During plastic deformation of metals and alloys, dislocations arrange in ordered patterns. How and when these self-organization processes take place have remained elusive, because in situ observations have not been feasible. We present an x-ray diffraction method that provided data on the dynamics of individual, deeply embedded dislocation structures. During tensile deformation of pure copper, dislocation-free regions were identified. They showed an unexpected intermittent dynamics, for example, appearing and disappearing with proceeding deformation and even displaying transient splitting behavior. Insight into these processes is relevant for an understanding of the strength and work-hardening of deformed materials.

Understanding the origin of the dramatic temperature and density dependence of the relaxation time of glass-forming liquids is a fundamental challenge in glass science. The recently established 'density-scaling' relation quantifies the relative importance of temperature and density for the relaxation time in terms of a material-dependent exponent. We show that this exponent for approximate single-parameter liquids can be calculated from thermoviscoelastic linear-response data at a single state point, for instance an ambient-pressure state point. This prediction is confirmed for the van der Waals liquid tetramethyl-tetraphenyl-trisiloxane. Consistent with this, a compilation of literature data for the Prigogine-Defay ratio shows that van der Waals liquids and polymers are approximate single-parameter systems, whereas associated and network-forming liquids are not.

Liquids composed of small-molecule monohydroxy alcohols are demonstrated to display rheological behavior typical for oligomeric chains. This observation was made possible by rheological experiments in which more than seven decades in frequency and more than five decades on the mechanical modulus scale are covered. The singly hydrogen-bonded monohydroxy alcohols were chosen because they display significant, but surprisingly poorly understood effects of intermolecular association. Based on the present shear study, one can apply theoretical concepts of polymer science to understand the anomalous physical behavior of a wide range of hydrogen-bonded liquids.

How would you… …describe the overall significance of this paper? This paper describes emerging characterization experiments referred to as High Energy Diffraction Microscopy conducted at the Advanced Photon Source (APS) beam line 1-ID-C. "Near field" diffraction is used to quantify three-dimensional orientation maps of polycrystalline samples non-destructively, with incredible detail grain boundary geometry. "Far field" experiments are used to quantify lattice strains and single crystal stress states within large aggregates subjected to in situ loading. …describe this work to a materials science and engineering professional with no experience in your technical specialty? Materials derive their mechanical properties from their internal structure. As engineering moves downscale, it becomes more important to quantify the structure and mechanical response of engineering materials on small size scales. High energy x-ray diffraction methods are rapidly evolving into important microscale characterization tools that can be used together with high fidelity mechanical models. …describe this work to a layperson? Micro-and nano-engineering methods hold enormous promise for a broad spectrum of products and processes. The determination of material attributes and mechanical properties on small size scales is one of the main barriers to moving down scale. Instead of making tiny specimens, we examine deforming test samples using high energy x-rays, created using a special national laboratory facility. This work will enable us to precisely reconstruct the internal structure of engineering alloys and will provide important mechanical data on the micron scale. The status of the High Energy Diffraction Microscopy (HEDM) program at the 1-ID beam line of the Advanced Photon Source is reported. HEDM applies high energy synchrotron radiation for the grain and sub-grain scale structural and mechanical characterization of polycrystalline bulk materials in situ during thermomechanical loading. Case studies demonstrate the mapping of grain boundary topology, the evaluation of stress tensors of individual grains during tensile deformation and comparison to a finite element modeling simulation, and the characterization of evolving dislocation structure. Complementary information is obtained by post mortem electron microscopy on the same sample volume previously investigated by HEDM.

This paper presents dielectric relaxation data for organic glass-forming liquids compiled from different groups and supplemented by new measurements. The main quantity of interest is the "minimum slope" of the alpha dielectric loss plotted as a function of frequency in a log-log plot, i.e., the numerically largest slope above the loss peak frequency. The data consisting of 347 spectra for 53 liquids show prevalence of minimum slopes close to -1/2, corresponding to approximate square root(t) dependence of the dielectric relaxation function at short times. The paper studies possible correlations between minimum slopes and (1) temperature (quantified via the loss peak frequency); (2) how well an inverse power-law fits data above the loss peak; (3) degree of time-temperature superposition; (4) loss peak half width; (5) deviation from non-Arrhenius behavior; (6) loss strength. For the first three points we find correlations that show a special status of liquids with minimum slopes close to -1/2. For the last three points only fairly insignificant correlations are found, with the exception of large-loss liquids that have minimum slopes that are numerically significantly larger than 1/2. We conclude that--excluding large-loss liquids--approximate square root(t) relaxation appears to be a generic property of the alpha relaxation of organic glass formers.

