maximum peak height (Rp), and the mean spacing between local peaks (S). The arithmetic mean of the absolute values of the height of healthy cartilage was 86 nm, while wear began at Ra = 73 nm. The maximum changes of values of the roughness parameters differed from the healthy ones by 71%, 80%, and 51% for Ra, Rp, and S, respectively. Young’s modulus for healthy cartilage surfaces ranged from 1.7 to 0.5 MPa. For the three stages of cartilage wear, Young’s modulus increased, and then it approached the maximum value and decreased. AFM seems to be a powerful tool for surface analysis of biological samples as it enables indentation measurements in addition to imaging.

The purpose of this study was twofold. Firstly, we proposed a measurement protocol for the atomic force microscopy (AFM) method to determine the nanomechanical properties of articular cartilage in experimental osteoarthritis in rabbits. Then, we verified if mechanical properties can be evaluated with AFM shortly after platelet-rich plasma (PRP) injection. We hypothesized that the modulus determined by AFM indentation experiments could be utilized as a progressive disease marker during the treatment of osteoarthritis. The rabbits were equally divided into three groups of six: control (group 1); injections of saline (0.5 mL) and 10% surgical talc (Talcum Pharmaceutical®, Minsk, Belarus) were delivered into the right knee under the patella (group 2 and 3); and PRP was injected into the right knee (group 3). In group 2, the arithmetic average of absolute values (Ra) change was a 25% increase; the maximum peak height (Rp) increased by over 102%, while the mean spacing between local peaks (S) increased by 28% (p < 0.05). In group 3, Ra increased by 14% and Rp increased by 32%, while S decreased by 75% (p < 0.05). The Young’s modulus of the surface layers decreased by 18% as a result of induced model of osteoarthritis (IMO) (p < 0.05), and it increased by 9% (p < 0.05) as a result of PRP therapy, which means that the mechanical properties of cartilage were partially recovered. This research demonstrates that Young’s modulus utilized on a nanometer scale has potential to be a progressive disease marker during the treatment of osteoarthritis.

Abstract.Introduction: Osteoarthritis is a chronic, progressive disease. The aim of this paper is presenting the AFM investigation of cartilage in relation to the assessment of degenerative changes in the surface of hyaline cartilage. It can be useful in choosing the most effective methods of therapy. Methods: Samples were taken from the cartilage surface of the femoral head after its removal during total hip arthroplasty. Images of the surface of the sample were obtained using an optical microscope equipped with a digital video camera, in the reflected light and by atomic force microscopy. Results: The longitudinal orientation of the collagen fibers and sub-fibers beams on the surface, up to a diameter of 50 nm are identified in non-destroyed area sites. Conclusions: Images of the destroyed areas displaying separately passing collagen fibers, strongly exposed to the surface: the size measured and found substructure.