Shear-mechanical and dielectric measurements on the two monohydroxy (monoalcohol) molecular glass formers 2-ethyl-1-hexanol and 2-butanol close to the glass-transition temperature are presented. The shear-mechanical data are obtained using the piezoelectric shear-modulus gauge method covering frequencies from 1 mHz to 10 kHz. The shear-mechanical relaxation spectra show two processes, which follow the typical scenario of a structural (alpha) relaxation and an additional (Johari-Goldstein) beta relaxation. The dielectric relaxation spectra are dominated by a Debye-type peak with an additional non-Debye peak visible. This Debye-type relaxation is a common feature peculiar to monoalcohols. The time scale of the non-Debye dielectric relaxation process is shown to correspond to the mechanical structural (alpha) relaxation. Glass-transition temperatures and fragilities are reported based on the mechanical alpha relaxation and the dielectric Debye-type process, showing that the two glass-transition temperatures differ by approximately 10 K and that the fragility based on the Debye-type process is a factor of 2 smaller than the structural fragility. If a mechanical signature of the Debye-type relaxation exists in these liquids, its relaxation strength is at most 1% and 3% of the full relaxation strength of 2-butanol and 2-ethyl-1-hexanol, respectively. These findings support the notion that it is the non-Debye dielectric relaxation process that corresponds to the structural alpha relaxation in the liquid.

We report dynamical shear-modulus measurements for five glass-forming liquids (pentaphenyltrimethyltrisiloxane, diethyl phthalate, dibutyl phthalate, 1,2-propanediol, and m-touluidine). The shear-mechanical spectra are obtained by the piezoelectric shear-modulus gauge (PSG) method. This technique allows one to measure the shear modulus (10(5)-10(10) Pa) of the liquid within a frequency range from 1 mHz to 10 kHz. We analyze the frequency-dependent response functions to investigate whether time-temperature superposition (TTS) is obeyed. We also study the shear-modulus loss-peak position and its high-frequency part. It has been suggested that when TTS applies, the high-frequency side of the imaginary part of the dielectric response decreases like a power law of the frequency with an exponent -1/2. This conjecture is analyzed on the basis of the shear mechanical data. We find that TTS is obeyed for pentaphenyltrimethyltrisiloxane and in 1,2-propanediol while in the remaining liquids evidence of a mechanical beta process is found. Although the high-frequency power law behavior w(-alpha) of the shear loss may approach a limiting value of alpha = 0.5 when lowering the temperature, we find that the exponent lies systematically above this value (around 0.4). For the two liquids without beta relaxation (pentaphenyltrimethyltrisiloxane and 1,2-propanediol) we also test the shoving model prediction, according to which the relaxation time activation energy is proportional to the instantaneous shear modulus. We find that the data are well described by this model.

We present shear mechanical and dielectric measurements taken on seven liquids: triphenylethylene, tetramethyltetra-phenyltrisiloxane (Dow Corning 704 diffusion pump fluid), polyphenyl ether (Santovac 5 vacuum pump fluid), perhydrosqualene, polybutadiene, decahydroisoquinoline (DHIQ), and tripropylene glycol. The shear mechanical and dielectric measurements are for each liquid performed under identical thermal conditions close to the glass transition temperature. The liquids span four orders of magnitude in dielectric relaxation strength and include liquids with and without Johari-Goldstein beta relaxation. The shear mechanical data are obtained by the piezoelectric shear modulus gauge method giving a large frequency span (10(-3)-10(4.5) Hz). This allows us to resolve the shear mechanical Johari-Goldstein beta peak in the equilibrium DHIQ liquid. We moreover report a signature (a pronounced rise in the shear mechanical loss at frequencies above the alpha relaxation) of a Johari-Goldstein beta relaxation in the shear mechanical spectra for all the liquids which show a beta relaxation in the dielectric spectrum. It is found that both the alpha and beta loss peaks are shifted to higher frequencies in the shear mechanical spectrum compared to the dielectric spectrum. It is in both the shear and dielectric responses found that liquids obeying time-temperature superposition also have a high-frequency power law with exponent close to -12. It is moreover seen that the less temperature dependent the spectral shape is, the closer it is to the universal -12 power-law behavior. The deviation from this universal power-law behavior and the temperature dependencies of the spectral shape are rationalized as coming from interactions between the alpha and beta relaxations.